S-26037 - Heated blanket/cushion Uline - Free user manual and instructions

USER MANUAL S-26037 Uline

Technical line drawing of a mechanical component with shaded sections and a handle (no text or symbols)

STOP

Read and save these instructions.

SAFETY

Heated seat cushion is designed for comfort and gentle warmth during use. During extended operation, the cushion can gradually reach elevated surface temperatures. Use responsibly to avoid discomfort or potential skin irritation.

DANGER! BURN HAZARD

• This heated seat cushion can reach high temperatures during extended use. Long, direct contact may cause burns, even if the heat is not immediately felt.
• Use only when awake and alert. Do not use the cushion while sleeping.
• Avoid long, uninterrupted sitting on the heated surface. The cushion warms gradually and may reach high temperatures after extended use.
  • Always use with clothing between your skin and the cushion. Do not use directly against bare skin.
• Monitor comfort levels. Discontinue use if the cushion feels excessively warm or if skin discomfort occurs.
• Not recommended for individuals with reduced heat sensitivity, including children, older adults, pets, or persons with diabetes, neuropathy or circulation issues.
• Do not use if the user cannot sense or communicate discomfort.
• Never cover the cushion with blankets, pillows or other insulating materials, as this may trap heat.

GENERAL USE GUIDANCE

• If using for extended periods, shift position occasionally to prevent prolonged contact with a single skin area.
• Keep the cushion clean and free of items that could restrict airflow or damage the heating element.
• Cycling the pad off and on every 45 minutes or less (45 minutes on, 15 minutes off) during extended use is recommended.
• To prevent leakage, overheating or explosion of the power bank, note the following precautions. Failure to read and follow the following items could pose health/safety issues and/or compromise the lifespan of the product.
• Do not put the product into water or get it wet.
• Do not use or store the product near a heat source such as fire or a heater. Do not charge the product near a fire or an extreme hot environment.
• Use only the original charger included with the product.
• Do not short-circuit the positive and negative poles of the power bank with wires or other metal objects. Do not transport or store the power bank with necklaces, hair clips or other metal objects.
• Do not strike, throw or subject the product to mechanical shock.

SAFETY CONTINUED

• Do not pierce the product chassis with nails or other sharp objects. Do not hit with a hammer or step on it with your foot.
• Do not place the product in a microwave or pressure vessel.
• Do not use if the power bank emits odor.
• If the power bank leaks or emits odor, do not use it near an open flame.
• Leaking electrolyte may cause fire or explosion.

• If the device is not going to be used for a long period of time, remove the power bank and place it in a cool, dry place.

• If the contact terminals on the product become dirty, wipe them off with a dry cloth before use. Failure to do so may result in poor contact, resulting in energy loss or failure to charge.

• Heat pad cannot be needled, cut or punctured.
  • Heat pad cannot be washed.
• Discontinue use of the heat pad if strong acid or alkali corrosion appears.

INSTRUCTIONS

STOP

Before use, check that all parts are included.

USAGE

1. Ensure power bank is fully charged.

NOTE: Press the power button on the power bank to display the battery level. When battery level is low, charge promptly.

1. Connect the cable of the heated cushion to USB Type-A of the power bank. (See Figure 1)
2. When power bank is plugged into the seat cushion, power button functions as follows (See Figure 2):

a. Single click turns on the battery.

b. Double click turns off the battery.

NOTE: Cushion has one heat setting.

Figure 1 N Type-C F Type-A Type-A H Cable

Figure 2 Power Button

INSTRUCTIONS CONTINUED

1. Store the power bank in the side pocket while cushion is in use. (See Figure 3)

Figure 3 Side Pocket

STORAGE

1. Double click power button to turn power bank off. (See Figure 4)

Figure 4 Power Button

1. Unplug the cable from the power bank. (See Figure 5)

2. Charge power bank for next use.

Figure 5

Technical line drawing of a mechanical component with shaded internal area and handle (no text or symbols)

Technical line drawing of a mechanical component with shaded sections and a handle (no text or symbols)

Figure 1 N Typ=C M 7p=ATyp=A Câble

Figure 2 Bouton d'alimentation

INSTRUCTIONS SUITE