HWS34GGH1 - Wine cellar HAIER - Free user manual and instructions

USER MANUAL HWS34GGH1 HAIER

EN WARNING: Risk of fire/flammable material. The symbol indicates there is a risk of fire since

flammable materials are used. Take care to avoid

àÊÛ×Ò×Ð !"EN Accessories Check the accessories and literature in accordance with this list: Name User Manual HWS34GGH1 HWS58GGH1

Energy Label Wire barrier

Notice Shelf Wire barrier Adjustable feet DisplayHWS58GGH1 Door LED lamp SwitchPicture of appliance

ventilationdistance of 50 mm in all directions must be observed(Fig.5). equired space to open the door (Fig. 1,2,3,4);For safety and energy reasons,the required

1. Unpacking ▶ Take the appliance out of the packaging.

▶ Remove all packaging materials including the foam base and all adhesive tape hold- ing the accessories.2. Environmental conditionsthe temperature inside the appliance and its energy consumption. Do not install the appli-ance near other heat-emitting appliances (ovens, refrigerators) without isolation.

Width BHeight COverall Height D

Installation surface.

1. Tilt the appliance slightly backwards (Fig. 7).

2. Set the adjustable front feet to the desired level

3. The stability can be checked by alternately

bumping on the diagonals. The slight swaying should be the same in both directions. Other- wise the frame can warp; possible leaking door seals are the result. A low tendency to the rear facilitates the closing of the door. max 45°

▶ Keep ventilation openings in the appliance or in the in-built structure clear of ob- struction. This refrigerating appliance is not intended to be used as a built-in applianceThe appliance closes more easily if the levelling feet on the front are used: Rotate the adjustable feet (Fig. 8) to turn them up or down: ▶ Turning the feet clockwise raises the appliance. ▶ Turning the feet counterclockwise lower the appli- ance. To avoid risks a damaged power cord must be replaced by the customer service (see warranty card). ▶ The appliance is heavy. You need two persons to carry out the door reversibility.

▶ Do not tilt the appliance more than 45 ° to prevent damage of the cooling system. ▶ power supply, socket and fusing are appropriate to the rating plate. ▶ the power socket is earthed and no multi-plug or extension.

Connect the plug to a properly installed household socket. The maintenance-free lubrication oil is located capsule of the compressor. This oil can get the closed pipe system during transport if the ance is tilted. Before connecting the applianc power supply, wait 0.5 hours (Fig. 9) so that the in the through appli- e to the oil runs back into the capsule. Before connecting the appliance to the power supply you should check, whether the door swing must changed from right (as delivered) to left, if this is required by the installation location and the usability

8Assembly steps Provide necessary tool. Unplug the appliance.

Install the removed shaft sleeve through the wiring harness terminal to the other side of the door body, the wiring harness terminal on the other side is hid- den inside the decorative cover, extend the wiring harness into the body, and buckle the decorative cover.

6. 5HPRYHWKHƪ[LQJVFUHZVVKDIWVOHHYHVDQGGRRU

stop at the bottom of the door body and install them on the other side of the door body.

7. Remove the lower hinge screw at the bottom of

WKHER[ƪ[WKHORZHUKLQJHVFUHZWRWKHRWKHUVLGH of the box.

8. Install the door body onto the lower hinge of the

body,the door harness is connected to the box harness terminal and placed inside the box, with screws securing the upper hinge.

Install the hinge cover and decorative cover, and complete the left and right door replacement.

3. Remove the left and right hinge cover,disconnect

the wiring harness connection terminal between the door body and the box body,remove the three screws from the upper hinge and remove the door body. The hinge side shaft sleeve passes through the wiring harness terminal and is taken out from the door body,remove the decorative cover on the door opening side and pull out the hidden wiring harness from the door body.

The buttons on the control panel are touch buttons, which respond when lightly touched ZLWKWKHƪQJHU

▶ Remove all packaging materials. This includes the foam base and all adhesive tape holding the wine cellar accessories inside and outside. Keep them out of children’s reach and dispose them in an environmentally friendly manner. ▶ Clean the inside and outside of the appliance with water and a mild detergent before putting any wine in it. ▶ After the appliance has been levelled and cleaned, wait for at least 2 hours before connecting it to the power supply. If your wine cellar has been tilted for any reason, wait 24 hours before plugging it in. See section INSTALLATION. ▶ Once you have plugged the unit into an electrical outlet, let the unit run for at least 30 minutes to acclimatize itself before making any adjustments. ▶ The temperature is automatically set to 12 °C. If desired, you can change the tem- perature manually. Please see TEMPERATURE.

3. Description for control panel

4. Automatically locking function

A Light button B Temperature adjust button:down C Display D Temperature adjust button:up E Lock button In the lock screen state, long press the lock button for 3S, the display screen displays 3, 2 and 1, the display screen is unlocked;If there is no operation, the screen will be locked automatically after 30s,In the lock screen state, all the lock button icons are on, and the buttons on the display screen cannot be operated (except the lighting button); A B C D E5.Temperature setting

6WRSSUHVVLQJWKHEXWWRQIRUVHFRQGWKHWHPSHUWXUHLVFRPƪUPHG It lights up automatically when any button is touched or the door is opened(for HWS58GGH1).Winter mode

12. Door opening alarm (for HWS58GGH1)

Press the button for 3 seconds ,the Wi-Fi button starts tRƫDVKTXLFNO\DQGDXto- Press the “ ” button for 3 seconds ,switch between Fahrenheit and Celsius. matically ente appliance.When the temperature in the appliance reaches the set temperature,the The temperature inside the appliance deviates from the set temperature by 1~2 ℃, which is normal. rs the cRQƪJXration mode . Technology Wi-Fi IEE 802.11 b/g/n 2401-2483

Standard Frequency Band(s) [MHz] Maximum power [mW]Band(s) [MHz]

Use PRODUCT INFORMATION How to activate Wi-Fi module: Press the light button for 3 seconds to activate the Wi-Fi The Wi-Fi module is switched on the Wi-Fi icon starts to blink ,IWKHZLQHFHOODULVHQUROOHGEXWWKH:L)LLVRƩWKHLFRQZLll blink If the wine cellar is enrolled and connected the Wi-Fi icon is always on To reset the Wi-Fi press the light for 3 seconds

IN APP PAIRING PROCEDURE

Step 1 Download the hOn app on the stores Step 2 Log in or sign up Step 3 Add a new appliance selecting the wine cellar from the list

Step 4 Scan the QR or insert manually the serial number Step 5 Press the light button on the product for 3s to activate the Wi-Fi Step 6 The wi-Fi icon will blink, the pairing process is in progress You will have 5 minutes to complete the pairing process When the process is completed the Wi-Fi icon will stop blinking and it will remain always on NOTE1. ▶ Make sure the appliance is properly ventilated (see INSTALLATION). ▶ Do not install the appliance in direct sunlight or in the near of heat sources (e.g. stoves, heaters). ▶ Avoid unnecessarily low temperature in the appliance. The energy consumption in- creases the lower the temperature in the appliance is set.

positioned in the appliance on factory-fresh condition, and fo

eep door seals clean so that the door always closes correctly.

▶ 7RLQFUHDVHWKHHQHUJ\HƬFLHQF\WKHOLJKWVVKRXOGEHWXUQHGRƩZKHQWKHZLQHFHOODU

is not being viewed.

two (for HWS58GGH1) (for HWS58GGH1)

Unlock the door by turning the key clockwise; Lock the door by turning the key counterclockwise;

EquipmentThe defrosting of the wine cellar is done automatically; no manual operation is needed.

The lamp uses LED as its light source,featuring low energy consumption and long service life. If there is any abnormality,please contact the customer service.See CUSTOMER SERVICE. 2.Replacing the LED lamp Unplug the power cord. Clean the appliance and door gaskets as described above. Keep the door open to prevent the creation of bad odours inside.

3. Non-use for a longer period

1. Remove all bottles and unplug the appliance.

2. Secure shelves and other moveable parts in the wine cellar with adhesive tape.

3. Do not tilt the wine cellar more than 45° to avoid damaging the refrigerating system.

4. Moving the appliance

Parameters of LED lamp: WARNING! Do not replace the LED lamp yourself. It must only be replaced by either the manufac- turer or the authorised service agent. Voltage12V Max power: 2W(for HWS34GGH1) Max power: 5W(for HWS58GGH1)

Care and cleaningof a problem please check all shown possibilities and follow below instructions before y contact an after sales service. See CUSTOMER SERVICE. Error Code Cause Solution

WARNING! ▶ Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket.

improper repairs can cause considerable consequential damages. ▶ A damaged supply should only be replaced by the manufacturer, its service agent or Low temperature alarm when the temperature of the control sensor is too low; 1.Check the ambient temperature . 2.Check the Compressor connec- tor. 3.Check the resistance of the tem- perature control sensor.

Troubleshooting The door has been opened frequently or for long time. The door has been opened frequently or for long time.Problem Possible Cause Possible Solution Moisture accumulates on the wine cellar’s outside surface

The climate is too warm and too damp The door is not closed tightly.The cold air in the appliance and the warm air outside it condensates. This is normal in damp climate and will change when the hu- midity decreases. Ensure that the door is shut tightly and that the gaskets seal properly. The appliance makes abnormal sounds The appliance is not located on level ground. The appliance touches some ob- ject around it. Ajust the feet to level the appli- ance. Remove objects around the appliance. A slight sound is to be heard si milar water. This is normal - The interior light- ing or cooling system does not work. Mains plug is not connected to the mains socket. The power supply is not intact. The LED-lamp is out of order. Connect the mains plug. Check the electrical supply to- the room.Call the local electric- ity company. Please call the service for changing The sides of the cooler get warm. This is normal. - The door does not shut properly The appliance is not level. The door is blocked. Level the appliance with the leveling feet. Check for blockages like bottles or shelves. To contact the technical assistance, visit our website: https://corporate.haier-europe.com/en/ Under the section “website”, choose the brand of your product and your country. You will to contact the technical assistance.

Troubleshooting2019/2016 Explanations: 1)based on standard test results for 24 hours.The actual power consumption depends on the actual environment, the amount of bottling, the set temperature, the door opening and closing, etc. 2)The nominal power consumption is the value obtained according to the standard test when the wine cabinet does not turn on the internal light. - extended temperate: ‘this refrigerating appliance is intended to be used at ambient temperatures ranging from 10 °C to 32 °C’; - temperate: ‘this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 32 °C’; - subtropical: ‘this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 38 °C’; - tropical: ‘this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 43 °C’;

Technical data Standards and directives This product meets the requirements of all applicable EC directives with the correspon- ding harmonised standards, which provide for CE marking.

Airborne acoustical noise emisions (db (A) re 1pW) TType of applianype of applianccee TThis appliance is intended to be used exclusiveused exclusivellyy ffor the sor the sttoorrage of wine.age of wine. Yes Dimensions (W/D/H in mmDimensions (W/D/H in mm 475/456/1280 Wine Cellar

Yes 475/456/850 Wine Cellar

SN N ST Climate class: This appliance is intended to be used at an ambient temperature between 10 °C and 38 °C Ïõèèö÷äñçìñê Ïõèèö÷äñçìñê Ïõèèö÷äñçìñê Wine CellarHWS34GGH1ÔWe recommend our Haier Customer Service and the use of original spare parts. ▶ your local dealer or

Haier Poland Sp. zo.o. Al. Jerozolimskie 181B 02-222 Warszawa POLAND Haier Benelux SA Anderlecht Route de Lennik 451 BELGIUM Haier Iberia SL Pg. Garcia Faria, 49-51 08019 Barcelona SPAIN Haier Europe Trading SRL Via De Cristoforis, 12 21100 Verese ITALY ÊßÊÒÕÊËÒÕÒÝâØÏÜÙÊÛÎÙÊÛÝÜThermostats, temperature sensors, printed circuit boards and light sources are available for a minimum period of seven years after placing the last unit of the model on the market.Door handles, door hinges, trays and baskets for a minimum period of seven years and door gaskets for a minimum period of 10 year, after placing the last unit of the model on the market Öìñìðøðêøäõäñ÷èèìö2 years for EU Countries, 3 years for Turkey, 1 year for UK, 1 year for Russia, 3 years for Sweden, 2 years for Serbia, 5 years for Norway, 1 year for Morocco, 6 months for Algeria, Tunisia no legal warranty required. Ïòõéøõ÷ëèõìñéòõðä÷ìòñäåòø÷÷ëèóõòçøæ÷óïèäöèæòñöøï÷ë÷÷óö¦¦èóõèïèæèøõòóäèø¦ òõöæäñ÷ëèÚÛòñ÷ëèèñèõêüïäåèïöøóóïìèçúì÷ë÷ëèäóóïìäñæè

INFORMATIONS SUR LE PRODUIT

VNRQWDNWXMVLØ]XU]ØGHPPLHMVNLP

INFORMÁCIE O PRODUKTE