Z29955A - Clock AURIOL - Free user manual and instructions

Product Type	Radio-Controlled Alarm Clock
Brand	Auriol
Model	Z29955A
Dimensions (approx.)	15 x 8 x 15 cm (5.9 x 3.1 x 5.9 in)
Weight (approx.)	300 g (10.6 oz)
Power Source	2 x AA batteries (not included)
Display Type	Digital LCD with backlight
Time Synchronization	Radio-controlled (DCF-77 signal)
Alarm Function	Single alarm with snooze
Additional Functions	Date display, indoor temperature, calendar
Operating Temperature	-5°C to 50°C (23°F to 122°F)
Cleaning Instructions	Wipe with a soft, dry cloth; avoid water and solvents
Battery Replacement	Replace with same type (AA) when low battery indicator appears
Safety Precautions	Keep away from water, heat sources; use only approved batteries
Spare Parts Availability	Batteries only; other parts not user-serviceable
Reparability	Limited; contact manufacturer for service
Warranty	2 years (check local regulations)
Country of Origin	China
Package Contents	Clock, user manual

Frequently Asked Questions - Z29955A AURIOL

How do I set the time manually if the radio signal is weak?

Press and hold the SET button for 3 seconds. Use the UP and DOWN buttons to adjust hours, minutes, and date. Press SET to confirm each step.

Why is my clock not receiving the radio signal?

Ensure the clock is placed near a window, away from electronic interference. The DCF signal may be weak in some areas. Try moving the clock or setting it manually.

How do I activate the backlight?

Press the SNOOZE/LIGHT button briefly to turn on the backlight for 5 seconds. The backlight may be dim to save battery.

How do I set the alarm?

Press the ALARM button once to view the current alarm time. Press and hold ALARM until the hour flashes, then use UP/DOWN to adjust. Press ALARM again to set minutes. To enable/disable, press ALARM repeatedly until the alarm icon shows or disappears.

How do I turn off the snooze function?

When the alarm sounds, press the SNOOZE/LIGHT button to snooze for 5 minutes. To silence the alarm completely, press the ALARM or SET button.

What type of batteries does the clock use?

The clock requires 2 AA batteries (not included). Use alkaline batteries for best performance. Do not use rechargeable batteries unless specified.

How do I change the temperature unit from °C to °F?

Press and hold the UP button for 3 seconds to toggle between Celsius and Fahrenheit. The unit will change on the display.

My clock display is dim or not working. What should I do?

Check that the batteries are installed correctly and have sufficient charge. Replace with fresh batteries if needed. If the display remains blank, the unit may be defective.

Can I mount the clock on a wall?

This model is designed for tabletop use only. It does not include a wall-mounting bracket. Placing it on a flat surface is recommended.

How do I reset the clock to factory defaults?

Remove the batteries, wait 30 seconds, then reinsert them. The clock will automatically start searching for the radio signal and reset to default settings.

USER MANUAL Z29955A AURIOL

Operation and Safety Notes

PL

ZEGAR ŚCIENNY Z RAMKAMI NA ZDJĘCIA

GB Operation and Safety Notes Page 5

Description of Parts....Page 6

Technical details....Page 7

Included items ......Page 7

Safety

General Safety Information......Page 7

Safety Instructions for Batteries Page 8

Preparing the product for use......Page 9

Operation

Receiving the DCF radio time signal......Page 9

Setting the time manually....Page 10

Insertung photos......Page 11

Reset the functions (RESET)......Page 11

Cleaning and Maintenance......Page 11

Disposal Page 11

Information

Declaration of Conformity......Page 12

GB 5

Introduction

Photo Wall Clock

Introduction

Keep these instructions in a safe place. If you pass the product on to anyone else, please ensure that you also pass on all the documentation.

Proper Use

The wall clock shows the time by using Radio time signal (DCF). The device is intended for use indoors at normal room temperatures only. The device is not intended for commercial use.

• Description of Parts

1 M.SET button 2 RESET button 3 REC button 4 Battery compartment 5 Wall hanging hole 6 Housing screw 7 Back part 8 Photo holder

6 GB

Introduction / Safety

Technical details

Radio time signal (DCF)

Battery type: 1.5 V, AA

Included items

1 Photo wall clock, 1 Battery 1.5V, AA, 1 Operating instructions

Safety

WARNING! Please read all safety information and instructions.

Failure to comply with the safety information and instructions may result in fire and/or severe injuries.

General Safety Information

DANGER OF DEATH AND ACCIDENT HAZARD FOR TODDLERS AND SMALL CHILDREN! Never allow children to play unsupervised

with the packaging material. There is a danger of suffocation from the packaging material. Children frequently underestimate the dangers.

Children or persons who lack the knowledge or experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision

Safety

or instruction by a person responsible for their safety. Children must never be allowed to play with the device.

WARNING! DANGER TO LIFE! Batteries can be swallowed, which may represent a danger to life. If a battery has been swallowed, medical help is required immediately.

- Do not use the device if it is damaged.

Safety Instructions for Batteries

■ Remove the battery from the device if it is not going to be used for a prolonged period. CAUTION! DANGER OF EXPLOSION! The batteries must never be recharged! When inserting the battery, ensure the correct polarity! This is shown in the battery compartment. If necessary, clean the battery and device contacts before inserting the battery. ■ Remove a spent battery immediately from the device. There is an increased danger of leaks! If the above instructions are not complied with, the battery may discharge itself beyond its end voltage. There is then a danger of leaking. If the battery has leaked inside your device, you should remove it immediately in order to prevent damage to the device! Batteries must not be disposed of in the normal domestic waste! ■ Every consumer is legally obliged to dispose of batteries in the proper manner! - Keep batteries away from children; do not throw batteries in the fire, short-circuit batteries or take them apart.

Safety/Preparing the product for use/Operation

Avoid contact with the skin, eyes and mucous membranes. Any parts of the body coming into contact with battery acid should be rinsed off with copious amounts of water and / or a doctor contacted if necessary!

● Preparing the product for use

☐ Remove the battery insulation strip from between the battery and the contact.

Note: Reception may be considerably reduced by obstructions (e.g. concrete walls) or sources of interference (e.g. other electrical devices). In the event of reception problems, change the position of the wall clock (e.g. to somewhere near a window).

Radio Signal (DCF):

The DCF signal (time signal transmitter) consists of time pulses emitted by one of the most accurate clocks in the world close to Frankfurt / Main, Germany – this varies by 1 second in a million years.

Your radio-controlled clock receives these signals under ideal conditions up to a distance of approx. 1,500 km around Frankfurt / Main. Reception of the radio signal generally takes approx. 3–10 minutes.

Operation

- Receiving the DCF radio time signal

The wall clock automatically starts to search for the DCF radio time signal. This process takes about 3–10 minutes to complete.

GB 9

Operation

The reception of the DCF radio time signal by the wall clock can also be started manually.

Press and keep pressed the REC button at least 5 seconds. The wall clock attempts to receive the DCF radio time signal. This process takes a few minutes to complete.

Note: If the wall clock was not able to receive the DCF radio time signal because of errors, e.g. due your location to being at too great a distance from the transmitter or for other reasons, you can set the time manually. The manually set value is overwritten as soon as reception of the DCF radio time signal is successful.

- Setting the time manually

Press and keep pressed the M.SET button at least 3 seconds. The wall clock switches into manual mode. Press and keep pressed the M.SET button again until the hands reach the correct position for you to set the time. Briefly pressing the M.SET button moves the hands forward in one minute steps to enable you to set the current time manually.

Note: After 8 seconds without pressing the M.SET button, the wall clock switches out of manual mode and keeps the time as normal. The manually set value is overwritten as soon as reception of the DCF radio time signal is successful.

Operation/Cleaning and Maintenance/Disposal

Inserting photos

You can insert your own photographs into the clock's photo-holder 8.

To do this, proceed as shown in Fig. B.

- Reset the functions (RESET)

If the wall clock does not react, you can press the RESET button to reset all the settings back to the default values. You can then start again from the beginning.

● Cleaning and Maintenance

Under no circumstances should you use liquids or detergents, as these will damage the device. The device should only be cleaned on the outside with a soft dry cloth. If the wall clock is not going to be used, remove the battery.

- Disposal

The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities.

Contact your local refuse disposal authority for more details of how to dispose of your worn-out product.

Disposal / Information

To help protect the environment, please dispose of the product properly when it has reached the end of its useful life and not in the household waste. Information on collection points and their opening hours can be obtained from your local authority.

Faulty or used batteries must be recycled in accordance with Directive 2006/66/EC. Please return the batteries and/or the device to the available collection points.

Environmental damage through incorrect disposal of the batteries!

Batteries may not be disposed of with the usual domestic waste. They may contain toxic heavy metals and are subject to hazardous waste treatment rules and regulations. The chemical symbols for heavy metals are as follows: Cd = cadmium, Hg = mercury, Pb = lead. That is why you should dispose of used batteries at a local collection point.

Information

Declaration of Conformity

We, OWIM GmbH & Co. KG, Stiftsbergstraße 1, D-74167 Neckarsulm, hereby declare under our sole responsibility that the product: Photo Wall Clock, Model No.: Z29955A, Version: 10 / 2012, to which this declaration refers, complies with the standards/normative documents of 1999/5/EC.

12 GB

Information

The full Declaration of Conformity is available on the Internet at www.owim.com.

13 GB

Table of contents

Introduction