CSE10KB4EA - Air Conditioning PANASONIC - Free user manual and instructions

USER MANUAL CSE10KB4EA PANASONIC

Multi Split Outdoor Unit Multi Split Outdoor Unit

© Panasonic HA Air-Conditioning (M) Sdn. Bhd. 2010. Unauthorized copying and distribution is a violation of law.2 SAFETY PRECAUTIONS To prevent personal injury, injury to others, or property damage, please comply with the following. Incorrect operation due to failure to follow instructions below may cause harm or damage, the seriousness of which is classifi ed as below: WARNING WARNING This sign warns of death or serious injury. CAUTION CAUTION This sign warns of injury or damage to property. The instructions to be followed are classifi ed by the following symbols: This symbol denotes an action that is PROHIBITED. These symbols denote an actions that is COMPULSORY. WARNING WARNING

INDOOR UNIT AND OUTDOOR UNIT

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Please consult authorized dealer or specialist to repair, install, remove and reinstall the unit. Improper installation and handling will cause leakage, electric shock or fi re. Do not install the unit in a potentially explosive or fl ammable atmosphere. Failure to do so could result in fi re. Do not insert your fi ngers or other objects into the air conditioner indoor or outdoor unit, rotating parts may cause injury. Do not touch the outdoor unit during lightning, it may cause electric shock. REMOTE CONTROL Do not allow infants and small children to play with the remote control to prevent them from accidentally swallowing the batteries. Thank you for purchasing Panasonic Air Conditioner

SAFETY PRECAUTIONS 2~3

REMOTE CONTROL 6~7 TROUBLESHOOTING 8~9 INFORMATION 42~43 QUICK GUIDE BACK COVER NOTE NOTE The illustrations in this manual are for explanation purposes only and may differ from the actual unit. It is subjected to change without notice for future improvement.ENGLISH

Do not wash the indoor unit with water, benzene, thinner or scouring powder. Do not use for other purpose such as preservation of food. Do not use any combustible equipment in front of the airfl ow outlet to avoid propagation fi re. Do not expose yourself directly to cold air for a long period. Do not sit or step on the unit, you may fall down accidentally. Do not touch the sharp aluminium fi n, sharp parts may cause injury. Do not switch ON the indoor unit when waxing the fl oor. After waxing, aerate the room properly before operating the unit. Do not install the unit in oily and smoky areas. Ensure drainage pipe is connected properly. Otherwise, leakage may occur. Aerate the room regularly. After long period of use, make sure the installation rack is not deteriorate to prevent the unit from falling down. REMOTE CONTROL Do not use rechargeable (Ni-Cd) batteries. It may damage the remote control. Remove the batteries if the unit is not going to be used for a long period of time. New batteries of the same type must be inserted following the polarity stated to prevent malfunction of the remote control. WARNING WARNING POWER SUPPLY Do not use modifi ed cord, joint cord, extension cord or unspecifi ed cord to prevent overheating and fi re. Do not share the same power outlet with other equipment to prevent overheating and fi re. Do not operate with wet hands to prevent electric shock. If the supply cord is damage, it must be replaced by the manufacturer, its service agent or similarly qualifi ed persons in order to avoid a hazard. It is strongly recommended to be installed with Earth Leakage Circuit Breaker (ELCB) or Residual Current Device (RCD) to prevent electric shock or fi re. This equipment must be earthed to prevent electrical shock or fi re. In case of emergency or abnormal conditions (burnt smell, etc), turn off the power supply, and please consult authorized dealer. Prevent electric shock by switching off the power supply when: - Before cleaning or servicing. - Extended non-use. - Abnormally strong lightning activity. Air Inlet Air Inlet Air Outlet Air Outlet Power Supply Outdoor Unit OPERATION CONDITION OPERATION CONDITION Use this air conditioner under the following temperature range CU-E10HBEA Temperature (°C) Indoor Outdoor

• This unit is still able to operate as a cooler with outdoor temperature as low as -10°C in a non-living room, such as a computer room, with a room temperature of 16°C or above, and room humidity up to 80%. When the outdoor temperature drops to -10°C, compressor will be cut off and resume operation again once the temperature rises to more than -10°C.

• When the outdoor temperature is out of the above temperature range, the heating capacity will drop signifi cantly and outdoor unit might stop for protection control.

• DBT: Dry bulb temperature

DEFINITION Multi air conditioner systems save space by letting you connect multiple indoor units to a single outdoor unit. OPERATION CONDITION OPERATION CONDITION Multi Split Outdoor Unit (CU-2E15LBE, CU-2E18LBE, CU-3E18LBE, CU-4E23LBE, CU-4E27CBPG) Temperature (°C) Indoor Outdoor Outdoor CU-2E15LBE, CU-2E18LBE,

• DBT: Dry bulb temperature

• WBT: Wet bulb temperature Room A Room A Living room Living room Outdoor Unit Outdoor Unit INDOOR UNIT INDOOR UNIT

• It is possible to operate the indoor units individually or simultaneously. The operation mode priority is given to the fi rst unit that turned on.

• During operation, heating and cooling mode could not be activated at the same time for different indoor unit. The power indicator blinks to indicate the indoor unit is standing by for different operation mode.ENGLISH

• Switch off the power supply before cleaning.

• Do not touch the aluminium fi n, sharp parts may cause injury. INDOOR UNIT CLEANING INSTRUCTIONS CLEANING INSTRUCTIONS HINT HINT

• Do not use benzene, thinner or scouring powder.

• Use only soap ( pH7) or neutral household detergent.

• Do not use water hotter than 40°C.

• To ensure optimal performance of the unit, cleaning maintenance has to be carried out at regular intervals. Please consult authorized dealer. CLOSE OPEN CLOSECLOSEOPEN CLOSE OPE

Slowly pull down Slowly pull down the intake grille. the intake grille.

Remove the air fi lter Remove the air fi lter from the tabs and pull it from the tabs and pull it downwards. downwards.

Press the knobs. Press the knobs. Remove Remove INDOOR UNIT Wipe the unit gently with a soft, dry cloth. AIR FILTER

• lt is recommended to clean the air fi lter every 6 weeks.

• Wash/rinse the fi lters gently with water to avoid damage to the fi lter surface.

• Dry the fi lters thoroughly under the shade, away from fi re or direct sunlight.6 REMOTE CONTROL Press the remote control’s button

Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly.

• Operating the unit within the recommended temperature could induce energy saving. HEAT mode : 20˚C ~ 24˚C. COOL mode : 26˚C ~ 28˚C. DRY mode : 1˚C ~ 2˚C lower than room temperature.

During operation mode selection the power indicator blinks.

• Unit selects operation mode every 10 minutes according to temperature setting and room temperature (For single Split System).

• Unit selects operation mode every 3 hours according to temperature setting, outdoor and room temperature (For Multi split system). HEAT mode - To enjoy warm air

• Unit takes a while to warm up. The power indicator blinks during this operation. COOL mode - To enjoy cool air

• Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode. DRY mode - To dehumidify the environment

• Unit operates at low fan speed to give a gentle cooling operation. Air fi lter Airfl ow direction louver Intake grille POWER (Green) TIMER (Orange) POWERFUL (Orange) QUIET (Orange) AUTO AIR SWING (Orange) Control Panel Remote Control Receiver Auto OFF/ON button

• Used when remote control is misplaced or a malfunction occurs. Step Action Mode 1 Press once. Automatic

Press and hold until you hear one beep, then release. Force cooling

Repeat step 2. Press and hold until you hear two beeps, then release. Normal cooling

Repeat step 3. Press and hold until you hear three beeps, then release. Force heating Press the button to turn off. CANCEL OFF TIMER

OFF CLOCK RESET SET TEMP AIR SWING OFF/ON QUIET AUTO MANUALCHECK

Transmitter Maximum distances: 8mENGLISH

• Can be activated in all modes and can be cancelled by pressing the respective button again.

• Cannot be selected at the same time.

• To turn ON or OFF the unit at a preset time.

Select ON or OFF timer Set the time Confi rm

• When ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time.

• Timer operation is based on the clock set in the remote control and repeats daily once set. For clock setting, please refer to Remote Control Preparation at back cover.

• If timer is cancelled manually or due to power failure, you can restore the previous setting (once power is resumed) by pressing SET

• For AUTO, the indoor fan speed is automatically adjusted according to the operation mode.

• The vertical airfl ow louver swings up and down automatically.

• In heat mode, the air blows horizontally for a while, then starts to blow downwards.

• The airfl ow direction can be adjusted as desired by using remote control.

• Do not adjust the vertical airfl ow direction louvers by hand.

• The air is discharge evenly through 4 output vents.

• Single Split System: This operation stops automatically after 20 minutes.

• Multi Split System: Press the button again or turn OFF the unit to stop this operation.

• This operation reduces airfl ow noise.

Press and hold for approximately 10 seconds to show temperature setting in °C or °F.

Press to restore the remote control’s default setting.8 TROUBLESHOOTING The following symptoms do not indicate malfunction. The following symptoms do not indicate malfunction. SYMPTOM SYMPTOM CAUSE CAUSE Mist emerges from indoor unit. ► • Condensation effect due to cooling process. Water fl owing sound during operation. ► • Refrigerant fl ow inside the unit. The room has a peculiar odour. ► • This may be due to damp smell emitted by the wall, carpet, furniture or clothing. Indoor fan stops occasionally during automatic fan speed setting. ► • This helps to remove the surrounding odours. Airfl ow continues even after operation has stopped. ► • Extraction of remaining heat from the indoor unit (maximum 30 seconds). Operation is delayed a few minutes after restart. ► • The delay is a protection to the unit’s compressor. Outdoor unit emits water/steam. ► • Condensation or evaporation occurs on pipes. Timer indicator is always on. ► • The timer setting repeats daily once set. Power indicator blinks during HEAT mode with no warm air supply (and louver is closed). ► • The unit is in defrost mode (and AIR SWING is set to AUTO). Indoor fan stops occasionally during heating operation. ► • To avoid unintended cooling effect. Power indicator blinks before the unit is switched on. ► • This is a preliminary step in preparation for the operation when the ON timer has been set. Cracking sound during operation. ► • Changes of temperature cause the expansion/ contraction of the unit. Check the following before calling for servicing. Check the following before calling for servicing. SYMPTOM SYMPTOM CHECK CHECK Heating/Cooling operation is not working effi ciently. ► • Set the temperature correctly.

• Close all doors and windows.

• Clean or replace the fi lters.

• Clear any obstruction at the air inlet and air outlet vents. Noisy during operation. ► • Check if the unit has been installed at an incline.

• Close the front panel properly. Remote control does not work. (Display is dim or transmission signal is weak.) ► • Insert the batteries correctly.

• Replace weak batteries. The unit does not work. ► • Check if the circuit breaker is tripped.

• Check if timers have been set. The unit does not receive the signal from the remote control. ► • Make sure the receiver not obstructed.

• Certain fl uorescent lights may interfere with signal transmitter. Please consult authorized dealer. Patrol sensor or e-ion indicator on the indoor unit is blinking. ► • Stop Patrol or e-ion operation then restart. If the patrol sensor or e-ion indicator still blinking, please consult authorized dealer.ENGLISH

OFF CLOCK RESET SET CHECK

Press for 5 seconds.

Press for 5 seconds to quit checking.

Press until you hear beep sound, then write down the error code. Note:

• For certain errors, you may restart the unit for limited operation with 4 beeps during operation starts.

Turn the unit off and reveal the error code to authorized dealer.

NON SERVICEABLE CRITERIAS

TURN OFF POWER SUPPLY then please consult authorized dealer under the following conditions:

• Abnormal noise during operation.

• Water/foreign particles have entered the remote control.

• Water leaks from Indoor unit.

• Circuit breaker switches off frequently.

• Power cord becomes unnaturally warm.

• Switches or buttons are not functioning properly.

FOR SEASONAL INSPECTION AFTER EXTENDED NON-USE

• Checking of remote control batteries.

• No obstruction at air inlet and air outlet vents.

• Use Auto OFF/ON button to select Cooling/Heating operation, after 15 minutes of operation, it is normal to have the following temperature difference between air inlet and air outlet vents: Cooling: ≥ 8°C Heating: ≥ 14°C

FOR EXTENDED NON-USE

• Activate Heat mode for 2~3 hours as an alternative to remove moisture left in the internal parts thoroughly to prevent mould growth.

• Turn off the power supply.

• Remove the remote control batteries.10

OFF CLOCK RESET SET TEMP AIR SWING OFF/ON QUIET AUTO MANUALCHECK

OFF CLOCK RESET SET TEMP AIR SWING OFF/ON QUIET AUTO MANUALCHECK

OFF CLOCK RESET SET CHECK

OFF CLOCK RESET SET TEMP AIR SWING OFF/ON QUIET AUTO MANUALCHECK

OFF CLOCK RESET SET CHECK

UNITÀ INTERNA E UNITÀ ESTERNA

UNITÀ INTERNA E UNITÀ ESTERNA

UNITÀ INTERNA E UNITÀ ESTERNA

UNITÀ INTERNA E UNITÀ ESTERNA

UNITÀ INTERNA CLOSE OPEN CLOSECLOSEOPEN CLOSE OPE

OFF CLOCK RESET SET TEMP AIR SWING OFF/ON QUIET AUTO MANUALCHECK

OFF CLOCK RESET SET CHECK

INFORMATIONEN/INFORMAZIONI Information for Users on Collection and Disposal of Old Equipment and Used Batteries

These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. Avis aux utilisateurs concernant la collecte et l’élimination des piles et des appareils électriques et électroniques usagés

OFF CLOCK RESET SET TEMP

SET CHECK CLOCK RESET