IAN 91837 - Lighting Livarno Lux - Free user manual and instructions

USER MANUAL IAN 91837 Livarno Lux

Operation and Safety Notes

SE

LED-LaMpOr

GB/IEOperation and Safety NotesPage 4

The product is not intended to be used for commercial purposes.

Description of parts

LED lamp
2 Battery compartment
3 Battery compartment cover
4 Self-adhesive pad
5 LED bulb
1.5V AAA battery

- Technical data

Bulbs: 4 × LED, 0.5 W (The LED bulbs cannot be replaced)

Batteries: 3 × 1.5V = - , AAA (included)

General Safety Instructions

KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE!

A WANGF DEATH AND ACCIDENTS FOR TODDLERS AND CHILDREN!

Never leave children unsupervised with the packaging material. The packaging material represents a danger of suffocation. Children frequently underestimate the dangers. Always keep children away from the packaging material. This product is not a toy.

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

CAUTION! RISK OF INJURY! Please do not use this device if you find that it is damaged in any way.

Check whether all of the parts are correctly fitted. If the device is not correctly assembled there is a danger of injury.
- Keep the product away from humidity.
Do not subject the device to any extreme temperatures or severe mechanical stress. Otherwise this may result in deformation of the product.
The lamps are only intended for use indoors, in dry and enclosed areas.

Battery Safety Instructions

WARNING! DANGER TO LIFE! Keep

batteries out of the reach of children. Do not leave batteries lying around. There is a risk of children or animals swallowing them. Consult a doctor immediately if a battery is swallowed.

EXPLOSION HAZARD! Never recharge nonrechargeable batteries, short-circuit and / or open batteries.

This can cause them to overheat, burn or burst. Never throw batteries into fire or water. The batteries may explode.

Remove spent batteries from the product immediately. Otherwise there is an increased risk of leakage.
Always replace all batteries at the same time and only use batteries of the same type.
Do not use different types of batteries or mix used and new batteries together.
Check regularly that the batteries are not leaking.
Leaked or damaged batteries can cause chemical burns if they come into contact with the skin; in such cases wear suitable protective gloves!
Remove the batteries from the product if it is not in use for any length of time.
Make sure that the polarity is correct when you insert the batteries! This is indicated in the battery compartment. The batteries can otherwise explode.

Remove used batteries from the device. Very old or used batteries may leak. The chemical fluid can damage the product.

Bringing into use

- Inserting/replacing the batteries

Note: Remove the insulating strips before using the product for the first time.

Note: Switch the product off before you insert or remove the batteries.

Turn the battery compartment cover 3 anticlockwise and take it off the battery compartment 2 (see Fig. A).
Insert the (new) batteries into the battery compartment.

Note: Make sure you fit the batteries the right way round (polarity). The correct polarity is shown inside the battery compartment.

Put the battery compartment cover back in place on the battery compartment and turn it clockwise to tighten it (see Fig. B).

- Installing the light

Pull off the protective film from the self-adhesive pad 4 of the battery compartment cover 3 (see Fig. C).

• Attach the light in the desired location.

Note: The substrate should be dry, smooth and free of dust and grease.

Note: For the first 24 hours after installation do not remove the self-adhesive pad. Otherwise the self-adhesive pad will lose its ability to stick.

To help protect the environment, please dispose of the product properly when it has reached the end of its useful life and not in the household waste. Information on collection points and their opening hours can be obtained from your local authority.

- Switching On/Off

Press the light in the middle to switch it on or off.

- Cleaning and care

Use a dry cloth to clean the light - never use petrol, solvents or cleaners that attack plastic.

Disposal

The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities.

Contact your local refuse disposal authority for more details of how to dispose of your worn-out product.

Defective or used batteries have to be recycled in line with Directive 2006/66/EC. Return batteries and/or the device via the recycling facilities provided.

Environmental damage through incorrect disposal of the rechargeable batteries!

Batteries may not be disposed of with the usual domestic waste. They may contain toxic heavy metals and are subject to hazardous waste treatment rules and regulations. The chemical symbols for heavy metals are as follows: Cd = cadmium, Hg = mercury, Pb = lead. That is why you should dispose of used rechargeable batteries at a local collection point.

EMC (€

LED-valaisin

Piles: 3 piles 1,5 V --- type AAA (fournies)

WAARSCHUWING! LEVENSGEVAARI!

EXPLOSIONSGEFAHR! Laden