5in1 EP7500 - Electric epilator REMINGTON - Free user manual and instructions

Features	Details
Device type	5-in-1 epilator
Included accessories	5 interchangeable heads
Functions	Epilating, shaving, trimming, facial cleansing, sensitive area hair removal
Power supply	Mains powered
Usage	Suitable for use on body and face
Maintenance	Washable accessories for easy cleaning
Safety	Use only on dry and clean skin
Weight	Lightweight and easy to handle
Dimensions	Compact for easy storage
Warranty	Check warranty conditions with the seller

Frequently Asked Questions - 5in1 EP7500 REMINGTON

How do I use the REMINGTON 5in1 EP7500?

To use the REMINGTON 5in1 EP7500, start by selecting the desired accessory, then turn on the device by pressing the power button. Move it gently over the area to be treated, following the specific instructions for each accessory.

How do I clean the REMINGTON 5in1 EP7500?

To clean your REMINGTON 5in1 EP7500, unplug the device and remove the used accessory. Rinse the accessory with lukewarm water and use a soft brush to remove hairs or residue. Do not immerse the device in water.

What is the battery life of the REMINGTON 5in1 EP7500?

The battery of the REMINGTON 5in1 EP7500 can last up to 40 minutes of continuous use after a full charge, depending on the mode of use.

How do I charge the REMINGTON 5in1 EP7500?

To charge the REMINGTON 5in1 EP7500, plug the supplied charger into a power outlet and connect it to the device. A light indicator will turn on to show that the device is charging.

What should I do if the REMINGTON 5in1 EP7500 does not work?

If your REMINGTON 5in1 EP7500 does not work, first check that the device is properly charged. If the problem persists, make sure the accessory is securely attached. If the device still does not turn on, contact customer service.

Are the accessories of the REMINGTON 5in1 EP7500 washable?

Yes, most accessories of the REMINGTON 5in1 EP7500 are washable with water, but be sure to consult the instruction manual for specific recommendations regarding each accessory.

How do I change the accessories of the REMINGTON 5in1 EP7500?

To change the accessories, turn off the device and gently pull off the accessory. Then insert the new accessory, making sure it is securely attached before turning the device back on.

Can the REMINGTON 5in1 EP7500 be used on sensitive skin?

Yes, the REMINGTON 5in1 EP7500 is designed for use on sensitive skin. However, it is recommended to perform a test on a small skin area before extensive use to avoid irritation.

USER MANUAL 5in1 EP7500 REMINGTON

ENGLISH Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use. IMPORTANT SAFEGUARDS

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.

• WARNING: Keep the appliance dry.

• Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres.

• Do not use the appliance if it is damaged or malfunctions.

• Do not use attachments other than those we supply.

• Do not leave the appliance unattended while plugged in.

• Keep the power plug and cord away from heated surfaces.

• Make sure the power plug and cord do not get wet.

• Do not plug or unplug the appliance with wet hands.

• Do not twist or kink the cable, or wrap it round the appliance.

• This appliance is not intended for commercial or salon use. PARTS

3. Removable and washable head

5. On/O Switch – 2 Speeds

The rotating tweezers catch even short hairs and pull them out by the root. The hairs that grow back are soft and thin. Epilating leaves your skin smooth and hair-free for several weeks. If you have not used an epilator before, or if you have not epilated for a long period of time, it may take a short while for your skin to adapt to epilation. The discomfort experienced at rst is considerably reduced with repeated use as the skin adjusts to the process. Using an epilator may cause reddening or irritation of the skin. This is a normal reaction that will quickly disappear. However, you should consult your doctor if the irritation has not disappeared within three days. All methods of hair removal from the root can result in in-growing hair depending on the condition of the skin and hair. Regular exfoliation helps to prevent in-growing hair. In some cases inammation of the skin could occur when bacteria penetrate the skin (e.g. when moving the appliance over the skin). Thorough cleaning of the epilation head before each use will minimise the risk of infection.

• When using an epilator for the rst time it is best to try it on a small area to get used to the process of epilation.

• The optimum length for hair removal is between 2-5mm. Epilation is easier and more comfortable.

• Take a warm bath or shower before epilating and exfoliate to remove dead skin cells.

• This will make your skin more pliable, making the epilation process less uncomfortable.

• Epilate in the evening so that any possible reddening can disappear overnight.

• After use you can use a body cream or aloe lotion to soothe the skin and reduce skin irritation.

• Exfoliate regularly to avoid in-growing hair EXFOLIATE

• Exfoliation prevents in-growing hairs. Ingrown hairs occur when the growing hair curls up under the skin instead of growing out like it should. It results in an often painful red bump and possible infection. Rubbing your skin with an exfoliation glove in the shower or bath, or using a dry body brush will help reduce ingrown hairs or infections.

• Before epilating ensure the skin is clean, dry and free from creams or oils.

• Rub the skin in the area to be epilated to lift short hairs to optimise hair removal.

• Ensure the Epilator is OFF and attach the power cord to the product and then to the mains. ENGLISH5 ENGLISH

1. Turn the epilator on to the desired speed:

• LOW is recommended for ne hair

• HIGH is recommended for coarse hair or stronger hair growth

2. Using your free hand, hold the skin taut to make the hairs stand upright.

3. Position the epilator at so that the tweezers are at a 90° angle and at against the skin.

The Ultimate Contour Cap will ensure the optimum tweezing angle (Figure A).

4. Using small circular motions, slowly and gently glide the epilator over the skin. This

circular motion is the most eective method and makes the process less uncomfortable (Figure B).

5. Alternatively, guide the epilator in a slow, continuous movement against the hair

6. Repeat within each area until all unwanted hair is removed.

Epilate from the lower arm/leg and slowly move upwards. To epilate behind the elbow/ knee, keep the arm/leg straight to stretch the skin (Figure C)

Please be aware that these areas are particularly sensitive. However this sensitivity will reduce after repeated usage. For more comfort, ensure that the skin is held taut and that the hair is at the optimum length of 2-5mm. If it has been an extended period of time since you have removed hair, trim the hair with a Remington® bikini trimmer or cosmetic trimmer before epilation (Figure D and E)

It is recommended to use LOW speed or Detail cap for these sensitive areas. FACIAL EPILATION

• Place epilator at a 90° angle to the skin and move the epilator head in a circular motion.

• NOTE: Do not use for removing hair from the eyebrow.

• Keep the product away from hair on the scalp, eyebrows and eyelashes. PRECISION LIGHT

• The built in precision light helps you to see every hair. DETAIL CAP

• The detail cap is designed for small areas (including the face) and spot treatments.

• Ensure the epilator is switched o.

• Remove the Ultimate Contour or Massage Cap.

• Place the Detail Cap into the appropriate slots at the top of the epilator.

• Gently press the Detail Cap into place until you hear a “click”.

• The Massage Cap is designed for gentler epilation.

• Ensure the epilator is switched o.

• Remove the Ultimate Contour or Detail Cap.

• Place the Massage Cap into the appropriate slots at the top of the epilator.

• Gently press the Massage Cap into place until you hear a “click”. SHAVER HEAD

• The shaver head provides a close shave for sensitive areas.

• Ensure the epilator is switched o.

• Press the head release button and remove the epilator head.

• Attach the shaver head until it clicks into place.

• Hold the shaver head at a 90° angle to the skin and move against the direction of hair growth.

TRIMMING AND SHAPING

1. Attach the bikini comb to the shaver head.

2. Hold the shaver at a right angle to your skin and press down gently.

3. Edge and shape the areas as desired.

• For your protection your epilator may slow down or even stop if pressed too rmly against the skin.

• Do not use the epilating head on irritated skin or skin with varicose veins, rashes, spots, moles or wounds without consulting a doctor. People with reduced immune response e.g. during pregnancy, or people who suer from diabetes mellitus, haemophilia or immunodeciency should also consult their doctor before using this product.

• For hygiene reasons do not let another person use your epilator. It is recommended for use by one person only.

CLEANING AND MAINTENANCE

To ensure long lasting performance of your epilator, clean the head assembly regularly. Cleaning the epilation head after each use:

• Ensure the epilator is turned o and disconnected from the mains.

• Press the head release button and open the head assembly (Figure F).

• Turn the head assembly upside down.

• The epilator head can be removed and rinsed for cleaning. For optimal cleaning; brush hairs from the tweezers before rinsing (Figure G). NOTE: Do not completely submerge in water. The epilator head can be submerged after it has been removed from the epilator body. ENGLISH7 ENGLISH TO REMOVE RESIDUE:

• To remove residue from the stainless steel tweezers, dampen a swab with alcohol.

• Gently run the swab over the tweezers until the residue has been removed.

• CAUTION: Make sure that the cotton swab is not soaked in alcohol as this may damage the epilator. CLEANING THE SHAVER HEAD AFTER EACH USE:

• Ensure the epilator is turned o and disconnected from the mains.

• Press the head release button and remove the shaving head.

• Remove the blade and trimmer assembly by placing your ngers either side of the assembly and pulling upwards.

• Gently shake the blade and trimmer assembly to remove the hair. Use the cleaning brush to brush the trimmers and shaver housing.

• Replace the blade and trimmer assembly. NOTE: Never use the cleaning brush on the foil as damage may occur. RECYCLING

To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate ocial recycling/ collection point.

PER RIMUOVERE I RESIDUI