UH 171093 S - Basket AMICA - Free user manual and instructions

Product type	Wall-mounted kitchen hood
Brand	Amica
Model	UH 171093 S
Category	Extractor hood
Power supply	220-240 V ~ 50 Hz
Operating modes	Extraction (external exhaust) and recirculation (charcoal filter)
Fan speeds	3 adjustable speeds
Lighting	Independent, integrated
Grease filter	Aluminum, dishwasher-safe or hand washable
Charcoal filter	Active, not washable, replaceable (only in recirculation mode)
Grease filter cleaning frequency	At least once a month
Charcoal filter replacement frequency	Every 2 months (or more often depending on use)
Possible installation types	Wall-mounted, island (depending on model)
Exhaust duct diameter	120 or 150 mm
Maximum duct length	4-5 meters
Safety	Do not use without grease filter; do not flambé under the hood; respect mounting distances
Maintenance	Clean exterior with a damp cloth and mild detergent; do not use solvents or abrasives
Warranty	According to warranty card provided
Compliance	EU Directives: Low Voltage, EMC, ErP, RoHS

Frequently Asked Questions - UH 171093 S AMICA

How to install the hood correctly?

Before installation, make sure the wall can support the weight of the hood. Unroll and straighten the power cable. Respect the minimum height above the cooking surface: for an electric hob, follow the instructions in the manual; for a gas hob, refer to the stove instructions. Make sure the exhaust duct (if extraction mode) does not exceed 4-5 meters and use fixing clamps. Installation should be carried out by a qualified installer.

How to clean the aluminum grease filter?

The grease filter must be cleaned at least once a month. You can wash it in the dishwasher or by hand with a mild detergent or liquid soap. After several washes in the dishwasher, its color may change, but this does not affect its performance.

When should the charcoal filter be replaced?

The activated charcoal filter is used only in recirculation mode. It cannot be washed and must be replaced every 2 months, or more often with heavy use. It absorbs odors until saturation.

How to switch from extraction mode to recirculation mode?

To switch to recirculation mode, install a charcoal filter and remove the exhaust duct. On some models, a lever inside the hood must be toggled (see figure 8 in the manual). The filtered air is then returned to the room through side slots.

What mounting height to respect?

The mounting height above an electric hob is indicated in the product's technical specifications. If your gas stove specifies a greater distance, respect that. Generally, the recommended distance is about 65 to 75 cm for electric hobs and 75 to 85 cm for gas hobs (see figure 1 in the manual).

Can I use the hood without the grease filter?

No, it is strictly forbidden to use the hood without the aluminum grease filter installed. The filter prevents grease from entering the motor and reduces the risk of fire.

What to do if the hood does not turn on?

First check that the hood is properly plugged in and the bipolar switch is on. Make sure the power cable is not damaged. If the problem persists, contact customer service. Do not attempt to repair yourself.

How to adjust the fan speeds?

The hood has 3 speeds controlled by buttons (see figure 4). Speeds 1 and 2 are for normal use, speed 3 for heavy smoke (frying, grilling). Use the appropriate speed for quiet operation.

How to maintain the exterior of the hood?

Clean the exterior with a damp cloth and a mild detergent. Do not use solvents, alcohol, abrasive products or rough cloths, as they could damage painted surfaces or stainless steel.

How to dispose of the hood at the end of its life?

Do not dispose of the appliance with household waste. Cut the power cable and take it to a collection center for waste electrical and electronic equipment (WEEE). The crossed-out wheelie bin symbol on the appliance reminds you of this. This helps protect the environment.

USER MANUAL UH 171093 S AMICA

TACK FÖR ATT DU HAR KÖPT EN PRODUKT

BASTAKUND!

THANK YOU FOR PURCHASING AN AMICA APPLIANCE

DEAR CUSTOMER!

You are now a user of a kitchen extractor hood. This hood has been designed and manufactured speci
cally with a view to satisfying your expectations and it will certainly constitute a fitting element of a modern kitchen. The modern structural solutions and the newest technologies used in production of this hood guarantee its high effectiveness and good appearance. Please read these instructions carefully before installing the hood. They will help you avoid mistakes during installation and operation of the hood.

We wish you a lot of satisfaction from choosing our kitchen extractor hood.

Symbols appearing in these instructions have the following meaning:

Important information concerning proper operation of the appliance and your personal safety.

Risks resulting from improper operation of the appliance. Activities that must be performed by a qualified technician.

Tips on how to use the appliance.

Information on how to protect the environment.

This indicates actions than must not be performed by the user.

TABLE OF CONTENTS

GUIDELINES CONCERNING THE SAFETY OF USE 31

INSTALLATION 35

fore using the appliance, please carefully read this manual!

The appliance is intended for household use only.

The manufacturer reserves the right to introduce changes which do not affect the operation of the appliance.

The manufacturer will accept no responsibility for any damage due to installation or operation not conforming to these instructionsi

Cooker hood is designed to remove cooking odours. Do not use cooker hood for other purposes.

• Connect the cooker hood operating in extraction mode to a suitable ventilation duct (do NOT connect the cooker to smoke or flue gas ducts, which are in use). It requires installation of the air extraction duct to the outside. The duct length (typically 120 or 150mm in diameter) should not exceed 4 - 5m . The air exhaust duct is also required for telescopic and under furniture cooker hoods operating in air recirculation mode.

Cooker hood operating in air recirculation mode requires the installation of an activated charcoal filter. In this case, installing an extractor duct is not required, however it is recommended to install an air guide vane. (chimney cooker hoods only).

The cooker hood features independent lighting and exhaust fan that can be operated at one of several speeds.
Depending on the type, the hood is designed to be permanently attached to a vertical wall over a gas or electric stove (chimney and universal hoods); on the ceiling over a gas or electric stove (island hoods); on the vertical built in furniture over a gas or electric stove (telescopic and built-in hoods). Before installing, make sure that the wall/ceiling structure is strong enough to suspend the hood. Some hoods are very heavy.

• For details of the installation distance above an electric hob please refer to product technical sheet If the installation instructions of the gas cooker specify a greater distance, this must be taken into account (Fig. 1a/b/c).

• Do not leave an open flame under the hood. When the pots are removed from the burner, set the minimum flame. Always make sure that the flame does not extend outside the pot, because it causes unwanted loss of energy and a dangerous concentration of heat.

• Any food cooked in fat shall be constantly monitored, since overheated fat can ignite very easily.

• Pull the plug of the power cord from a wall socket before any filter cleaning or repair operation.

The textile grease filter should be replaced, and the aluminium filters should be cleaned at least every one month in connection with the existing fire danger (saturated fat is very flammable).

• If any other non-electric devices are used in the same room as the hood (e.g. liquid fuel ovens, flow-through or volumetric water heaters), it is necessary to provide appropriate ventilation (air supply). Safe operation is possible when during simultaneous operation of the hood and combustion devices dependent on air supply the negative pressure of not more than 0.004 milibar is maintained at the location of these devices inside the room (this point does not apply when the hood is used as an odour absorber).

Do not abut against the hood

The hood should be frequently cleaned inside and on the outside surfaces (at least once a month). See "Cleaning section" in this manual.

• If the power wire gets broken, it should be replaced with a new one in a specialist repair shop.

Make sure the appliance can be easily disconnected from the mains, either by pulling the plug out of the mains socket, or by switching the two-pole switch off.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

• Check if the voltage indicated on the rating plate corresponds to the local power supply parameters.
  Before installing unwind and straighten the power cord.
• Warning! The packaging materials (polyethylene bags, small pieces of foamed polystyrene etc.) should be kept away from children while unpacking.
  NOTE: Before connecting the hood to the mains power supply always check that the power cord is properly installed and is not trapped by the appliance. It is recommended to make sure the hood operates correctly before installation.
• Never use the hood without effectively mounted grating!
  The flaming of foods beneath the hood itself is severely prohibited.
• With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities.

WARNING! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazardsii

Installation

Step-by-step appliance installation is shown on Fig. 3...

Setting the air extractor mode of operation of the hood

In the extractor mode air is discharged to the outside by a special conduit. In that setting any carbon filters shall be removed. The hood should be connected to the opening discharging air to the outside by means of a rigid or flexible conduit of 120mm diameter, which should be purchased in a shop selling installation materials.

A qualified installer should be commissioned to make the connection.

Setting the odour absorber mode of operation of the hood

In this option filtered air returns to the room through openings in the front of the hood. In this setting it is necessary to install the carbon filter. It is recommended to install the air guide (availability depending on model).

In some universal hoods you need to switch lever inside the hood (Fig. 8) to switch between the extraction and air recirculation modes. The cleaned air is returned to the room through the holes in the top of the unit.

Furniture and telescopic cooker hoods operating in air recirculation mode require installation of the exhaust duct. The other end of the duct should be directed to the room as it will discharge filtered air.

Fan speeds

The lowest and medium speeds should be used under normal conditions and with low concentration of fumes. The maximum speed should be used in case of high concentration of kitchen fumes, e.g. during frying or grilling.

Use control panel to control your cooker hood (Fig. 4)

0 - Appliance on/off

Medium speed
High speed
- Lighting turn on / turn off

Regular maintenance and cleaning of the device will ensure faultless operation, and help extend the life of the unit. Attention should be paid to replacing grease and carbon filters according to instructions.

Aluminium grease filter

Cleaning

For normal hood operation, aluminium grease filter should be cleaned every month in the dishwasher or by hand using a mild detergent or liquid soap.

To replace:

Dismantling of aluminium grease filter is shown on Figure 5.

Acrylic filter is used in some models. This filter should be replaced at least once every two months or more frequently if the appliance is used intensively.

Charcoal filter (only the recirculation version)

Operation - Carbon filters can be used only when the hood is not connected to any ventilation duct. Filters with active carbon can absorb odours until they are saturated. They cannot be washed or regenerated and should be replaced at least every 2 months or more frequently in case of very intensive use.

Replace:

Dismantling of charcoal filter is shown on Figure 6.

Lighting

See Figure 7 for details how to replace lights. Use incandescent / halogen / LED modules of the same specification as those factory-installed in the appliance.

Cleaning

Normal hood cleaning:

• Do not use a soaked cloth, sponge, or water jet.
• Do not use solvents or alcohol, as they may tarnish lacquered surfaces.
• Do not use caustic substances, especially for cleaning stainless steel.
• Do not use a rough or abrasive cloth.

It is recommend to use a damp cloth and a neutral detergent.

Aluminium filters may be washed in the dishwasher. The colour of aluminium filters may change after several washings. This is normal and it is not necessary to renew the filters.

Recycling of the packaging

Our packaging is made of environmentally friendly materials, which can be reused:

The external packaging is made of cardboard/foil
The FCKW free shape of foamed polystyrene (PS)
Polyethylene (PE) foils and bags

ELIMINATION / DISPOSAL OF THE EU-IPMENT

If the appliance is no longer in use, cut the connecting cable off the used equipment before scrapping. We also recommend that the appliance is locked or render it useless so that the appliance presents no

danger to children while being stored for disposal. This appliance is marked with a symbol of the crossed out waste container in conformance with the European Directive 2002/96/EC. Such marking informs that the equipment may not be kept together with other waste coming from the household after the period of its use. The user is obliged to dispose of the appliance at the waste collection point authorised by the local authority. The local waste collection points, shops and communal units form an appropriate system enabling the disposal of the equipment.

Handling the used electrical and electronic equipment and any hazardous substances contained therein in a correct manner is vital to avoid damage the local natural environment. Therefore care and responsibility should always be taken in the disposal of these products

WARRANTY AND AFTER-SALE SERVICES

Warranty

Warranty service as stated on the warranty card

The manufacturer shall not be held liable for any damage caused by improper use of the product.

Manufacturer's Declaration

The manufacturer hereby declares that this product meets the requirements of the following European directives:

Low Voltage Directive 2014/35/EC
- Electromagnetic Compatibility (EMC) Directive 2014/30/EC
ErP Directive 2009/125/EC
- Directive RoHS 2011/65/EC

and has thus been marked with the symbol and been issued with a declaration of compliance made available to market regulators.