KA EL 167 - Heating KALORIK - Free user manual and instructions

USER MANUAL KA EL 167 KALORIK

1. Handle
2. Window
3. Thermostat
4. Switches I and II
5. Cord storage
6. Rolls and feet
7. Air humidifier

F

Technical line drawings of mechanical components including shaft, housing, and bearing (no text or labels)

Please read these instructions carefully before using the appliance.

Important: People (including children) who are not able to use the appliance in a safe way, due to their physical, sensorial or mental capacity or their lack of experience or knowledge, must never use the appliance except if they are supervised by a person responsible for their safety or if they previously received instructions concerning the safe use of the appliance.

Close supervision is necessary to prevent children from using the appliance as a toy.

☐ Check that your mains voltage corresponds to that stated on the appliance.
☐ Never leave the appliance unsupervised when in use.
From time to time check the appliance for damages. If it is damaged, do not use it but have it repaired by a competent qualified electrician (*). Should the cord be damaged, it must be replaced by a competent qualified electrician(*).
☐ Only use the appliance for domestic purposes and in the way indicated in these instructions.
☐ Never immerse the appliance in water or any other liquid for any reason whatsoever. When cleaning the appliance, refer to the instructions in the "Cleaning and care" section.
□ Never use the appliance near hot surfaces.
□ Unplug the appliance before cleaning it.
☐ Never use the appliance outside and always place it in a dry environment.
☐ Never use accessories that are not recommended by the producer. They could constitute a danger to the user and risk to damage the appliance.
☐ Do not place the appliance under a power socket. The power socket must not be in the hot airflow of the appliance in order to avoid overheating.
☐ Never move the appliance by pulling the cord. Make sure the cord cannot get caught in any way. Do not wind the cord around the appliance and do not bend it.
□ Always position the radiator in such a way that inflammable materials (such as curtains) cannot be ignited. Ensure at all times that the unit is placed solidly on its wheels.
Make sure that the air inlet and outlet openings are not blocked. To avoid any risk of fire, do not cover the heater (ex. With clothes)
☐ Warning: Do not operate the heater near baths, showers, washbasins, swimming pools or any other water container. It must be impossible to reach the commands of your appliance when you are in contact with water.
☐ The temperature of the appliance may be very high when the appliance is in use. Avoid contact with the skin.
☐ Make sure the cord does not come into contact with the hot parts of the appliance.
☐ Never use the appliance near inflammable or explosive materials.
☐ Do not cover the appliance in order to avoid any risk of fire.
☐ Hazards may occur, for instance when touching the radiator or knocking it over, or as a result of inappropriate positioning. No responsibility is accepted if damage results from improper use, or if these instructions are not complied with.
□ Always switch off and remove the plug from the wall socket after use, and also in case of any malfunction and before cleaning. Do not attempt to remove the plug from the wall socket with wet hands.
☐ This radiator is filled with a precise quantity of special oil. Any repairs requiring the opening of the oil container are to be made by the manufacturer or its authorized service agent. They also should be contacted if oil leaking.

☐ When scrapping the appliance, all regulations concerning the disposal of oil should be followed.

1) Competent qualified electrician: after sales department of the producer or importer or any person who is qualified, approved and competent to perform this kind of repairs in order to avoid all danger. In any case you should return the appliance to this electrician.

CONNECTION TO THE MAINS SUPPLY

The radiator should only be connected to an earthed socket installed in accordance with the regulations.

Make sure that the supply voltage corresponds with the voltage marked on the rating label (230V (AC)) and the rated electric current is not lower than 10A.

This product complies with all binding CE- labelling directives.

START UP

Before using the radiator for the first time, the feet must be fitted to the base of the unit and then secured with the screws provided.

Technical line drawings of mechanical components including shaft, housing, and bearing (no text or symbols)

When the appliance is switched on for the first time, a slight smell may be emitted. Please ensure sufficient ventilation.

USAGE

Your appliance is fitted with an air humidifier (on the opposite side of the control panel). Before switching on your appliance, fill the water tank (with demineralized water). Do not overfill over the HIGH level.

How to fill the tank:

• Remove the tank and its support from the heater
• Remove the tank from its support
• Open the lid and fill the tank
• Close the lid, replace the tank on its support
  Replace everything on the heater.

CAUTION: IF YOU WANT TO FILL THE TANK DURING USE PAY ATTENTION NOT TO GET BURNED BECAUSE IT BECOMES VERY HOT.

1. There are two indicator light switches; you can adjust them on your requirement.

Switch positions

I = reduced power
II = medium power
I+II = full power

1. Turn the thermostat to position 4 and switch on your appliance (1 or 2 switches).

8 KA EL 16-7/9/11 - 070418

1. After 10-15 minutes, if you feel the room temperature is too low or too high, just adjust the temperature to the desired position.
2. If you want to switch off your appliance, turn off the two power switches at the same time (the indicator light will be off), remove the plug from the power supply and place it in its storage location. CAUTION: YOUR APPLIANCE WILL REMAIN HOT FOR A FEW MINUTES.
3. To move your appliance, take it by its handle, raise it and roll it.

OVERHEAT PROTECTION

This heater is protected with an overheat protection that switches off the appliance automatically in case of overheat. In this case, unplug the appliance, wait about 10 minutes for it to cool. Then switch it back on as described above. The appliance should operate normally. Should the problem persist, please contact the nearest customer service.

GENERAL CLEANING AND CARE

• Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down completely.
• Do not clean the radiator with water and do not immerse it.
  • The housing may be wiped with a slightly damp, lint-fee cloth.

PROTECTION OF THE ENVIRONMENT- DIRECTIVE 2002/96/EC

In order to preserve our environment and protect human health, the waste electrical and electronic equipment should be disposed of in accordance with specific rules with the

implication of both suppliers and users. For this reason, as indicated by the symbol , the rating label or on the packaging, your appliance should not be disposed of as unsorted municipal waste. The user has the right to bring it to a municipal collection point performing waste recovery by means of reuse, recycling or use for other applications in accordance with the directive.

FR MODE D'EMPLOI

POUR VOTRE SECURITE

Technical line drawings of mechanical components including shaft, housing, and wheel assembly (no text or labels)

Technical line drawings of mechanical components including a rod, housing, and bearing (no text or symbols)

I+II = maximum stand

Technical line drawings of mechanical components including shaft, housing, and wheel assembly (no text or labels)

Technical line drawings of mechanical components including shaft, housing, and bearing (no text or symbols)

Technical line drawings of mechanical components including a rod, housing, and bearing (no text or labels)