EZ 2693 - Electric toothbrush CLATRONIC - Free user manual and instructions

USER MANUAL EZ 2693 CLATRONIC

General Safety Instructions

• Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing.
• The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit for commercial use. Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately. Do not put it in water.
• When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories.
• Never leave the appliance unsupervised. To protect children from the dangers posed by electrical appliances, make sure that the cable is hanging low and that children do not have access to the appliance.
• Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type.
  Use only original spare parts.
• Pay careful attention to the following "Special Safety Instructions".

Special Safety Instructions

• Please do not immerse the toothbrush in water.

List of Parts

1 Brush head

5 Drive rod

2 Brush compartment

6 ON/OFF switch

3 Brush shaft

7 Charge control lamp

4 Coloured ring

8 Charger

Initial Operation

In order that the battery reaches its full capacity, please carry out the following operation: Charge the battery (see "Charging the Battery"). Then leave the device switched on until it switches itself off. Then charge the battery once more. The device is now ready for operation.

Charging the Battery

1. Connect the charging device to a 230 volt, 50 hertz socket.
2. Attach the motor housing to the charging pin.

Using the Device

1. Push a brush on to the drive rod. The bristles must point in the direction of the switch. It must not be possible to turn the brush shaft in this position. The brushes are fitted with different coloured rings so that they can be distinguished from one another.
2. Rinse out your mouth thoroughly and moisten the bristles. You can use toothpaste if required. In order to avoid splashes, switch the toothbrush on and off while it is in the mouth.
3. Switch the toothbrush on by the switch (6).
4. Move the brush slowly in small circular movements and with a slight pressure from tooth to tooth. It is not necessary to press hard. Take care that the head of the brush also reaches the spaces between the teeth.
5. Rinse your mouth out after use. Pull off the head of the brush and clean it with water. The brush head can be replaced in the container for storage.
6. The toothbrush is switched off by pressing the switch (6) again.

Note: During the first days of use it may be that bleeding of the gums occurs. This normally stops after a few days. If the bleeding of the gums does not stop after 2 weeks, please consult a dentist.

Cleaning and Care

• Pull down the brush head. Do not push down the brush but only the lower part of the accessory (colored marking) and clean it under running water! Do not use any additives to clean the head of the brush!
• The toothbrush is watertight and can be cleaned under running water! Please do not immerse completely in water.
• Do not use any abrasive substances for cleaning! These may damage the seals and the housing!
• Simple soapy water may be used to clean the toothbrush.
• Please note that toothbrushes lose their cleaning capacity after approx. 8 weeks. The spare brushes for your electrical toothbrush can be ordered at the telephone specified in the „Service“ section.

This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.

Subject to technical changes without prior notice!

GB

GB

Guarantee

The device supplied by our Company is covered by a 24 month guarantee starting on the date of purchase (receipt).

During the life of the guarantee any fault of the device or its accessories *) ascribable to material or manufacturing defects will be eliminated free of charge by repairing or, at our discretion, by replacing it. The guarantee services do not entail an extension of the life of the guarantee nor do they give rise to any right to a new guarantee!

Proof of the guarantee is provided by the proof of purchase. Without proof of purchase no free replacement or repair will be carried out.

If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt.

*) Damage to accessories does not mean automatic free replacement of the whole machine. In such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge.

Defects to consumables or parts subject to wearing (e.g. motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc.) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!

The guarantee lapses in case of unauthorized tampering.

After the expiry of the guarantee

After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs.

• Ptoxaynta He norgykaite npibop B BOy.