Flight - Hair Dryers GHD - Free user manual and instructions

USER MANUAL Flight GHD

Not to be reproduceda hazard even when the ghd ight™ is switched o. For additional protection, the installation of a residual current device (RCD) with an operating current not exceeding 30mA is advisable when using this product. Please contact an electrician for further details. CAUTION: Never use the ghd ight

with wet hands, in, or near water, bathtubs, showers, basins or other receptacles containing water (or any other liquid). Always inspect your ghd ight™ before use, and do not use it if it is damaged. If the power cord or plug is damaged it must be replaced by Jemella Ltd, its service agent or similarly qualied persons in order to avoid a hazard. Jemella Ltd will replace the product free of charge only if it is within warranty. To reduce the risk of electrocution:1. Do not use if the cord is damaged.

2. Do not pull or strain the power cord and do not unplug by pulling on the cord, rather disconnect the ghd

ight by isolating the mains switch and then by removing the plug.3. Do not use an electrical extension lead in conjunction with the ghd ight.4. Do not use at temperatures below 5°C and above 35°C.

5. Hold the ghd ight by the handle; do not hold by the casing or concentrator nozzle, which can be hot.

6. Take care to avoid the hot surface of the ghd ight coming into direct contact with the skin, in particular

the eyes, ears, face and neck.

7. Never place the ghd ight on any heat sensitive surface or cover it whilst in or immediately after use.

IMPORTANT: This ghd ight is designed for 120/220-240V. Do not use with any power supplies other than that specied on the rating plate. important safety instructions Before attempting to use this ghd ight for the safety of both yourself and others, please read the safety precautions set out below carefully and follow them, without exception, at all times when using your ghd ight. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved, by a person responsible for their safety. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. When the ghd ight™ is used in a bathroom, unplug it after use since the proximity of water presents

ghd ight travel hairdryer safety instructions and manufacturer’s guarantee Not to be reproduced1. Do not use this product with a voltage inverter.

2. Always check that the voltage of your electricity supply matches the voltage

3. Your ghd product is a class II electrical appliance and should not be

4. Any error when connecting the ghd ight can cause irreparable harm,

not covered by the guarantee.

warning: keep away from water:

1. Do not store near water.

2. Do not immerse or put under running water,

even for cleaning purposes.

3. Do not reach for the appliance if it has fallen

4. Do not leave within the reach of children.

The ghd ight must be unplugged from the mains socket:

1. before cleaning and maintenance procedures.

2. if it is not working correctly.

3. as soon as you have nished using it.

4. if you leave the room, even momentarily.

The ghd ight is equipped with a heat-sensitive safety cut out device. In the event of overheating (for example if the rear grill is blocked), the dryer will stop automatically. Isolate the dryer from the mains supply and allow to cool before using again. If your ghd ight has broken or does not work correctly immediately stop using and contact ghd (Jemella Ltd), see contact details. Your ghd ight should only be repaired using specialist tools and by qualied experts at ghd.

warning: electricity

Failure to comply with these safety precautions may result in electric shock or other injuries!

variable voltage Your ghd ight is tted with a dual voltage selector (Fig.1). To use this feature simply insert a coin to switch the ghd ight to accept the required incoming voltage i.e. 120V or 240V. Note: Before using this product please ensure that you check that the voltage selector is set for the correct voltage and do not operate the voltage selector when the product is in use. If in doubt contact a qualied person. using your ghd ight

1. After washing your hair, towel-dry it thoroughly.

2. Do not allow excess water from your hair or any other source to contact the ghd ight.

3. For fast drying, use the ghd ight without the styling nozzle.

4. Note: The t of a cold nozzle could be tight, particularly when the dryer and nozzles are new.

5. Never cover the blower or intake opening.

6. Use the selector switch, to set the fan speed and the drying temperature:

7. When drying or styling, do not allow any of your hair to cover or come into contact with the air inlet grill

at the back of your dryer. Figure 1 Dual Voltage Selector = Off = Cool = Medium = High Not to be reproduced87

1. Always allow the ghd ight to cool down before storing away.

2. When the ghd ight has cooled down, fold the power cord in the same way as it was rst

delivered in its packaging. Do not wrap the supply cord around the ghd ight as this can strain the cord and cause premature supply cord failure. cleaning your ghd ight

1. To ensure that your ghd ight operates at the optimum eciency, always ensure that the rear

lter is kept clean by regularly cleaning it.

2. To do this rst unplug the ghd ight from the mains power supply. Take a soft brush and gently

remove any dust and hair from the lter.

3. Do not clean with abrasive or corrosive products.

failure to operate In the unlikely event that your ghd product does not operate correctly, check that the ghd product and mains power supply are switched on, and that power is available. For UK plugs, please ensure that the tted fuse is intact and functioning; if it is not, replace it with an identically rated British Standard Fuse. If in doubt or for further advice please visit the help section of ghdhair.com or contact an approved ghd stockist or contact ghd customer services for further advice. manufacturer’s guarantee The ghd ight is intended solely for drying and styling hair and should only be used for this purpose. It is designed for use in the home only and should not be used for professional purposes. All ghd products are individually tested before leaving the factory. However in the unlikely event of the product proving defective due to faulty workmanship or materials, then, at its sole discretion, ghd will replace the product at no charge with an identical or equivalent product within two years from the original date of purchase. A replacement product assumes the remaining guarantee of the original product or 180 days, whichever provides longer coverage for you. When a product is exchanged, any replacement item becomes your property and the replaced item becomes property of ghd. To claim under this guarantee please visit ‘ghdhair.com/returns’ and follow the onscreen instructions to complete your return*. Please ensure that you include a proof of purchase with any returned product. Therefore please ensure you keep your proof of purchase in a safe place. This guarantee only applies to genuine ghd products purchased through ghd approved stockists, and does not cover products repaired or serviced by anyone other than ghd personnel or ghd representatives. Note that this guarantee may be invalidated where serial numbers or identication have been erased, damaged or modied. This does not aect your statutory rights. *Neither Jemella Group Limited nor its subsidiaries provides replacement parts for any of its electrical units. If you do not have access to the internet please return your ghd electrical product to the closest ghd address as printed in this leaet or on the packaging, together with your proof of purchase. For customers in Australia and New Zealand, please phone your closest ghd oce on the number printed in this leaet. The guarantee does not include:

1. Damage caused by misuse, improper treatment or violent usage.

2. Damage caused by failure to comply with these instructions for use.

3. Damage caused by connecting this appliance to the incorrect voltage.

4. Damage caused by connecting accessories (e.g. nozzles, diusers etc.) supplied by other manufacturers.

5. Minor faults which do not signicantly aect the value of the dryer or its eective use.

6. Normal wear and tear.

Australia Only Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Not to be reproducedghd UK ghd UK: 0845 330 1133 ghd Republic of Ireland: +44 1924 423 400 ghd Returns Phase 3 (Chilton House) Sherwood Park Annesley Nottingham NG15 0DJ

ghd South Africa ghd South Africa: 086 010 9366 ghd South Africa PO Box 818 Gillitts

South Africa ghd Australia ghd Australia: 1300 443 424 ghd Australia PO Box 15516 City East Queensland 4002 Australia ghd New Zealand ghd New Zealand: 0800 880 209 ghd New Zealand Private Bag 211030 Laurence Stevens Drive Auckland 2154 New Zealand recycling and disposal Your ghd electrical product is classied as ‘electrical or electronic equipment’ and must not be disposed of with other household or commercial waste at the end of its working life. When you have no further use for your ghd product, please dispose of it according to your local authority’s recycling procedure. For more information contact your local authority. UK/EU only Your ghd electrical product should be disposed of in accordance with the WEEE directive (Waste Electrical and Electronic Equipment 2002/96/EC), which ensures that products are recycled using the best available methods and practices to minimise any potential damage to the environment. For more information, contact your local authority or the retailer from whom you purchased this product. product compliance All electrical products from Jemella Ltd are subjected to independent compliance testing by appointed government and EU approved bodies. Our products all comply with EN 60335-2-23 and carry the CE mark. Other approvals include South Africa, Australia and New Zealand.

warning: electricity

ghdhair.com™ ghd ight™ ghd og er et registrert varemerke som tilhører Jemella Group Limited. © Jemella Group Limited 2020. Designet i Cambridge, UK. Produsert i Kina. ghd ight 2.0 Not to be reproducedvalidate your guarantee For peace of mind styling with your new ghd product, register your guarantee today for: - Verication of the authenticity of your ghd product - Replacement should your ghd product fail within the guarantee period* - Exclusive oers and deals before anyone else - The latest news and trends rst Visit ghdhair.com/register or use your QR reader on your smartphone to validate. This does not aect your statutory rights. *conditions apply, see safety instructions.

Not to be reproduced