Hypernova CKHN3344 - Watch Christiaan van der Klaauw - Free user manual and instructions

USER MANUAL Hypernova CKHN3344 Christiaan van der Klaauw

H G DCongratulations with your purchase of a Christiaan van der Klaauw Astronomical Watch. Christiaan van der Klaauw has been making superb watches - unique, exclusive and innovative - for more than 40 years. All these watches are made by hand by passionate watchmakers, with a central theme that appeals strongly to the imagination: astronomy. is is a logical relationship for Christiaan van der Klaauw - after all, time has always been determined on the basis of astronomical values. So we can justiably state in connection with our watches: Astronomy, time in its purest form. Your wristwatch is tted with an automatic movement. When you wear your watch, the movements of your wrist are automatically converted into the energy required to operate your watch. You can also wind the watch by hand. If you do not wear the watch, we advise you to place it in a watch winder. Turn clockwise. Exposing our watches to water is not recommended. Your watch may be damaged if you wear it while swimming or in the shower. Christiaan van der Klaauw Astro- nomical Watches are tted with a strap made of alligator leather. is strap can be replaced. Contact an ocial dealer of Christiaan van der Klaauw Astronomical Watches if a replacement is required. ENGLISH

WELCOME TO THE WORLD OF

CHRISTIAAN VAN DER KLAAUW ASTRONOMICAL WATCHESSpecications e following information is displayed on the Hypernova:

hours with luminova;

minutes with luminova;

seconds and a day/night indicator;

date (day of the week + month);

recorder, 30 minutes;

start and stop pusher;

reset pusher. Adjustment e settings of your watch can be adjusted by using the dierent positions of the crown and the push button

e crown has three positions:

this is the position of the crown when you are wearing the watch. In this position, you can wind the watch by hand.

setting the date and the moon phase.

setting the time. To adjust the settings of the Hypernova, pull out the crown to position

. You can now set the time to 12:00. Caution: do not do this at 24:00. en push the crown in by one position

to set the date and month by turning the crown counterclockwise. Set the moon phase by turning the crown clockwise. Important Always set the moon phase to the previous day. Once this is the case, use the enclosed accessory to push in the push button

located at the 10 o’clock position on the left-hand side of the watchcase to set the day. Set this to the previous day as well. When the correct month is shown in the window and the day, date and moon phase are set to the previous day, then pull out the crown to position

, and then turn the hands clockwise until everything is set to today. When the hands also show the right time, then push the crown in again completely. ENGLISHENGLISHFunctionalities

A second hand and a day/night indicator are located at the 9 o’clock position.

e day and month are displayed at the 12 o’clock position.

e hand with the arrow at the end points to the calendarday of the month.

e moon phases are shown at the 6 o’clock position. When the moon picture is shown left of the centre, the Moon is in the rst quarter. When the image is in the middle, it is full moon, and when it is on the right, the Moon is in the last quarter. If the image is not visible, then it is new moon. Chronograph e chronograph function is located at the 6 o’clock position (hours)

and the 12 o’clock position (minutes)

. e hand shows the number of seconds

e chronograph start and stop pusher

is above the crown at the 2 o’clock position. e reset button