4LD4306 - Clock AURIOL - Free user manual and instructions

USER MANUAL 4LD4306 AURIOL

Preliminary note Please read the instruction manual before using the wall clock for the first time- even if you are experienced at using electronic equipment. Please take special care when reading the chapter "Important safety information". Keep this instruction manual so you may use it a reference material in the future. If you sell or give this wall clock to someone else it is very important to also include this manual. Intended use This electronic appliance is intended for time display and the described additional features. Any other use or modification of the electronic appliance does not comply with the intended uses. The manufacturer is not liable for damages caused by improper use or misuse. The device is not intended for commercial use. Scope of delivery

• instruction manual Technical specifications

• Battery powered 1,5 V AA R6/LR6 battery Set up the device safely Hang the wall clock on a flat wall using a nail or screw. The wall clock is not designed for operation in rooms with high humidity (i.e. bathroom). Make sure that:

• no direct heat sources (i.e. radiators) influence the device;

• no direct sunlight reaches the device;

• contact with splashing or dripping water must be avoided

• the device doesn’t stand near magnetic fields (i.e. speakers);

• no foreign objects penetrate the housing.

• candles and other open flames must be kept away from this product at all times to prevent the spread of fire

User This device may be used by persons (including children over 8 years of age) with reduced physical, sensory or mental abilities or lack of experience and knowledge, if they are supervised or instructed regarding the safe use of the device and understand the dangers that may arise. Children may not play with the device. Cleaning and user maintenance of the device may not be performed by children without supervision. Keep packaging films out of the hands of children. There is a danger of suffocation. Batteries Keep batteries out of reach of small children. If a battery is swallowed, you must seek medical attention immediately. Batteries/rechargeable batteries must always be inserted in the correct polarity. If necessary, clean the battery and device contacts. Never attempt to recharge non-rechargeable batteries. Never short-circuit or attempt to open batteries. Never throw batteries into fire as they may explode. If the device will not be used for an extended time period, remove the battery and store the device in a dry and dust-free area. Improper use of the battery can lead to explosion or leakage. If the battery leaks, avoid contact with skin, eyes and mucous membranes. Use gloves. If you are exposed to battery acid, rinse the affected areas with plenty of clean water and immediately seek medical attention. Remove discharged batteries from the device as they present an increased risk of leakage. Setup Insert a 1,5 V AA R6/LR6 battery in the correct polarity into the battery compartment on the back of the wall clock. The hands will move to the 12:00:00, 4:00:00 or 8:00:00 o'clock position and stop. The clock will now begin to receive the DCF77 radio signal. The reception process can take 3-10 minutes. After successful reception of the radio signal, the hands will automatically move to the correct time. If the reception process fails, it will be repeated hourly. The reception process can be restarted manually by pressing and holding REC on the back side of the clock for 5 seconds. The hands will move to the 12:00:00, 4:00:00 or 8:00:00 o'clock position and stop. The clock will now begin to receive the DCF77 radio signal. Manual time setting This feature cannot be used while the clock is attempting to receive the radio signal (Hands at 12:00:00, 4:00:00 or 8:00:00). Press and hold the SET button on the backside of the clock for 5 seconds. The clock will enter manual mode. Press and hold SET to move the hands to the correct position. If the SET button is pressed briefly, the hands will move forward by exactly one minute. After 7 seconds without pressing SET, the clock will exit manual mode and the hands will move in the normal fashion.-

Reset In case of a malfunction, the clock can be reset and holding RESET on the back side of the clock for 5 seconds (with a small screwdriver). The hands will move to the 12:00:00, 4:00:00 or 8:00:00 o'clock position and stop. The clock will now begin to receive the DCF77 radio signal. Reception interference The DCF77 radio signal is transmitted from the vicinity of Frankfurt am Main and can be received within a radius of about 1500 km. However, there are some sources of interference that may greatly hinder reception. If your wall clock does not correctly receive the radio signal, hang the wall clock in a different location. Please note, that the electromagnetic waves that may occur near computers, telephones, radios and TVs can interfere with DCF77 radio reception. Strong building insulation (metal building elements), mountains or atmospheric interference can also hinder reception. Replace the batteries if necessary. Cleaning instructions Clean the product with a soft, dry and lint-free cloth. A glasses cleaning cloth is ideal. Declaration of Conformity If used as intended this product conforms to the basic standards of § 3 and the other relevant provisions of the FTEG (Section 3 of the R&TTE directive). The declaration of conformity may be requested here: conformity@digi-tech-gmbh.com Disposal of the electronic appliance This wall clock may not be disposed of with normal household waste. Dispose of the unit at an approved disposal facility or at your local recycling centre. Please observe the current rules and regulations when disposing of the appliance. Contact the disposal system if in doubt. Disposal of the batteries Please dispose of your batteries properly in containers especially set up at retailers. Batteries do not belong in household waste. Dispose of the batteries at an approved disposal facility or at your local recycling centre. Contact the disposal system if in doubt.

digi-tech gmbh warranty This wall clock includes a 3 year warranty starting on the day of purchase. In case of defects of this wall clock you have, by law, certain rights regarding the vendor of the wall clock. These rights are not changed by the warranty which is described in the following paragraphs. Warranty conditions The warranty duration starts on the date of purchase. Please keep the original receipt in a safe place. The receipt is needed as a proof of purchase. If a defect occurs in the wall clock within 3 years, the wall clock will be repaired or replaced (according to our choice) free of charge. This warranty requires that, within the 3 year warranty period, the wall clock and the receipt can be made available to us along with a short written description of the defect and when it occured. If the defect is covered by the warranty, you will receive the repaired wall clock or a new wall clock. Repair or replacement does not cause the warranty period to restart. Warranty period and defects liability The warranty period is not increased by the defect liability. This also applies to repaired or replaced parts. If defects are noticed at the time of purchase they must be reported immediately upon unpacking the item. Paid repair may be available after the end of the warranty period. Scope of the warranty The wall clock was manufactured according to strict quality guidelines and was carefully inspected before delivery. The warranty does not include parts that experience normal wear and tear and can thus be seen as wear parts or fragile parts that are damaged. Examples include Switches, Batteries or parts made of glass. This warranty becomes void if the wall clock is damaged, is not used in the recommended way or is improperly repaired. For proper use of the wall clock all instructions in this manual must be adhered to exactly. Use of the wall clock in a way that is discouraged in the manual must be avoided. The wall clock not intended for commercial use. Abusive or improper use, excessive force and changes that are made by non-authorized repair centers will void the warranty.-

Warranty claim procedure To ensure that your call is processed in a fast and efficient manner please note the following directions:

• Have your receipt (as proof of purchase) and the article number (281487) handy.

• The article number can be found on the type label, an engraving, the front page of the manual (bottom left) or a sticker on the back side or bottom side of the case.

• In case defects occur, please first contact the service center (see below) by phone or email.

Visit www.lidl-service.com to download this and many other manuals, product videos and software. Service Name: Inter-Quartz GmbH Street: Valterweg 27A Town: Eppstein 65817 Country: Germany Email: support@inter-quartz.de Telephone: +49 (0)6198 571825

Please note that the following address is not a service address. Please first contact the service address (see above). Name: digi-tech gmbh Street: Valterweg 27A Town: Eppstein 65817 Country: Germany-