MBL-34M - Blender MPM - Free user manual and instructions

USER MANUAL MBL-34M MPM

EN We wish you satisfaction from using the product and invite you to check a wide range of other MPM appliances.

Two kitchen utensils: a hand mixer with 1000W label and a hand mixer with 1500W label, shown without any text or symbols on the devices themselves.

cz NAVOD K OBSLUZE 3
DE BEDENUNGSANLEITUNG 7
EE KASUTUSJUHEND 12
EL EXEPIATO XPH21E 16
EN USER MANUAL 21
ES MANUAL DE INSTRUCCIONES 25
FR MANUEL DE L'UTILISATEUR 30
HU HASZNALATI UTASÍTÁS 35
IT MANUALE D'USO 39
LT VARTOTOJO VADOVAS 44
LV LIETOTAJA ROKASGRAMATA 48
NL GEBRIJIKERSHANDLEIDING 52
PL NSTRUKCJA OBSLUGI 57
RO MANUAL DE UTILIZARE 62
RU АНСТРУКЦИПО ОБСЛУЖИВАНИО 67
SK POUZIVATELSKA PRIRUCKA 72
UA ПОСІБНИК КОРИСТУВАЧА 77

MPM and S.A.

Labeled diagram of a food prep and cleaning device showing components like MPM, blender, whisk, and beaker with numbered parts.

Stainless steel body

9-stage speed control + TURBO mode

Hanging pin

Stainless steel mixing attachment fit for use in high temperatures

BEZPEČNOSTNÍ POKYNY PŘI POUŽÍVÁNÍ

-Read the instructions carefully before use.
-Do not handle the device with wet hands.
-Take special care when children are near the device.
- Do not use the device for purposes other than those for which it was intended.
- Do not immerse the device, cable or charger in water or other liquids.
- Do not let the power cord hang over the edge of the table/counter.
-Do not leave the device unattended during operation.
- Never use a damaged device, including one with a damaged cord or plug, in which case have it repaired at an authorised service centre.
-Do not use the device outdoors.
- Do not hang the power cable on sharp edges or allow it to come into contact with hot surfaces.
-Do not place the device on a hot surface.
- Do not place the device near other electric cookers, burners, ovens, etc.
-The device should be put on a dry, flat and stable surface.
-The device is intended for domestic use only.
-Always ensure that all parts of the device are correctly fitted before starting work.
-Use of accessories not recommended by the manufacturer may cause damage to the device, fire or personal injury.
-The device may be used by people with reduced physical, sensory or mental abilities, as well as those without prior knowledge or experience in using such types of device, provided that they either are supervised or have been instructed and informed about potential threats which they fully understood.
-The device must be kept away from children. Keep the device and cable out of the reach of children.
-Children are forbidden to perform cleaning and maintenance activities.
-Children are not allowed to play with the device.
- Do not pull the plug out of the power socket by pulling the cord.

- The equipment is not designed to operate using external timers or a separate remote control.

-Do not connect the plug to the power socket with wet hands.

- For the safety of children, please do not leave freely accessible parts of the packaging (plastic bags, cardboard boxes, polystyrene, etc.).

- WARNING! Do not allow children to play with the film. Danger of suffocation!

-Check that the power parameters on the device's rating plate correspond to the parameters of your power supply network.

-CAUTION! Before starting cleaning and maintenance works, disconnect the device from the power supply network and wait until it cools down completely after work. Do not submerge the device into water!

- CAUTION! Do not use sharp objects, abrasive polishes, solvents or other strong chemicals for cleaning since their use may cause damages to the device.

- Before the first use, remove all bags, stickers, tapes and transport locks from the device and its accessories.

- Disconnect the device from the power supply each time when the device is left unattended and before any assembling, disassembling, or cleaning works.

- Wait until the motor stops completely before disassembling the device.

- Pay special attention when handling the blades, especially when removing and washing them.

- Do not exceed the maximum capacity indicated on the container.

-Allow hot ingredients to cool down before processing them.

- Clean the device, in particular parts being in direct contact with food, before first use, immediately after finishing work and if the device has not been used for a long time. The procedure is described in details in the “CLEANING AND MAINTENANCE” section.

- Keep your hands away from moving parts when the device is in operation!

- CAUTION! Avoid physical contact with the cutting blades while emptying and cleaning the device as they are very sharp and might cause serious injuries.

- CAUTION! Do not exceed the permissible operating time stated on the nameplate. Wait for the device to cool down before turning it on again.

DEVICE DESCRIPTION

1. Blender housing
2. Control buttons

A. ON/OFF
B. Turbo
C. Speed control knob

1. Hanging bracket
2. Mixing attachment

3. Blending container (700 ml)

4. Whipping attachment for egg whites, light creams and sauces

5. Shredding kit

D. Container lid
E. Chopping knife with a stainless steel blade
F. Container for grinding (500 ml)

ATTENTION! The whipping attachment (6), the shredding set (7) and the mixing container (5) are included in the MBL-34M version only.

BLENDER ASSEMBLY AND USE

CAUTION! Do not allow the blender housing (1) to get wet. Prior to the accessories mounting/demounting procedure, make sure the device is not connected to the power supply.

CAUTION! The temperature of food prepared with the blender must not exceed 60^ C.

The MBL-33M (34M) version of the blender is a compact device facilitating everyday meal preparation. The device is especially recommended for grinding raw and cooked vegetables, soft fruits (without seeds), preparing sauces, creams, soups, mixing liquids, etc. Prior to grinding large ingredients with a blender cut them into smaller pieces (1-2 cm).

1. Attach one of the selected accessories to the blender housing (1): a mixing attachment (4), a whipping attachment (6) or a chopping set (7). To lock the accessories, turn the housing against the attachment clockwise until it locks. Do the opposite for disassembling the mixing attachment. Pay close attention in order to avoid self injures or parts damages when disconnecting accessories.

Shredding kit (7) - preparation for work.

Place the container (F) on a dry and stable surface. When holding the plastic shaft, place the knife (E) into the container by putting it on the plastic shaft. Place food items (vegetables, fruits, nuts, meat, onions, hard cheese, hard-boiled eggs, garlic, herbs) inside the container. Put on the top cover (D) and turn it slightly clockwise to lock it.

1. After ensuring proper assemble of all components, connect the plug of the device to the power source.

2. To start blender:

3. Set the speed using the control knob (C) (speed range: 1-9), then press and hold the ON/OFF button (A).

4. Press and hold the Turbo button (B) for short-term operation of the device at maximum speed.

5. After the work is finished, turn the control knob to the lowest speed and disconnect the device from the power source.

6. The maximum time of continuous operation of the device is 30 sec. After this time, turn off the device and wait until it cools down.

CLEANING AND MAINTENANCE

1. Before cleaning/maintenance disconnect the device from the power supply.
2. Clean the blender housing (1) with a damp cloth. Avoid direct contact of the blender housing with liquids; neither submerge nor wash under running water, etc.
3. Wash the other accessories in warm water with detergent, rinse and dry or put in the dish-washer.
4. Periodically check parts before reassembling. Do not use the blender if the knives are jammed or rotate with difficulty.

CAUTION! Do not use sharp objects, abrasive polishes, solvents or other strong chemicals for cleaning since their use may cause damages to the device.

TECHNICAL DATA

Model MBL- 33M / MBL-34M
Power supply 220-240V	~ 50/60Hz
Power 1200W - 1500W
Availability of the shutdown and standby mode available
Power consumption in standby mode -
Power consumption in the shutdown mode 0,19W
Power consumption in network standby mode	-
Automatically goes into standby mode after -
Automatically goes into the shutdown mode after -
Network standby mode, if the device has a connection function with the appli cation	-
Length of mains cable 1,04 m

CAUTION! MPM agd S.A. reserves the right to technical changes.

Proper disposal of the product (waste electrical and electronic equipment)

Marking on the product indicates that after the service–life of the product expires, it should not be disposed with other type of municipal waste. Used equipment may have a negative impact on the environment and health of people due to potentially containing hazardous substances, mixtures and components. Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may cause a release of substances that are hazardous to the environment and health.

Used equipment should be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the electric waste collection points, the user should contact the municipal point of electric waste collection or used equipment processing department.

BESCHRIJVING VAN HET APPARAAT

1. Staafmixerbehuizing
2. Bedieningsknoppen