MG11U - Lawn mower Eldom - Free user manual and instructions

USER MANUAL MG11U Eldom

Black and white photo of a Eldom electric toothbrush with spiked teeth and a circular button labeled 'eldom' (no additional text or symbols visible)

/EN/ The disposal of used electrical and electronic equipment (applies to European Union countries and other European countries with separate waste-collection systems).

This symbol on the product or its packaging indicates that it should not be classified as household waste. It should be handed over to an appropriate company dealing with the collection and recycling of electrical and electronic equipment. The correct disposal of the product will prevent potential negative consequences for the environment and human health resulting from hazardous substances present in the product. Electrical devices must be handed over to restrict their re-use and further treatment. If the device contains batte ries, remove them, and hand them over to a storage point separately. DO NOT THROW EQUIPMENT INTO THE MUNICIPAL WASTE BIN. Material recycling helps to preserve natural resources. For detailed information on how to recycle this product, please contact your local authority, the recycling company, or the shop where you bought it.

Read thoroughly this manual before the first use of the unit. Failure to comply with the following safety and safety instructions may result in electric shock, fire and/or serious injury.

Keep all warnings and security notices so you can use them in the future.

1. Before using the appliance for the first time, please read carefully these Instructions for Use.
2. The appliance should be connected to sockets compliant with current parameters given on the casing.
3. The appliance should always be disconnected by pulling the plug, not the power cord.
4. The device can be used by children aged 8 and older and by persons with limited physical, sensory or mental capabilities, or persons without sufficient experience and knowledge only under supervision or if previously instructed on the safe use of the appliance and the possible risks. Children shall not play with the appliance. Cleaning and maintenance that are the responsibility of the user shall not be carried out by children without supervision. Protect the appliance and the power cord against children under 8 years old.
5. Do not place the appliance in the vicinity of heat sources.
6. The appliance is intended for domestic use only.
7. Do not immerse the cord or the appliance in water.
8. The appliance must always be cleaned after use. The appliance must always be turned off before cleaning and maintenance as well as in case of malfunction and after operation.
9. Do not use with a broken or otherwise damaged hairdressing head as it may lead to injury.
10. Do not use the appliance for clipping animal and artificial hair.
11. Do not use the appliance for clipping wet hair. It is designed for clipping dry hair only.
12. Do not use in the open air.

13. Use only with the originally included accessories and feeder.

14. Never use the appliance when it is wet, with wet hands or in the vicinity of showers, water in a bath, washbasin and other containers.

15. When used in the bathroom, the appliance must be disconnected after use because proximity of water is dangerous even if the appliance is turned off.
16. The appliance must not be immersed in or sprinkled with water.
17. When in operation, do not leave the appliance unattended. The power cord and the whole appliance should be regularly checked for damage. Do not turn the appliance on, if any damage has been found.
18. In the event the power cord is damaged, it must be replaced in the Manufacturer's Service Centre to prevent danger. A list of Service Centres can be found in the attachment and on the website www.eldom.eu.
19. The appliance can be repaired only in an authorised Service Centre. Any modernization or application of spare parts or elements other than the original ones is forbidden and dangerous for the user.
20. The company Eldom Sp. z o.o. shall not be liable for any damage caused by inappropriate use of the appliance.

CAUTION:

Do not use the appliance near bathtubs, showers, swimming pools and similar water reservoirs.

WARNING: Plastic bag can be dangerous, to avoid danger of suffocation keep this bag away from babies and children.

ENVIRONMENTAL PROTECTION

– The appliance is made of materials which can be recycled.
– It should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

WARRANTY

• This appliance is designed for domestic use only.
• It cannot be used for professional purposes or for other than the intended use.
• Improper use will nullify the guarantee.

EN

INSTRUCTION MANUAL

HAIR CLIPPER MG11U

GENERAL DESCRIPTION

1. Cutting head
2. Hair length control ring
3. Switch-key
4. Control lamp
5. Telescope styling attachment
6. Slider
7. Maintenance oil
8. Cleaning brush
9. USB power cable
10. Comb guides

TECHNICAL DATA

• Power: 3W
  • Supply voltage: DC 5V, 1A
  • Battery: 2x 600 mA, Ni-CD
• Charging time: 8 hours

INTENDED USE

The MG11U hair clipper is designed to cut hair. It has steel blades, guaranteeing high durability of the device, the rotating ring allows to cut hair from 3-15 mm.

HOW TO USE THE APPLIANCE

• Before use, check the appliance is complete and undamaged.
• Remove all transport protection.
• The clipper can be used as a mains or battery powered device.
• If mains-powered, the unit is ready to use immediately.

Electric power supply

• Turn off the device by moving the switch (3) to the "OFF" position.
• Connect one end of the cable (9) to the clipper, and the other to the power supply (not included), with the parameters specified above, and then to the mains.
• Connection to the mains is indicated by the indicator light (4).
• To start work, set the switch (3) to the "ON" position.
• When finished working, turn off the device by sliding the switch (3) down and disconnect the cable (9) from the mains and from the device socket.

Charging and operation with the batt

• The charging time of the battery is about 8 hours.
• Charging is indicated by the red indicator light (4).
• Turn off the device - the switch (3) in the "OFF" position.
• Connect one end of the cable (9) to the clippers, and the other to the power supply (not included), with the parameters specified above, and then to the mains.
• After the battery has been charged, disconnect the feeder, the appliance is ready for operation with the battery. To start operation, turn the switch-key (3) to position "ON".
• Charging the battery for over 12 hours reduces its life span.
• If the appliance is not used for a longer period of time, it is recommended to charge the battery at least once every half a year.

NOTICE: The control lamp (4) does not go out after the battery has been charged.

Hair clipping

• Make sure the appliance is clean, correctly assembled and oiled.
• Before clipping the hair, comb it to make it more natural.

CAUTION. The appliance must not be used to cut wet hair.

• The slider (6) should be moved to the right - the plastic cap at the head is retracted.
• Put on the cap (5) by sliding it into the guides (10) photo 1 - the knob (2) should be turned to the maximum left. The knob (2) allows you to set 24 lengths of hair clipping.
• Working with the attachment allows you to cut hair in the range from 3-15 mm. A shorter haircut length will be obtained by removing the cap (5). To do this, turn the knob (2) as far to the left as possible and slide out the cap (5) photo 1.
• It is recommended to start trimming from the largest length.
• It is necessary to cut small areas, slowly moving the razor through the hair.
• Start trimming from the nape of the neck upwards or from the forehead and temples upwards.
• Hold the razor gently under the hair so that the teeth of the attachment point upward and lie flat on the head
• For thick hair, you can move the slider (9) to the left - a plastic cap will slide out, blocking some of the hair from sliding under the head (1) and making it easier to work with. After thinning the hair, move the switch (9) to the right and continue cutting.
• The clipper is started with the switch (3), position "on". The operation of the clipper is additionally indicated by the indicator lamp (4).

CLEANING AND MAINTENANCE

• Before cleaning, unplug the appliance and turn it off.
• After using the appliance, the chamber of cutting knives should always be cleaned. For this purpose, open the cutting head (1) by pressing the clipper blades with your thumb in the direction shown in phot. 2. Protect the blades against falling down.

NOTICE. Do not immerse the appliance in water.

• Clean the blades with the brush included in the set.
• Cutting blades must be maintained on a regular basis. Put one to two drops of oil between the blades and turn the appliance on for a few seconds.
• Do not use hair oils, fat, oils mixed with refined kerosene or other solvents.
• Do not use any cleansing agents which are strong or may damage the surface.
• Wipe the casing with a moist or dry cloth.

WARRANTY

• This appliance is designed for domestic use only.
• It cannot be used for professional purposes or for other than the intended use.
• Improper use will nullify the guarantee.