NT 401 Tact Bs - Vacuum Cleaner Kärcher - Free user manual and instructions

USER MANUAL NT 401 Tact Bs Kärcher

Register your product www.kaercher.com/welcome NT 40/1 Tact Bs

Teile-Nr. Kabellänge EU 6.650-591.0 7,5 m 11DE– 1 Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent own- ers. – Before first start-up it is definitely nec- essary to read the safety indications Nr. 5.956-249.0! – The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dan- gers for the operator and other persons. – In case of transport damage inform ven- dor immediately. – When unpacking the product, make sure that no accessories are missing and that none of the package contents have been damaged. Notes about the ingredients (REACH) You will find current information about the ingredients at: www.kaercher.com/REACH DANGER Pointer to immediate danger, which leads to severe injuries or death. 몇 WARNING Pointer to a possibly dangerous situation, which can lead to severe injuries or death. 몇 CAUTION Pointer to a possibly dangerous situation, which can lead to minor injuries. ATTENTION Pointer to a possibly dangerous situation, which can lead to property damage. 몇 WARNING The appliance is not suitable for vacuuming dust which endangers health. – This vacuum cleaner is specially de- signed for use in bakeries and for clean- ing ovens. – This appliance is suitable for commer- cial use. – The device is supplied without accesso- ries. – The optionally available accessory kits were specially developed for use in bakeries, see accessories and spare parts. Contents Environmental protection ... EN 1 Danger or hazard levels ... EN 1 Proper use ... EN 1 Description ... EN 1 Device elements ... EN 2 Start up ... EN 2 Operation ... EN 2 Transport... EN 3 Storage ... EN 3 Care and maintenance ... EN 3 Troubleshooting ... EN 3 Warranty ... EN 4 Accessories and Spare Parts . EN 4 EU Declaration of Conformity . EN 5 Technical specifications ... EN 6 Environmental protection The packaging material can be recycled. Please do not throw the packaging material into household waste; please send it for recycling. Old appliances contain valuable materials that can be recycled; these should be sent for recy- cling. Batteries, oil, and similar substances must not enter the environment. Please dispose of your old appliances using appro- priate collection systems. Danger or hazard levels Proper use Description 12 EN– 2 1 Electrodes 2 Holder for suction pipe 3 Push handle 4 Hose hook 5 Air outlet, working air 6 Suction head 7 Suction head lock 8 Recessed grip 9 Dirt receptacle 10 Steering roller 11 Handle 12 Air inlet, motor cooling air 13 Suction support 14 Stop for tool box 15 Fixing eyelet 16 Filter cover 17 Carrying handle 18 Rotating knob 19 Holder for floor nozzle or oven nozzle 20 Fastening screw for slider 21 Power cord 22 Filter frame 23 Flat fold filter (PES) 24 Filter dedusting 25 Nameplate ATTENTION The flat pleated filter must always be in place while vacuuming. Static charge is deflected by providing earthing to the connection nozzles. This prevents the formation of sparks and cur- rent shocks due to attachments (option) with electrical conductivity. – If wet dirt is vacuumed with the uphol- stery or crevice nozzle, or if water is sucked up from a container, it is recom- mended to deactivate the "automatic fil- ter cleaning" function. – If the maximum liquid level is reached the appliance will turn off automatically. – In case of non-conductive liquids (such as emulsion drilling fluids, oils, and greases) the appliance is not turned off when the container is full. The filling level must be continu- ously monitored and the container must be emptied in time. – After the wet vacuuming: Clean the flat folded filter with the filter cleaning. Clean the electrodes with a brush. Clean the container with a damp rag and dry it. Illustration The suction hose (special accessories) is equipped with a clip system. All accessory parts with a nominal width of 35 mm can be connected. ATTENTION At the latest after 50 oven cleanings, the flat folded filter must be replaced. ATTENTION In order to guarantee safe operation of the vacuum cleaner, hot air (max. temperature 200 °C) should under no circumstances be suctioned for longer than 5 minutes without interruption. Plug in the mains plug. Set the rotary switch to the desired pro- gram. Device elements Start up Anti-static system Wet vacuum cleaning Clip connection Operation Rotating knob Appliance OFF Appliance ON Automatic filter cleaning: OFF Appliance ON Automatic filter cleaning: maxi- mum interval Appliance ON Automatic filter cleaning: mini- mum interval Turning on the Appliance 13EN– 3 The appliance has an special filter cleaning system that is particularly effective with fine dust. The flat pleated filter is automatically cleaned every 15 seconds (TACT MAX) or every 60 seconds (TACT MIN) through an air jet (pulsating sound). Set the rotary switch to the desired pro- gram (TACT MIN-TACT MAX). Illustration Power dedusting (especially with se- vere soiling of the flat pleated filter): Set the rotary switch to program 2, cover the suction tube or the bender with your hand and wait for the automatic filter dedusting (every 15 seconds). Switch off the appliance at the rotating knob. Pull out the mains plug. Empty the container. Vacuum and wipe the appliance inside and outside with a damp cloth. Illustration Store the suction hose (special acces- sories) and mains cable as shown in the illustration. Place the appliance in a dry room and secure it from unauthorized use. 몇 CAUTION Risk of injury and damage! Observe the weight of the appliance when you transport it. Remove the suction pipe with floor noz- zle or oven nozzle from the support. Carry the device by the carrying handle and the suction pipe, not by the push handle. When transporting in vehicles, secure the appliance according to the guide- lines from slipping and tipping over. 몇 CAUTION Risk of injury and damage! Note the weight of the appliance in case of storage. This appliance must only be stored in inte- rior rooms. DANGER First pull out the plug from the mains before carrying out any tasks on the machine. Illustration Open filter door. Remove filter frame. Replace the flat pleated filter. During placement, make sure that the flat fold filter rests against all sides. Insert filter frame. Close the filter door, it must lock into place. Release and remove the suction head. Clean the electrodes with a brush. Insert and lock the suction head. DANGER First pull out the plug from the mains before carrying out any tasks on the machine. Check the receptacle and the fuse of the power supply. Check the power cable, the power plug and electrodes of the device. Turn on the appliance. Empty the container. Automatic filter cleaning Turn off the appliance After each operation Storing the Appliance Transport Storage Care and maintenance Exchanging the flat pleated filter Cleaning the electrodes Troubleshooting Suction turbine does not run Suction turbine turns off 14 EN– 4 Turn off the appliance and wait for 5 sec- onds, turn it on again after 5 seconds. Clean the electrodes with a brush. Remove blockages in the suction noz- zle, suction tube, suction hose, or flat pleated filter. Ensure the filter cover properly locks into place. Replace the flat pleated filter. Illustration Check/correct the correct positioning of the flat pleated filter. Replace the flat pleated filter. Clean the electrodes with a brush. Continuously check the filling level in case of non-conductive liquid. Suction hose is not connected. Inform Customer Service. Inform Customer Service. If malfunction can not be fixed, the de- vice must be checked by customer ser- vice. The warranty terms published by the rele- vant sales company are applicable in each country. We will repair potential failures of your appliance within the warranty period free of charge, provided that such failure is caused by faulty material or defects in man- ufacturing. In the event of a warranty claim please contact your dealer or the nearest authorized Customer Service centre. Please submit the proof of purchase. Only use original accessories and spare parts, they ensure the safe and trouble-free operation of the device. For information about accessories and spare parts, please visit www.kaercher.com. Only use the following accessories to clean ovens: Suction turbine does not start again after the container has been emptied Suction capacity decreases Dust comes out while vacuuming Automatic shut-off (wet vacuum cleaning) does not react Automatic filter cleaning is not working Automatic filter cleaning cannot be switched off Automatic filter cleaning cannot be switched on Customer Service Warranty Accessories and Spare Parts Bakery kit Name Order No. Piece Bakery kit, electri- cally conductive 2.640-436.0 1 Flat fold filter (PES) 6.907-662.0 1 Oven kit Name Order No. Piece Suction hose (in- cluded in the oven kit), antistatic 4.440-731.0 1 Oven kit, antistatic 2.640-341.0 1 Flat fold filter (PES) 6.907-662.0 1 15EN– 5 We hereby declare that the machine de- scribed below complies with the relevant basic safety and health requirements of the EU Directives, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the machine is modified without our prior approval. 5.966-337 The signatories act on behalf of and with the authority of the company management. Documentation supervisor: S. Reiser Alfred Kärcher SE & Co. KG Alfred-Kärcher-Straße 28-40 71364 Winnenden (Germany) Tel.: [phone] Fax: [phone] Winnenden, 2018/10/01 EU Declaration of Conformity Product: Wet and dry vacuum cleaner Type: 1.148-xxx Relevant EU Directives 2006/42/EC (+2009/127/EC) 2014/30/EU 2011/65/EU Applied harmonized standards EN 55014–1: 2006+A1: 2009+A2: 2011 EN 55014–2: 2015 EN 60335–1 EN 60335–2–69 EN 61000–3–2: 2014 EN 61000–3–3: 2013 EN 62233: 2008 EN 50581 Applied national standards

Chairman of the Board of Management Director Regulatory Affairs & Certification 16 EN– 6 Technical specifications NT 40/1 Tact Bs Mains voltage V 220-240 Frequency Hz 1~ 50-60 Max. performance W 1380 Rated power W 1200 Container capacity l 39 Filling quantity (liquid) l 24 Air volume (max.) l/s 74 Negative pressure (max.) kPa (mbar) 25.4 (254) Surface of the flat fold filter m

Power cord H07RN-F 3x1,0 mm

www.kaercher.com/REACH