IAN 113978 - Lighting Livarno Lux - Free user manual and instructions

USER MANUAL IAN 113978 Livarno Lux

Introduction We congratulate you on the purchase of your new device. You have chosen a high quality product. Please read carefully and completely through these operating instructions. Fold out the page with the illustrations. These instruc- tions form part of the product and contain important information about bringing the product into use and its handling. Always observe all the safety advice. Check that the correct mains voltage is available and that all the parts have been properly assembled before bringing into use. Should you have any questions or be uncertain as to how to operate the device, please get in touch with your dealer or ser- vice point. Please keep these instructions in a safe place and hand them on to a third party if necessary.

Proper use This light is designed only for use indoors, in dry and enclosed rooms. The light can be attached to any surface classified as normally inflammable, except pipes. Any use other than that described above or modification to the lamp is not permitted and may lead to damage to people or property. Moreover, there is the risk of injury or loss of life and that the lamp may develop technical faults such as short circuit or fire or give an electric shock. This lamp is intended for use only in a domestic environment.

Included items Check that all the items and accessories are pre- sent and that the lamp is in perfect condition immediately after unpacking. 1 LED clip light (1-light spotlight) 1 Operating instructions

Description of parts

Mains lead with plug

Safety Safety advice The right to claim under the guarantee shall be rendered invalid in respect of damage caused by the non-observance of these operating instructions! No liability is accepted for consequent damage! No liability is accepted for damage to property or persons caused by improper handling or non- observance of the safety advice! To avoid danger to life from electric shock Every time before connecting the lamp the mains, check it and the mains lead for damage. Never use your light if you find it is damaged in any way. CAUTION! A damaged mains lead presents a serious danger to life from electric shock. In the event of damage, repairs or other problems with the lamp please contact the service centre or an electrician. Never let the lamp come into contact with water or other liquids. Never open any electrical fittings such as in-line switches, transformers etc. or allow any object to be inserted into them. This sort of interference Safety / Initial use / Operation / Maintenance and Cleaning / Disposal15 GB Introduction / Safety Safety / Initial use / Operation / Maintenance and Cleaning / Disposal can lead to a serious danger to life from electric shock. To avoid danger of fire and injury RISK OF INJURY! Check each light for damage immediately after unpacking. Do not assemble the light if the bulbs and/or lamp glass are defective. In this event, contact the service centre for a replacement. RISK OF INJURY FROM BURNS! Ensure the lamp has been switched off and allowed to cool before you touch it. In this way you will avoid the danger of burns. Bulbs give off a lot of heat around the top of the lamp. Never leave the spotlight operating unattended. Fire can result from the development of too much heat. This light is not suitable for use as a night light. Do not allow the lamp or the packaging materials to lie around unattended. Plastic film or bags, Styrofoam etc. can turn into dangerous toys for children. Do not attach the lamp to damp or conductive substrates. Do not look into the LED from a close distance during operation. Do not look at the LED with an optical instru- ment (e.g. magnifier). The LED lights cannot be replaced. Working safely Fit the light in such a way to ensure it is protected from damp and dirt. Do not attach this spotlight to pipes.

Initial use Ensure the installation site is clean and dry. Clamp the spotlight on to a suitable object. Note: make sure that the anti-slip rubbers and the bracket are secure. Insert the mains plug

(attached to the mains lead) into the mains socket. Your spotlight is now ready for operation.

to turn the spotlight on or off.

Directing the spotlight Only change the direction of the spotlight

after the light has been switched off. Allow the lamp to cool down completely. Bend the flexible arm into the desired position.

Maintenance and Cleaning

CAUTION! DANGER OF ELECTRIC

SHOCK! First pull the plug

attached to the mains lead out of the mains socket. Do not use any solvents, petrol or similar. This would cause damage to the light. Allow the lamp to cool down completely.

CAUTION! DANGER OF ELECTRIC

SHOCK! For reasons of electrical safety, the light must never be cleaned with water or other fluids or be immersed in water. When cleaning, only use a dry, lint-free cloth.

Disposal The packaging and ancillary packing consist entirely of environmentally-friend- ly materials. They can be disposed of at your local recycling facility. The symbol of the wheelie bin with the line through it means that, in the European Union, the product has to be disposed of in a separate refuse collection. This applies to16 GB Disposal / Warranty and Service the product and to all components bearing this symbol. Products marked in this way may not be disposed of along with normal domestic waste but have to be handed in at a recycling collection point for electrical and electronic appliances. Recycling helps to reduce the consumption of raw materials and to ease the burden on the environment.

Warranty and Service

Guarantee You receive a 36 month warranty on this product, valid from the date of purchase. The device has been carefully produced under strict quality control. Within the warranty period we shall rectify without charge all material and manufacturing defects. In the event of a defect arising during the warranty period, please send the device to the listed Service Centre address, making reference to the following article number: 14103106L / 14103204L / 14103304L / 14103408L. Wear parts (such as bulbs) and damage caused by improper handling, non-observance of the oper- ating instructions or unauthorised interference are excluded from the warranty. The performance of services under the warranty does not extend or renew the warranty period.

Declaration of Conformity This product fulfils the requirements of the applicable European and national directives (Electromagnetic Compatibility 2004 / 108 / EC, Low Voltage Directive 2006 / 95 / EC, Ecodesign Directive 2009/125/EC, RoHS Directive 2011/65/EU). Conformity has been demonstrated. The relevant declarations and documents are held by the manufacturer. Manufacturer Briloner Leuchten GmbH Im Kissen 2 59929 Brilon GermanyBRILONER LEUCHTEN GMBH Im Kissen 2 D-59929 Brilon