Q: How to configure the AMICA OSC6231I hood to operate in extraction mode?

The AMICA OSC6231I hood is a universal model capable of operating in extraction mode (expelling air outside) or in recirculation mode. To switch to extraction mode, you need to perform a manual physical configuration . Steps to convert to extraction mode: Remove the charcoal filter - If a charcoal filter is installed, it must be removed (the charcoal filter is used exclusively in recirculation mode) Install the extraction duct - Connect an air duct with a diameter of 150 mm or 120 mm (depending on your installation) to the extraction opening of the hood Vent the air outside - The duct must be directed outside the building: through a wall, out a window, or through the roof Important: There is no electronic switch to toggle between modes. The extraction/recirculation mode conversion requires physical access inside the hood and handling of filters and ducts. Detailed instructions with assembly diagrams for both configurations are available in figure 8 of the installation manual provided with your device.

Question 1

What are the dimensions of the grease filter for this hood?

Accepted Answer

The manual for the AMICA KHF 665 651 S hood does not specify the exact dimensions (length x width x thickness) of the metal grease filter alone.

However, here is what we know about this model:

Grease filter: Metal and washable
Hood dimensions: 60 cm wide x 50 cm deep x 60 cm minimum height
Air outlet diameter: 150 mm

To find out the precise dimensions of the replacement filter or to order a spare part, contact AMICA customer service or consult an authorized dealer with the model reference (KHF 665 651 S). The filter should generally match the capture area of the hood, which is approximately 60 cm wide for this model.

Maintenance: Monthly cleaning of the grease filter is recommended to maintain good extraction performance.

Question 2

Which charcoal filter to use for the AMICA OWC9751TB HC?

Accepted Answer

For the AMICA OWC9751TB HC model, a charcoal filter is included in the delivery. It is a non-reusable filter that must not be washed.

Replacement frequency: The filter should be replaced approximately every 3 to 6 months, depending on the intensity of use of your hood.

How to obtain a replacement filter: The manual does not contain a specific item number. Please contact an authorized AMICA after-sales service or the manufacturer directly, providing the reference OWC9751TB HC to obtain the appropriate replacement filter.

Question 3

How to replace the lamp (bulb) of the AMICA KH 17129-3 E extractor hood?

Accepted Answer

The official manual for the AMICA KH 17129-3 E extractor hood does not contain specific instructions for replacing the bulb or LEDs.

However, here is what we know about the lighting of this device:

The hood is equipped with an independent adjustable LED lighting
The "L" button allows you to turn the lighting on and off
A long press on this same button adjusts the brightness

As the exact replacement procedure is not documented in the manual, it is recommended to contact AMICA customer service directly to obtain precise instructions and know the appropriate replacement part type. This will ensure that you do not damage the device.

Question 4

How to configure the AMICA OSC6231I hood to operate in extraction mode?

Accepted Answer

The AMICA OSC6231I hood is a universal model capable of operating in extraction mode (expelling air outside) or in recirculation mode. To switch to extraction mode, you need to perform a manual physical configuration.

Steps to convert to extraction mode:

Remove the charcoal filter - If a charcoal filter is installed, it must be removed (the charcoal filter is used exclusively in recirculation mode)
Install the extraction duct - Connect an air duct with a diameter of 150 mm or 120 mm (depending on your installation) to the extraction opening of the hood
Vent the air outside - The duct must be directed outside the building: through a wall, out a window, or through the roof

Important: There is no electronic switch to toggle between modes. The extraction/recirculation mode conversion requires physical access inside the hood and handling of filters and ducts.

Detailed instructions with assembly diagrams for both configurations are available in figure 8 of the installation manual provided with your device.

User manual AMICA Range hood : user manuals and guides in PDF

Models AMICA Range hood most viewed

Other categories AMICA

Recent questions about Range hood AMICA