MICW81 - Microphone HQ Power - Free user manual and instructions

USER MANUAL MICW81 HQ Power

To all residents of the European Union Important environmental information about this product This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized company for recycling. This device should be returned to your distributor or to a local recycling service. Respect the local environmental rules. If in doubt, contact your local waste disposal authorities.

Thank you for choosing HQPower™! Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, do not install or use it and contact your dealer.

Read and understand this manual and all safety signs before using this appliance.

• This device can be used by children aged from 8 years and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and user maintenance shall not be made by children without supervision.

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not accept responsibility for any ensuing defects or problems.

• A qualified technician should install and service this device.

• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device against damage by leaving it switched off until it has reached room temperature.

• This device falls under protection class 1. It is therefore essential that the device be earthed. Have a qualified person carry out the electric connection.

• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.

• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.

• Note that damage caused by user modifications to the device is not covered by the warranty.

• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not accept responsibility for any ensuing defects or problems.

• A qualified technician should install and service this device.MICW81

• Refer to the Velleman

Service and Quality Warranty on the last pages of this manual.

• This device is designed for professional use on stage, in discos, theatres… The MICW81 should only be used indoors with the included adaptor or with one having the same rating, connected to a 230 V~, 50 Hz (max.) power source.

• Protect this device from shocks and abuse. Avoid brute force when operating the device.

• Select a location where the device is protected against extreme heat, dust and moisture.

• Familiarise yourself with the functions of the device before actually using it. Any damage that may occur will most probably be due to unprofessional use of the device.

• All modifications of the device are forbidden for safety reasons.

• Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.

• Use the original packaging if the device is to be transported.

• Make sure never to operate or transport the device outside the specified temperature range (see Technical specifications).

• Keep this manual for future reference.

Refer to the illustrations on page 2 of this manual.

RF indicator channel A

balanced output channel B

balanced output channel A

RF indicator channel B

low-battery indicator

1. Make sure the receiver is switched off and the volume knob is at its minimum.

2. Connect the adapter to the receiver and plug it in the mains.

3. Switch on the receiver.

When the low-battery indicator lights, the battery is low. Replace the batteries with new ones.

1. Make sure the microphone is switched off.

2. Open the battery compartment by lifting the plastic cover.

3. Insert two new 1.5 V AA batteries in accordance with the polarity markings inside

the battery compartment. Do not use rechargeable batteries as these might influence the performance.

4. Close the battery compartment and switch on the microphone.

• Malfunction may occur if the power is on when the battery is replaced. Dispose of batteries in accordance with local regulations.

• Keep batteries away from children.

1. Pull out both antennas and place them perpendicular to the receiver.

2. Connect the receiver to the sound system:

o OUT MIX: Use an appropriate audio cable to connect to the amplifier or mixing table.

o BALANCE OUT: Use an appropriate audio cable to connect to the amplifier or mixing table.

3. Make sure the volume level is at its minimum and switch on the receiver.

4. Switch on the microphone.

5. Adjust the volume to a moderate level.

6. Turn the volume level to its minimum prior to switch off the receiver.MICW81

V. 04 – 25/06/2021 7 ©Velleman nv

7. Care and Maintenance

• All screws should be tightened and free of corrosion.

• The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing) should not be deformed, modified or tampered with; e.g. do not drill extra holes in mounting supports, do not change the location of the connections…

• The electric power supply cables must not show any damage. Have a qualified technician maintain the device.

• Disconnect the device from the mains prior to maintenance activities.

• Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

• Do not open the receiver. There are no user-serviceable parts.

• Contact your dealer for spare parts if necessary.

• Remove power and batteries when the device is not used for a long time.

S/N ratio at 1 mV RF and peak deviation .................................................. max. 95 dB

AF output voltage at peak deviation and 1 kHz AF out

RED Declaration of Conformity

Hereby, Velleman NV declares that the radio equipment type MICW81 is in compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at the following internet address: www.velleman.eu.

Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or injury resulting from (incorrect) use of this device. For more info concerning this product and the latest version of this manual, please visit our website www.velleman.eu. The information in this manual is subject to change without prior notice.

The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the prior written consent of the copyright holder.MICW81

• All consumer products are subject to a 24-month warranty on production flaws and defective material as from the original date of purchase.

• Velleman® can decide to replace an article with an equivalent article, or to refund the retail value totally or partially when the complaint is valid and a free repair or replacement of the article is impossible, or if the expenses are out of proportion. You will be delivered a replacing article or a refund at the value of 100% of the purchase price in case of a flaw occurred in the first year after the date of purchase and delivery, or a replacing article at 50% of the purchase price or a refund at the value of 50% of the retail value in case of a flaw occurred in the second year after the date of purchase and delivery.

• Not covered by warranty: - all direct or indirect damage caused after delivery to the article (e.g. by oxidation, shocks, falls, dust, dirt, humidity...), and by the article, as well as its contents (e.g. data loss), compensation for loss of profits; - consumable goods, parts or accessories that are subject to an aging process during normal use, such as batteries (rechargeable, non-rechargeable, built-in or replaceable), lamps, rubber parts, drive belts... (unlimited list); - flaws resulting from fire, water damage, lightning, accident, natural disaster, etc.…; - flaws caused deliberately, negligently or resulting from improper handling, negligent maintenance, abusive use or use contrary to the manufacturer’s instructions; - damage caused by a commercial, professional or collective use of the article (the warranty validity will be reduced to six (6) months when the article is used professionally); - damage resulting from an inappropriate packing and shipping of the article; - all damage caused by modification, repair or alteration performed by a third party without written permission by Velleman®.

• Articles to be repaired must be delivered to your Velleman® dealer, solidly packed (preferably in the original packaging), and be completed with the original receipt of purchase and a clear flaw description.

• Hint: In order to save on cost and time, please reread the manual and check if the flaw is caused by obvious causes prior to presenting the article for repair. Note that returning a non-defective article can also involve handling costs.

• Repairs occurring after warranty expiration are subject to shipping costs.

• The above conditions are without prejudice to all commercial warranties. The above enumeration is subject to modification according to the article (see article’s manual).