How do I access the clean water tank to use the self-cleaning feature of the MOVA K20?

Question

Accepted Answer

The clean water tank of the MOVA K20 is easily accessible and removable. Here’s how to access it:

Removing the clean water tank:

Locate the clean water tank release button on the side of the device (it is labeled “Clean Water Tank Release Button”)
Press firmly on this button to unlock the tank
Gently pull the tank out of the device towards you

Filling and reinstalling:

Once the tank is removed, open its lid by lifting it
Fill the clean water tank to the limit (capacity: 600 mL)
Close the tank lid
Reinstall the tank by sliding it back into its slot until you hear a distinct click

Activating self-cleaning:

Once the tank is filled, self-cleaning is easily activated. Place the device on its charging base, ensure that the clean water tank contains enough water, and then press the self-cleaning button located at the top of the handle. The function only works if the device is connected to the charging base and the battery indicator shows green.

Important: The brush roll takes up to 30 seconds to moisten on the first water launch, which is normal. If the circuit has not been used for a long time, several consecutive self-cleaning cycles may be necessary to completely purge the pipes and remove dust residues.

User manual MOVA Vacuum Cleaner : user manuals and guides in PDF

Models MOVA Vacuum Cleaner most viewed

Other categories MOVA

Recent questions about Vacuum Cleaner MOVA