SKO 40 A1 - Earphones SILVERCREST - Free user manual and instructions

USER MANUAL SKO 40 A1 SILVERCREST

ID: SKO 40 A1_15_V1.2

Please observe the illustrations on the fold-out page.

(right/left), adjustable

Cable with 3.5 mm stereo TRS connectors

Thank you for your trust! Congratulations on your new headphones. For a safe handling of the device and in order to get to know the entire scope of features:

• Thoroughly read these operating instructions prior to ini- tial commissioning.

• Above all, observe the safety instructions!

• The device should only be used as described in these op- erating instructions.

• Keep these operating instructions for reference.

• If you pass the device on to someone else, please include these operating instructions. The operating instructions are a part of the product. We hope you enjoy your new headphones! __RU110635_B1.book Seite 39 Donnerstag, 7. Mai 2015 5:50 1740

This is a consumer electronics device. The headphones are intended for sound playback from audio devices at a normal listening volume. The device is designed for use in private households. This device must not be used for commercial purposes.

3. Safety information

Warnings If necessary, the following symbols and warnings will be used in these operating instructions: DANGER! High risk: failure to observe this warning may result in injury to life and limb. WARNING! Moderate risk: failure to observe this warning may result in injury or serious material damage. CAUTION: low risk: failure to observe this warning may result in minor injury or material damage. NOTE: circumstances and specifics that must be observed when handling the device. DANGER for children and people with disabilities

Packing materials are not children's toys. Children must not play with the packing material: there is a risk of suffocation.

This device is not designed to be used by people (including children) with limited physical, sensory or mental capabilities or people without adequate experience and/or understanding, unless they are supervised by someone responsible for their safety or are instructed by them on how to use the device.

Children must be supervised to ensure that they do not play with the device.

DANGER of accidents due to impaired perception

Surrounding noises may sound different than usual. Never use the headphones during activities when you must be attentively aware of your surroundings, particularly when operating machinery or vehicles in traffic. (This also applies to bicycles.) You must also comply with the legal provisions and regulations of the country in which you are using the device. DANGER of affecting cardiac pacemakers

The magnetic fields generated by the headphones may impair the func- tioning of cardiac pacemakers and implanted defibrillators. You must therefore maintain a minimum distance of 10 cm between the head- phones and the cardiac pacemaker / defibrillator. WARNING! Risk of hearing damage

Set a low volume on the audio device before you connect the head- phones to the sound source.

Avoid excessive volumes, particularly over extended periods or in the case of frequent use. Excessive volume can result in permanent hear- ing damage. WARNING! Risk of material damage

Protect the device against damage, e.g. from: - drips and splashes of water - heat, direct sunlight and open flames (e.g. candles) - impacts and similar violent effects

Protect the cable against damage, e.g. from: -sharp edges - hot places - clamping or crushing

Do not use any astringent or abrasive cleaning agents.

1 Set of headphones 1 Cable with 3.5 mm stereo TRS connectors|

1Operating instructions If the delivery is incomplete, the customer should contact the manufacturer.

• Check that the device is undamaged. Connecting

1. Set the sound source to a low volume.

2. Plug one of the cable's stereo TRS connectors|

the headphones and the other into the headphone socket of the sound source (e.g. MP3 player, telephone). Put on the headphones

1. Put on the headphones in such a way that the marking

2. Adjust the size of the headphones to your head size by moving the

two adjustable headphone earpieces|

3. Set the volume of the sound source. Make absolutely sure that you

are still able to hear the surrounding sounds. __RU110635_B1.book Seite 42 Donnerstag, 7. Mai 2015 5:50 1743

6. Cleaning / storing

WARNING! Risk of material damage!

Protect the device from water drops and water spray.

Do not use any astringent or abrasive cleaning agents.

• If necessary, clean the device with a soft, damp cloth.

• When no longer using the device, store it in a place where neither high temperatures nor moisture can affect it.

This product is subject to the provisions of European Direc- tive 2012/19/EC. The symbol showing a wheelie bin crossed through indicates that the product requires separate refuse collection in the European Union. This applies to the product and all accessories marked with this symbol. Prod- ucts identified with this symbol may not be discarded with normal household waste, but have to be taken to a collection point for recy- cling electric and electronic devices. This disposal is free of charge. Protect the environment and dispose of waste properly. Further information can be ob- tained from your local disposal service or city/municipal administration. Packaging The packaging is made from recyclable materials. Dispose of the packag- ing sorted by materials. When disposing of the packaging, make sure you comply with the environmental regulations applicable in your country. __RU110635_B1.book Seite 43 Donnerstag, 7. Mai 2015 5:50 1744

If your headphones fail to function as required, please try this checklist first. Perhaps there is only a minor problem, and you can solve it yourself. WARNING! Risk of material damage! Do not attempt to repair the device yourself under any circumstances. Fault Possible causes /Action No sound

• Check the connection between the sound source and the headphones.

• Check the settings on your sound source. Sound only on one side of the headphones

• Check the balance settings on your sound source.

• Make sure that the cable's stereo TRS con- nectors

are fully inserted into the sock- ets|

Subject to technical modification. Declaration of conformity A complete declaration of conformity can be requested from HOYER Handel GmbH, see Service Centre. Model: SKO 40 A1 Resistance: 32 ŝ +/– 4 ŝ at 1 kHz Broadband ID voltage (WBCV): 130|mV +/– 10% Transmission range: 20 Hz - 20 kHz Plug: 3.5 mm TPS connector Cable length: 1.5 m Dimensions (WxDxH): approx. 190 x 165 x 75|mm Weight: approx. 0.166 kg (with cable|

Dear Customer, your device is provided with a 3 year warranty starting with the purchase date. In the event of product defects, you are entitled to statutory rights against the vendor. These statutory rights are not restricted by our warran- ty presented in the following. Warranty conditions The warranty period starts with the purchase date. Please keep the original pur- chase receipt in a safe place. This document is required to verify the purchase. If within three years from the purchase date of this product a material or factory defect occurs, the product will be repaired or replaced by us – at our discretion – free of charge to you. This warranty implies that within the period of three years the defective device and the purchase receipt are presented, including a brief written description of the defect and the time it occurred. If the defect is covered by our warranty, the repaired or a new product will be returned to you. No new warranty period starts with a repair or replacement of the product. Warranty period and statutory claims for defects The warranty period is not extended when the warranty has been claimed. This also applies to replaced and repaired parts. Any damages and defects already existing at the time of purchase must be reported im- mediately upon unpacking. Repairs arising after the expiration of the warranty period are subject to a charge. Warranty coverage The device was produced carefully according to strict quality guidelines and tested diligently prior to delivery. The warranty applies to material or factory defects. This warranty does not include product parts that are subject to standard wear and therefore can be considered wear parts; the same applies to damages at fragile parts, e.g. switches, rechargeable batteries or parts made of glass. This warranty expires if the product is damaged, not used as intended or not serviced. For the proper operation of the product, all instructions listed in the operating instructions must be observed carefully. Any form of use __RU110635_B1.book Seite 46 Donnerstag, 7. Mai 2015 5:50 1747

and handling that is advised against in the operating instructions or warned against must always be avoided. The product is only intended for private and not for commercial use. In the case of incorrect and improper treatment, use of force and interven- tions not performed by our authorised Service Centre, the warranty shall cease. Handling in case of a warranty claim In order to ensure prompt processing of your matter, please observe the following notes:

• Please keep the article number IAN: 110635 and the purchase receipt as a purchase verification for all inquiries.

• If faulty operation or other defects occur, first contact the Service Cen- tre listed in the following by telephone

• Then, you are able to send a product reported as defective free of charge to the service address specified to you, including the pur- chase receipt and the information on the defect and when it oc- curred. Please visit www.lidl-service.com to download this and many other manuals, product videos and software. Service Centre Service Great Britain Tel.: 0871 5000 720 (£ 0.10/Min.) E-Mail: hoyer@lidl.co.uk Service Ireland Tel.: 1890 930 034 (0,08 EUR/Min., (peak)) (0,06 EUR/Min., (off peak)) E-Mail: hoyer@lidl.ie IAN: 110635