WG629.9 - Pressure washer WORX - Free user manual and instructions

USER MANUAL WG629.9 WORX

1. PRESSURE SETTING SWITCH

2. LOCK-OFF SWITCH

3. BATTERY PACK RELEASE BUTTON

4. BATTERY PACK*

5. ON/OFF SWITCH LEVER

6. HOSE ADAPTOR

7. POWER NOZZLE

8. EXTENSION LANCE

9. SHORT LANCE

10. NOZZLE ADAPTOR

11. MULTI-SPRAY NOZZLE

12. HOSE CONNECTOR

13. HOSE FILTER

14. HOSE CLIP

15. HOSE

16. FLOATER

17. SOAP BOTTLE

18. BRUSH*

19. SQUEEGEE*

20. CARRY BAG*

21. Not all the accessories illustrated or described are included in standard delivery.

TECHNICAL DATA

	WG629	WG629.1	WG629.9
Charger voltage 120V~60Hz /
Voltage 20V	--- Max**
Pressure	High/Low (garden hose connected)
Long wand working mode	max 320psi / 175psi
Short wand working mode	max 94psi / 72psi
Max water flow rate	0.5gpm
Max. inlet water pressure	73psi (0.5MPa)
Suction height max	5ft.

Weight (with lance)

3.7lbs 2.8lbs

** Voltage measured without workload. Initial battery voltage reaches maximum of 20 volts. Nominal voltage is 18 volts.

ACCESSIONS

	WG629	WG629.1	WG629.9
Hose 20ft.(6m) 1 1
Short lance	1 1	1
Extension lance	1 1	1
Multi-Spray nozzle	1 1	1
Carry bag	1 1	1
Battery pack (WA3575)	1	1	/
Charger (WA3742)	1 1	/
Squeegee (WA4049)	/	1	/
Brush (WA4048)	/	1	/
Soap bottle (WA4036)	/	1	/

Only use the appropriate accessories intended for this tool. Accessory information can be found on the product packaging, at a WORX dealer or on our website at www.worx.com.

PRODUCT SAFETY

WARNING: Read all safety warnings and

all instructions. Failure to follow the warnings and instructions may result in c shock, fire and/or serious injury.

Save all warnings and instructions for future reference.

WARNING: This product may contain lead, phthalate or other chemicals known to the State of California to

cause cancer, birth defects and other reproductive harm. Wash your hands after use.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using this product basic precautions should always be followed, using the following:

1. Read all the instructions before using the product.
2. To reduce the risk of injury, close supervision is necessary when a product is used near children.
3. Know how to stop the product and bleed

pressures quickly. Be thoroughly familiar with the controls.

1. Stay alert - watch what you are doing.
2. Do not operate the product when fatigued or under the influence of alcohol or drugs.
3. Keep operating area clear of all persons
4. Do not overreach or stand on unstable support. Keep good footing and balance at all times.
5. Follow the maintenance instructions specified in the manual.
6. !WARNING - Risk of injection or injury- do not direct discharge stream at persons.
7. Do not spray electrical apparatus and wiring. SAVE THESE INSTRUCTIONS

GENERAL SAFETY WARNINGS FOR BATTERY PACK

1) WARNING: Risk of fire and burns. Do not disassemble, heat above 100^ (212^) , or incinerate. Do not expose cells or batteries to heat or fire. Avoid storage in direct sunlight.
2) Dispose of used battery promptly. When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other.
3) Keep battery out of reach of children and in original package until ready to use.
4) Never put batteries in mouth. If swallowed, contact your physician or local poison control center.
5) CAUTION - The battery used in this device may present a risk of fire or chemical burn if mistreated. Replace battery with WORX only. Use of another battery may present a risk of fire or explosion.
6) !WARNING: Do not use a visibly damaged battery pack or appliance as applicable.
7)WARNING: Do not modify or attempt to repair the appliance or the battery pack as applicable.
8) BATTERY MUST BE RECYCLED.
9) Do not short-circuit a cell or battery. Do not store cells or batteries haphazardly in a box or drawer where they may short-circuit each other or be short-circuited by conductive materials.
10) Do not subject cells or batteries to mechanical shock.
11) Keep cells and batteries clean and dry. Wipe the cell or battery terminals with a clean dry cloth if they become dirty.
12) Do not maintain secondary cells and batteries on charge when not in use.
13) Retain the original cell and battery literature for future reference.
14) Do not use any charger other than that

specifically provided for use with the equipment. Secondary cells and batteries need to be charged before use. Always use the correct charger and refer to the manufacturer's instructions or equipment manual for proper charging instructions.

15) When possible, remove the battery from the equipment when not in use.
16) Prevent unintentional starting. Ensure the switch is in the off-position before connecting to battery pack, picking up or carrying the appliance. Carrying the appliance with your finger on the switch or energizing appliance that have the switch on invites accidents.
17) Disconnect the battery pack from the appliance before making any adjustments, changing accessories, or storing appliance. Such preventive safety measures reduce the risk of starting the appliance accidentally.
18) Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.
19) Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.

SYMBOLS

To reduce the risk of injury, user must read instruction manual

Warning

Li-ON battery, battery must be recycled

Remove battery from the socket before carrying out any adjustment, servicing or maintenance.

call②recycle

POSITEC Inc. has established a partnership with the RBRC

Corporation to recycle any Positec batteries with the RBRC-call2recycle seal. For environmental protection, please do not discard batteries in the trash. After the batteries' life cycle is ended, then please call 1-800-822-8837 for a free service that will properly dispose of the battery.

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.

ACTION FIGURE
BEFORE OPERATION
Installing the battery pack See Fig. A1
Removing the battery pack See Fig. A2
Charging the battery pack More details can be found in WA3742's manual	See Fig. A3
ASSEMBLY
NOTE: The power nozzle has two working modes: short lance only and short lance used together with extension lance. Working mode 1 Attaching short lance to the power nozzle NOTE: When attaching, align the two projections on the lance with the grooves of the power nozzle as shown in Fig. B. NOTE: In this working mode, the highest pressure is 94psi. it is suitable for light duty cleaning and watering.	See Fig. B
Attaching the Multi-spray nozzle NOTE: When attaching, rotating the nozzle left and right to make sure the nozzle fully seated into position and gently pulling it to make sure it is locked into position securely.	See Fig. C

Working mode 2 Attaching extension lance to the power nozzle Attaching short lance to the extension lance NOTE: When attaching, align the two projections on the lance with the grooves of the power nozzle as shown in Fig. D, E. NOTE: In this working mode, the highest pressure is 320psi. it is suitable for removing strong stains.	See Fig. D, E
Attaching the hose to the power nozzle NOTE: After the hose is attached, check the connection by gently pulling upon the hose. It should not be pulled off.	See Fig. F1, F2
Attaching your own water hose (optional) 1. Remove the hose adaptor 2. Attach the home garden hose with suitable connectors NOTE: Except for the hose supplied, you can also connect the power nozzle to your own water hose with suitable connectors. NOTE: When retightening the quick hose adapter, please tighten securely. Otherwise, it may not draw any water for proper operation.	See Fig. G1, G2
OPERATION
Pressure setting Your power nozzle has two pressure modes.	See Fig. H
Start NOTE: At the first use, you need to empty the air in hose, place the power nozzle below waist level (<5ft/1.5m), then attach the extension lance and set it at high pressure. Do not start working until the water goes up along the hose and sprays out. This could take up to 30 seconds or more depending on the fresh water source.	See Fig. I
Selecting the nozzle pattern NOTE: Choose a suitable nozzle pattern according to your work. Spray patterns 0°, 15°, 25° and 40° are applicable for cleaning, and the spray pattern with the symbol is best suitable for watering. WARNING: Do not shift the nozzle pattern when the tool is powered on.	See Fig. J
Cleaning (Working mode 2) WARNING: Do not connect the machine to water supply which is turbid, muddy or corrosive. NOTE: Not recommended for use with salt water, immediately rinse with fresh water for proper maintenance.	See Fig. K, L
Watering (Working mode 1) See Fig. M

ATTACHMENT OF ACCESSORIES

A number of accessories have been supplied with this product and are required for use in different applications. Do not attempt to use cleaning without a lance or any accessories attached.

1. Soap bottle (WG629.1 only)

Soap bottle provides detergent suds for deeper cleaning of dirt. It is used in conjunction with power nozzle or extension lance. (See Fig. N1, N2)

2. Brush (WG629.1 only)

Brush is for cleaning cars, boats, motorcycles etc. It is used in conjunction with power nozzle or extension lance. (See Fig. O1, O2)

3. Squeegee (WG629.1 only)

After cleaning the surface with the power nozzle, then the squeezegee is best used to provide a streak clean surface on glass. (See Fig. P)

MAINTENANCE

Remove the Battery Pack from the tool before carrying out any adjustment, servicing or maintenance.

Inspect the product for damaged or worn parts before each use. Do not operate it if you find damaged or worn parts. Contact your supplier or the manufacturer for replacement parts.

Hose filter maintenance

Remove the hose filter from the hose and get out the strainer. Rinse the parts with clean water before reassembling. (See Fig. Q1, Q2)

CLEANING/STORAGE

Before Storage, completely drain all the water from the machine and hose.

Clean the moulded plastic housing of the machine using a soft brush and clean cloth. Do not use water, solvents or polishes. Store in a secure and dry place out of the reach of children. Do not place other objects on the product.

Store the machine and the accessories in a frost free place.

1. INTERRUPEUR DE RÉGLAGE DE

PRESSION

2. BOUTON DE VERROUILLAGE

3. CRAN DE DÉGAGEMENT DU BLOC-PILES

4. BLOC-PILES *

5. LEVIER INTERRUPEUR MARCHE/ARRÊT

6. ADAPTATEUR TUYAU

7. BUSE DE PRESSION

8. LANCE D'EXTENSION

9. LANCE COURTE

10. ADAPTATEUR DE BUSE

11. BUSE MULTI TYPES DE PULVÉRISATION

12. CONNECTEUR DE TUYAU

13. FILTER DU TUYAU

14. CLIP DE FIXATION DU TUYAU

15. TUYAU

16. FLOTTEUR

17. Bouteille DE SAVON*

18. BROSSE*

19. RACLETTE*

20. SAC DE TRANSPORT*

Copyright © 2016, Positec. All Rights Reserved.