NT 611 Eco K - Vacuum Cleaner Kärcher - Free user manual and instructions

USER MANUAL NT 611 Eco K Kärcher

Register your product www.kaercher.com/welcome NT 611 Eco K

Teile-Nr. Kabellänge EU 6.649-413.0 10 m CH 6.649-254.0 10 m 10 DE– 1 Please read and comply with these origi- nal instructions prior to the initial opera- tion of your appliance and store them for later use or subsequent owners. – Before first start-up it is definitely necessary to read the safety indications Nr. 5.956-249.0! – The non-compliance of the operating and safety in- structions may lead to damages of the appliance and to dangers for the operator and other persons. – In case of transport damage inform vendor immedi- ately. – When unpacking the product, make sure that no accessories are missing and that none of the pack- age contents have been damaged. Electrical and electronic devices often contain compo- nents which could potentially pose a danger to human health and the environment if handled or disposed of in- correctly. However, these components are necessary for the proper operation of the device. Devices marked with this symbol must not be disposed of with regular household rubbish. Notes about the ingredients (REACH) You will find current information about the ingredients at: www.kaercher.com/REACH 몇 WARNING The appliance is not suitable for vacuuming dust which endangers health. – This vacuum cleaner is intended for the continuous disposal of large volumes of liquid (flood damage, vacuuming containers, basins or tanks, etc.), as well as for the wet and dry cleaning of floor or wall surfaces. – This appliance is suited for the commercial use, e.g. for handymen and commercial businesses. 1Float 2 Power cord 3 Suction hose 4 Suction head lock 5 Dirt receptacle 6 Cable holder of the disposal pump 7 Lock plate 8 Steering roller bow 9 Steering roller 10 Floor nozzle 11 Suction tube 12 Suction support 13 Suction head 14 Disposal pump 15 Acorn nut of the disposal pump 16 Float switch of the disposal pump 17 Carrying handle 18 Filter cover 19 Handle for filter cleaning 20 Push handle 21 Bender 22 Mains plug of the disposal pump 23 Switch "Disposal pump OFF" 24 Socket 25 Switch "Disposal pump ON" 26 Main switch 27 Exhaust filter 28 Coarse dirt filter/flat fold filter 29 Drain hose 30 Floor nozzle holder 31 Cap 32 Holder for suction pipes 33 Cable hook 34 Holder for crevice nozzle 35 Nameplate – It is recommended that you connect this device to a socket that has a 30 mA protection switch against wrong currents. The appliance allows 3 operating modes: 1 Wet vacuuming with disposal pump 2 Wet vacuuming without disposal pump 3 Dry vacuum cleaning Note: You can wet vacuum if the disposal pump is turned off or has been removed. Removal of disposal pump, see dry vacuuming. Illustration Remove the brush strips. Install the rubber lips. Note: The structured side of the rubber lips must point outwards. Contents Environmental protection EN 1 Proper use EN 1 Device elements EN 1 Start up EN 1 Operation EN 2 Transport EN 3 Storage EN 3 Care and maintenance EN 3 Troubleshooting EN 3 Warranty EN 3 Accessories and Spare Parts EN 3 EU Declaration of Conformity EN 4 Technical specifications EN 4 Environmental protection The packaging material can be recycled. Please do not throw the packaging mate- rial into household waste; please send it for recycling. Old appliances contain valuable materi- als that can be recycled; these should be sent for recycling. Batteries, oil, and sim- ilar substances must not enter the envi- ronment. Please dispose of your old ap- pliances using appropriate collection sys- tems. Proper use Device elements Start up Wet vacuum cleaning Inserting the rubber lips 11EN– 2 Illustration Release and remove the suction head. Pull the paper filter bag/fleece filter bag towards the rear. Insert and lock the suction head. – To vacuum wet dirt, first remove the paper or fleece filter bag. Illustration Release and remove the suction head. Remove the membrane filter. Insert and lock the suction head. – To suck wet dirt, always remove the membrane fil- ter. Open filter door. Take out the flat folded filter. Install the coarse dirt filter. Close the filter door, it must lock into place. Illustration Remove the cap. Connect the disposal hose (nominal width 3/4" or larger). 몇 CAUTION Please observe the local provisions regarding the wastewater treatment. Illustration Drain off dirty water through the drainage hose. ATTENTION The coarse dirt filter must never be removed during vac- uuming. – Wet vacuuming without disposal pump: It is recom- mended to use a special filter bag (wet) (see Filter systems). – If the maximum liquid level is reached the appli- ance will turn off automatically. – After the wet vacuuming: Clean the floater, contain- er and the disposal pump if necessary, using a damp rag and dry them. ATTENTION Prior to dry vacuuming: Remove the disposal pump and install the flat fold filter. Note: You must use a flat fold filter during dry vacuum- ing. ATTENTION The flat pleated filter must always be in place while vac- uuming. – To vacuum fine dust, you can also use an addition- al paper filter bag, a fleece filter bag or a membrane filter. Unplug the mains plug of the disposal pump. Release and remove the suction head. Illustration Unscrew the acorn nut of the disposal pump. Remove the cable holder of the disposal pump and replace it with a locking cap. Remove the disposal pump and plastic insert si- multaneously from the container as the float switch of the disposal pump is attached to the plastic in- sert and could otherwise be damaged. Illustration Install the locking cap instead of the disposal hose. Insert and lock the suction head. Note: The flat fold filter is not included in the delivery. Open filter door. Take out the coarse dirt filter. Install the flat fold filter. Close the filter door, it must lock into place. Illustration Remove the rubber lips. Install the brush strip. Note: A paper filter bag or a fleece filter bag is not in- cluded in the delivery. Illustration Release and remove the suction head.

Place the paper or fleece filter bag. Insert and lock the suction head. Note: A membrane filter is not included in the delivery. Note: If you work without the paper filter bag or fleece filter bag, you must use a membrane filter to protect the suction head. Illustration Release and remove the suction head. Pull the membrane filter over the container edge. Insert and lock the suction head. Illustration The suction hose is equipped with a clip system. All C- 40/C-DN-40 accessories can be connected. DANGER Risk of injury and damage! The socket outlet is intended only for the direct connection of the disposal pump. Any other use of the socket outlet is not permitted. Plug in the mains plug of the appliance. Switch on the appliance at the main switch. Continuously dispose of large volumes of liquid: Switch on the disposal pump. Continuously dispose of liquids or clean. While vacuuming, clean the flat-fold filter at regular in- tervals. Pull the handle of the filter clean-off out several times and reinsert it. Remove the paper filter bag/fleece filter bag Remove the membrane filter Coarse dirt filter installation Connection of disposal pump Drain off dirt water General Dry vacuum cleaning General Removal of the disposal pump Installation of flat fold filter Install the brush strip Installing the paper filter bag/fleece filter bag Install membrane filter Clip connection Operation Turning on the Appliance Disposal or cleaning operation Filter dedusting 12 EN– 3 Shut off the disposal pump if necessary. Switch off the appliance at the main switch. Unplug the mains plug of the appliance. Filter dedusting: Pull the handle out several times and reinsert it. Empty the container. Vacuum and wipe the appliance inside and outside with a damp cloth. Wrap the mains connection cable around the hooks on the slider. Wind the suction hose around the sliding bow. Place the appliance in a dry room and secure it from unauthorized use. 몇 CAUTION Risk of injury and damage! Observe the weight of the appliance when you transport it. Remove the suction pipe with the floor nozzle from the holder. Hold the appliance at the handle and at the suction pipe to transport it. When transporting in vehicles, secure the appli- ance according to the guidelines from slipping and tipping over. 몇 CAUTION Risk of injury and damage! Note the weight of the appli- ance in case of storage. This appliance must only be stored in interior rooms. DANGER First pull out the plug from the mains before carrying out any tasks on the machine. Open filter door. Replace the coarse dirt filter/flat-fold filter or the ex- haust filter. Close the filter door, it must lock into place. Release and remove the suction head. Clean the floater with a moist cloth. Insert and lock the suction head. Release and remove the suction head. With disposal pump: Lay the container on its side and rinse it out with a water stream. Without disposal pump: Remove the disposal pump (see dry vacuum cleaning) and clean the container. Insert and lock the suction head. DANGER First pull out the plug from the mains before carrying out any tasks on the machine. Check the receptacle and the fuse of the power supply. Check the power cable and the power plug of the device. Turn on the appliance. Check the swimmer. Switch on the disposal pump. Remove obstructions from the suction nozzle, suc- tion tube, suction hose, or coarse dirt filter/flat-fold filter. Filter dedusting: Pull the handle out several times and reinsert it. Replace the paper or fleece filter bag. Ensure the filter cover properly locks into place. Clean or replace the membrane filter under running water. Replace the flat pleated filter. Check drain pipe for leaks. Check for proper installation of the flat pleated filter. Check the proper installation of the coarse dirt filter. Install the flat fold filter. Check for proper installation of the flat pleated filter. Replace the flat pleated filter. Check the socket of the appliance. Free the stuck floater switch in the container. Release the stuck pump impeller in the pump. Route the disposal hose without kinks. Check the disposal hose for obstructions. If malfunction can not be fixed, the device must be checked by customer service. The warranty terms published by the relevant sales company are applicable in each country. We will repair potential failures of your appliance within the warranty period free of charge, provided that such failure is caused by faulty material or defects in manufacturing. In the event of a warranty claim please contact your dealer or the nearest authorized Customer Service center. Please submit the proof of purchase. Only use original accessories and spare parts, they en- sure the safe and trouble-free operation of the device. For information about accessories and spare parts, please visit www.kaercher.com. Turn off the appliance After each operation Storing the Appliance Transport Storage Care and maintenance Replacing the coarse dirt filter/flat-fold filter or the exhaust filter Cleaning the floater Cleaning the dirt receptacle Troubleshooting Suction turbine does not run Suction turbine turns off Suction capacity decreases Dust escapes during dry vacuuming Disposal pump is not running Disposal pump does not produce much volume Customer Service Warranty Accessories and Spare Parts 13EN– 4 We hereby declare that the machine described below complies with the relevant basic safety and health re- quirements of the EU Directives, both in its basic design and construction as well as in the version put into circu- lation by us. This declaration shall cease to be valid if the machine is modified without our prior approval. 5.957-602 The signatories act on behalf of and with the authority of the company management. Documentation supervisor: S. Reiser Alfred Kärcher SE & Co. KG Alfred-Kärcher-Straße 28-40 71364 Winnenden (Germany) Tel.: [phone] Fax: [phone] Winnenden, 2020/10/01 EU Declaration of Conformity Product: Wet and dry vacuum cleaner Type: 1.146-xxx Relevant EU Directives 2006/42/EC (+2009/127/EC) 2014/30/EU 2011/65/EU Applied harmonized standards EN 55014–1: 2017 + A11: 2020 EN 55014–2: 2015 EN 60335–1 EN 60335–2–69 EN 61000–3–2: 2014 EN 61000–3–3: 2013 EN 62233: 2008 EN IEC 63000: 2018 Applied national standards