CORINTHIA ISOLA - Kitchen hood FABER - Free user manual and instructions

USER MANUAL CORINTHIA ISOLA FABER

© Recommendations and suggestions - The Instructions for Use apply to several versions of this appli- ance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. The manufaciurer will not be held liable for any damages re- sulting from incorrect or improper installation. The minimum safety distance between the cooker top and the extractor hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation). Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. For Class | appliances, check that the domestic power supply guarantees adequate earthing. Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible. Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fire- places, etc.). Ifthe extractor is used in conjunc- tion with non-electrical appliances (e.g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the cooker hood. In the event of damage to the power cable, it must be replaced by the manufacturer or by the technical service department, in order to prevent any risks. If the instructions for installation for the gas hob specify a greater distance specified above, this has to be taken into account. Regu- lations concerning the discharge of air have to be fulfilled. Use only screws and small parts in support of the hood.

Warning: Failure to install the

screws or fixing device in ac- cordance with these instructions may result in electrical hazards. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Use - The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. + Never use the hood for purposes other than for which it has been designed. + Never leave high naked flames under the hood when it is in operation.

+ Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continu- ously monitored during use: over- heated oil can burst into flames. Do not flambè under the range hood:; risk of fire. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental ca- pabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. “CAUTION: Accessible parts may become hot when used with cooking appliances.” Maintenance + The symbol Æ on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and elec- tronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Switch off or unplug the appliance from the mains supply before car- rying out any maintenance work. Clean and/or replace the Filters after the specified time period (Fire hazard). - The Activated charcoal filter is not washable and cannot be re- generated, and mustbe replaced approximately every 4 months of operation, or more frequently for particularly heavy usage (W).

- The Grease filters must be cleaned every 2 months of op- eration, or more frequently for particularly heavy usage, and can be washed in a dishwasher (2). + Clean the hood using a damp cloth and a neutral liquid deter- gent.

Controls Button | Function Led A Turns the motor on/off at speed one. Fixed. With the motor turned off: Flashes once a Saturation of the grease filters takes place after 100 hours of continuous | second. operation of the hood. With the motor turned off: Flashes once Saturation of the activated charcoal filters takes place after 200 hours of | every 0.5 continuous operation of the hood. seconds. B |Tums the motor on at speed two. On. Press and hold the button for approximately 2 seconds, with all the loads | Flashing. tumed off (Motor+Lights), to turn the Activated Charcoal Filter alarm on. LED (A) flashes twice to confirm. To tum the alarm off, press the button again and hold for at least 2 seconds. The relevant LED flashes once (A). [a Turns the Motor on at speed three. On. Press and hold the button for approximately 2 seconds, with all the loads | Flashing. turned off (Motor+Lights), to reset the Filter saturation alarm. LED A flashes three times. D Tums the motor on at INTENSIVE speed. Flashing. This speed is timed to run for 6 minutes. At the end of this time, the system retums automatically to the speed that was set before. If it is activated with the motor turned off, it will switch to OFF at the end of the time. To deactivate it, press button D once more or press button A. With all the loads tumed off (Motor+Lights), press and hold D for approximately | Flashing. 2 seconds to enable the remote control. Button A flashes twice. With all the loads tumed off (Motor+Lights), press and hold D for approximately 2 seconds to disable the remote control. Button A flashes once. E | Tums the lights onfoff at maximum strength. On. Lighting + For replacement contact technical support (‘To purchase contact technical support”).

TEPQ OE TEPITTWON IDIQITEPO OUXVAS

+ ACTMPATOPET € CHITATEH U3KIIOHU-