RDC 1008 - Alarm clock radio Explore Scientific - Free user manual and instructions

USER MANUAL RDC 1008 Explore Scientific

42ABOUT THIS INSTRUCTION MANUAL

These operating instructions are to be considered a component of the device. Please read the safety instructions and the operating instructions carefully before use. Keep these instructions for renewed use at a later date. When the device is sold or given to someone else, the instruction manual must be provided to the new owner/ user of the product. The device is intended only for indoor use.

• Risk of electric shock — This device contains electronic components. Only use the device as de- scribed in the manual; otherwise, you run the risk of an electric shock.

• Choking hazard — Children should only use the device under adult supervision. Keep packaging material, like platic bags and rubber bands, out of the reach of children, as these materials pose a choking hazard.

• Risk of chemical burn — Keep batteries out of the reach of children! Make sure you insert the ba- tteries correctly. Leaking battery acid can lead to chemical burns. Avoid contact of battery acid with skin, eyes and mucous membranes. In the event of contact, rinse the affected region immediately with a plenty of water and seek medical attention.

• Risk of fire/explosion — Do not expose the device to high temperatures. Use only the recomme- nded batteries. Do not short-circuit the device or batteries, or throw them into a fire. Excessive heat or improper handling could trig- ger a short-circuit, a fire, or an explosion.

• Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will contact the Service Centre and can send the device in to be repaired, if necessary.

• Use only the recommended batteries. Always replace weak or empty batteries with a new, compl- ete set of batteries at full capacity. Do not use batteries from different brands or with different capacities. The batteries should be removed from the unit if it has not been used for a long time. 2EN

Clock, Operating instructions, 2x AAA batteries.

• Avoid using rechargeable batteries. (Rechargeable batteries cannot maintain correct power req- uirements.)

• Insert batteries before first use, matching the polarity in the battery compartment. 2x AAA Batt- eries are required for the Clock.PRODUCT OVERVIEW

1. Press [ SNZ / LIGHT ] to activate the backlight or to activate the snooze function to delay thealarm

[ ▼　] to decrease one unit, press and hold to decrease rapidly.

3. While in time setting mode, press [ ▲ ] to increase one unit, press and hold to increase

rapidly. While in alarm time checking mode, press [ ▲ ] to turn on/off the Alarm 1 or Alarm 2.

4. Press and hold [ ] to enter time and date setting mode.

5. Press [ ] to check the alarm time. Press and

hold [ ] to enter alarm setting mode.

6. Press [ ] to initiate or stop RCC receiving.

7. Battery compartment.

Increase Quick Increase Check alarm time Enter into alarm setting Select °C or °F

Quick Decrease Decrease Quick Decrease

Enter into time and date setting Confirm setting

Confirm setting Initiate or stop RCC receiving

Alarm 2 on/off _______LCD DISPLAY

1. Remove the battery door from the back.

3. Reattach the battery door.

NOTE: Replace batteries when the display is dim. CLOCK CLOCK RECEPTION

1. When you insert or replace the batteries, RCC reception is initiated. To manually start RCC rece-

ption, press and hold the [ ] button.

2. If the RCC receiving process is successful, a completed RCC symbol [ ] will be shown in the

display and the date and time will be set automatically. If it fails, press and hold the [ ] button to re-initiate RCC receiving.

3. If the device is still not receiving the signal, please proceed to set the time manually.

SET THE CLOCK MANUALLY

1. Press and hold [ ] button to enter into time and date setting.

2. The setting parameter will flash.

3. Press [ ▲ ] button once, the figure will increase 1 unit. Press and hold the [ ▲/CF ] button, the

figures will increase rapidly.

4. Press [ ▼ ] button once, the figure will decrease 1 unit. Press and hold the [ ▼/RCC ] button, the

figures will decrease rapidly.

NL5. Press [ ] button to confirm setting and enter to next parameter.

6. Sequence of setting: Year (2004-2054) Month Date 7 Languages Week Display

12/24HR Time Zone Hour Minute Exit

7. If there is no action in 30 seconds or If you press [ ] button, the setting will be saved and

you will exit the setting mode.

1. Press and hold [ ] button to enter alarm setting mode.

5. Press [ ] button to confirm setting and exit.

6. Alarm will turn on automatically when alarm setting is finished.

Press [ ] to check the alarm time. Sequence of display: Alarm 1 Alarm 2 While in alarm time checking mode, press the [ ▲ ] button to turn on/off the Alarm 1 or Alarm 2. 8SNOOZE FUNCTION

1. At the set time, alarm signal rings.

2. During the alarm, press the [ SNZ / LIGHT ] button to delay the alarm by 5 minutes.

3. To stop the alarm, press [ ] or any other button, except for [ SNZ / LIGHT ].

4. The alarm will start again at the next alarm time, unless you switch off the alarm function by

pressing the [ ] to choose Alarm 1 or Alarm 2 and then press [ ▲ ] button until the alarm is set to off. TEMPERATURE The indoor temperature is always displayed in the right bottom corner of the screen. BACKLIGHT Press [ SNZ / LIGHT ] to activate backlight for 5 seconds. SPECIFICATIONS MAIN UNIT: Dimensions 80 x 70 x 30 mm (L x W x H) Weight 85 g (Exclude batteries) Power: 2x AAA (LR03) 1.5V batteries

9EC DECLARATION OF CONFORMITY

Hereby, Explore Scientific GmbH declares that the equipment type with part number: RDC1008 is in compliance with Directive: 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.bresser.de/download /RDC1008/CE/RDC1008_CE.pdf

• Remove the batteries before cleaning.

• Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not use any cleaning fluid.

• Protect the device from dust and moisture. DISPOSAL Dispose of the packaging materials properly, according to their type, such as paper or cardb- oard. Contact your local waste-disposal service or environmental authority for information on the proper disposal. Do not dispose of electronic devices in the household garbage! As per the Directive 2002/96/EC of the European Parliament on waste electrical and electronic equipment and its adaptation into German law, used electronic devices must be collected se- parately and recycled in an environmentally friendly manner.

TEMPERATURE: Indoor temperature display range: -20°C to +50°C (-4°F to 122°F)Cd ¹ Hg ² Pb ³ In accordance with the regulations concerning batteries and rechargeable batteries, disposing of them in the your used batteries as required by law — at a local collection point or in the ret- ail market. Disposal in domestic waste violates the Battery Directive. Batteries that contain toxins are marked with a sign and a chemical symbol.

battery contains cadmium

battery contains mercury

battery contains lead12 WARRANTY & SERVICE The regular guarantee period is 2 years and begins on the day of purchase. To benefit from an ext- ended voluntary guarantee period as stated on the gift box, registration on our website is required. You can consult the full guarantee terms as well as information on extending the guarantee period and details of our services at www.bresser.de/warranty_terms. Would you like detailed instructions for this product in a particular language? Then visit our website via the link below (QR code) for available versions. Alternatively you can also send an email to [e-mail] or leave a message on +49 (0) 28 72 – 80 74-220*. Please always state your name, precise address, a valid phone number and email address, as well as the article number and name.

Number charged at local rates in Germany (the amount you will be charged per phone call will depend on the tariff of your phone provider); calls from abroad will involve higher costs. Errors and technical changes reserved. MANUAL DOWNLOAD: www.bresser.de/download/RDC1008 SERVICE AND WARRANTY: