The In-Nova Premium - Range hood FABER - Free user manual and instructions

Product type	Cooker hood
Brand	Faber
Model	The In-Nova Premium
Width	90 cm
Depth	50 cm
Height (min/max)	60 - 110 cm
Net weight	18 kg
Power supply	220-240 V / 50 Hz
Suction power	650 m³/h
Noise level	55 dB (A)
Filter type	Activated carbon filter and metal filter
Number of speeds	3
Lighting	Integrated LED
Controls	Touch
Operation	Extraction or recirculation
Energy class	A
Filter maintenance	Monthly cleaning of the metal filter in the dishwasher
Safety	Automatic shut-off, overheating protection
Warranty	2 years
Spare parts available	Filters, LED bulbs, remote control

Frequently Asked Questions - The In-Nova Premium FABER

How to install the In-Nova Premium hood ?

The installation must be carried out by a qualified professional. Make sure the hood is firmly fixed to the wall or under a cabinet, at a distance of 65-75 cm above an electric hob or 75-85 cm for a gas hob. Follow the assembly diagram provided in the manual.

How to clean the metal filters ?

Metal filters can be cleaned in the dishwasher or by hand with warm soapy water. It is recommended to clean them every month to maintain the hood's efficiency. Dry them completely before putting them back in place.

How to change the LED bulb ?

First, unplug the appliance. Remove the lighting cover by gently pushing on the clips. Replace the defective LED module with an identical model (Faber reference). Reinstall the cover and plug the hood back in.

Why is my hood making noise ?

Excessive noise can be caused by a clogged filter, unstable installation, or a dirty motor. Check the filter cleaning and tighten the fasteners. If the noise persists, contact after-sales service.

How to use the touch controls ?

The touch controls respond to a light touch. Press the button to turn the hood on/off, use the + and - symbols to adjust the suction speed. Press and hold the lighting button to vary the light intensity.

What is the difference between extraction and recirculation mode ?

In extraction mode, air is expelled outside through a duct. In recirculation mode, air is filtered through a charcoal filter and then returned to the room. Recirculation mode requires the purchase of the appropriate charcoal filter.

How to replace the charcoal filters ?

Charcoal filters should be replaced every 3 to 6 months depending on usage. Open the hood panel, remove the used filters and insert the new ones in the correct orientation. Close the panel.

The hood does not turn on, what should I do ?

First, check the power supply (socket, fuse). Make sure the hood is properly plugged in. If nothing happens, test with another appliance. If the problem persists, call an authorized technician.

How often should filters be replaced ?

Metal filters should be cleaned every month. Charcoal filters should be replaced every 3 to 6 months depending on usage intensity. An indicator or notification may remind you of maintenance.

How to adjust the suction power ?

Use the touch controls to select the desired speed (usually 3 levels). Speed 1 is for gentle cooking, speed 3 for strong odors or steam. Press the corresponding button.

USER MANUAL The In-Nova Premium FABER

EN USER MANUAL 3

For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance.

The wire connection has to be done by specialized technician.

• The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
• The minimum safety distance between the cooker top and the extractor hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation).
• If the instructions for installation for the gas hob specify a greater distance, this must be respected.
• Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood.
• Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
• For Class I appliances, check

that the domestic power supply guarantees adequate earthing. - Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible. - Regulations concerning the discharge of air have to be fulfilled. - Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc.). If the extractor is used in conjunction with non-electrical appliances (e.g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the cooker hood. - The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels. - If the supply cord is damaged, it must be replaced from the manufacturer or its service agent. - Connect the plug to a socket complying with current regulations, located in an accessible place. - With regards to the technical

and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities.

WARNING: Before installing the Hood, remove the protective films.

- Use only screws and small parts in support of the hood.

WARNING: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

• Do not look directly at the light through optical devices (binoculars, magnifying glasses...).
• Do not flambé under the range hood; risk of fire.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. • Children should be supervised to ensure that they do not play with the appliance.
• The appliance is not to be used by persons (including children) with reduced physical, sensory

or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.

Accessible parts may become hot when used with cooking appliances.

• Clean and/or replace the Filters after the specified time period (Fire hazard). See paragraph Care and Cleaning.
• There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
• The symbol ✉ on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

2. USE

• The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells.
• Never use the hood for purposes other than for which it has been designed.
• Never leave high naked flames under the hood when it is in operation.
• Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides.
• Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.

3. CARE AND CLEANING

- The activated charcoal filter is not washable and cannot be regenerated, and must be replaced approximately every 4 months of operation, or more frequently for particularly heavy usage (W).

- The grease filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher (Z).

- Clean the hood using a damp cloth and a neutral liquid detergent.

4. CONTROLS

Button Function Led
L Turns the lights on/off at maximum strength. -
T1 Turns the motor on/off at speed one. Fixed.
		Keeping the button pressed for approximately 2 seconds starts/stops the temperature sensor.
T2 Turns the Motor on at speed two.Press and hold the button for approximately 5 seconds, with all the loads turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. The relevant LED flashes twice to confirm.To turn the alarm off, press the button again and hold for at least The relevant LED flashes once.		Fixed.The5 seconds.
T3 Turns the Motor on at speed three.Press and hold the button for approximately 3 seconds, with all the loads turned off (Motor and Lights), to perform a reset. The LED S1 flashes three times.		Fixed.
T4 Turns the Motor on at INTENSIVE Speed.This speed is timed to run for 6 minutes. At the end of this time, the system returns automatically to the speed that was set before. If it is activated with the motor turned off, the hood will switch to OFF at the end of the time.Press and hold for 5 seconds to enable the remote control, indicated by the LED flashing twice.Press and hold for 5 seconds to disable the remote control, indicated by the LED flashing just once.		Fixed.
S1 Signals the Metal Grease Filter saturation alarm, indicating that it is necessary to wash the filters. The alarm is triggered after the Hood has been in for 100 working hours.		Fixed.operation
		When this is activated, it signals the Activated Charcoal Filter saturation alarm, indicating that the filter must be changed; the Metal Grease Filters must also be washed. The Activated Charcoal Filter saturation alarm comes into operation after the Hood has been working for 200 hours.

WARNING: the temperature sensor is active when the hood is started. If, when the hood is off, the temperature detected by the sensor exceeds the set limit, the hood will turn on at speed two. When the temperature detected by the sensor returns below the threshold value the hood will turn off. In the event of the temperature not returning below the threshold value for approximately 90 minutes, the hood will turn off (the sensor is disabled for approximately 15 minutes, after which it will return to the previous setting). If the hood is adjusted manually (switching on/changing speed) the sensor is disabled and the hood must be turned off. After turning the hood off, the sensor is disabled for approximately 15 minutes, after which it will return to the previous setting. The temperature sensor does not guarantee automatic start-up of the hood, as its operation is influenced by environmental conditions, types of cooking operation, height and installation the hood (tested at 530 mm ).

WARNING: the sensor does not work with induction cookers.

5. REMOTE CONTROL (OPTIONAL)

This appliance can be commanded using a remote control, powered by a CR2032 type 3 V battery (not supplied).

• Do not place the remote control near heat sources.
• Do not discard the batteries with normal waste, they must be put into the specific containers.

6. LIGHTING

• Lamps in risk group 1 under IEC/EN62471 at a distance of 20cm and in exempt from risk group under IEC/EN62471 at a distance of 30cm.
• For replacement contact technical support ("To purchase contact technical support").

6. LIGHTING

6. LIGHTING

6. LIGHTING

6. LIGHTING

6. LIGHTING

LIGHTING

6. LIGHTING

6. LIGHTING

6. LIGHTING

no

6. LIGHTING

6. LIGHTING

6. LIGHTING

LIGHTING

1. SAFETY INFORMATION

6. LIGHTING

6. LIGHTING

6. LIGHTING

6. LIGHTING

- Clean the hood using a damp cloth and neutral liquid detergent.

4. CONTROL

Tipka Funkcija Led
L Uključuje/Isključuje svjetla na maksimalnu osvijetljenost. -
T1 Uključuje/Isključuje motor na prvu brzinu. Neprekidno.
		Držeći pritisnutu tipku oko 2 sekunde, aktivira/deaktivira senzor temperature.
T2 Uključuje motor na drugu brzinu.Držeći pritisnutu tipku oko 5 sekundi, kad su isključene sve komande (motor aktivira se alarm filtara s aktivnim ugljenom, a odgovarajuća Led lampica bljesne 2 puta.Za deaktiviranje, ponovno pritisnite tipku na dodatnih 5 sekundi, a Led lampica bljesne jedan put.		Neprekidno.+ svjetla),
T3 Uključuje motor na treću brzinu.Držeći pritisnutu tipku na oko 3 sekunde, kad su isključene sve komande (motor + svjetla), obavlja se resetiranje, a Led S1 bljesne tri puta.		Neprekidno.
T4 Uključuje motor na INTENZIVNU brzinu.Ta brzina tempirana je na 6 minuta. Po isteku tog vremena, sustav se automatski vraća na prethodno izabranu brzinu. Ako je aktivirana s ugašenog motora, po završetku vremena, prelazi u način OFF (Isključeno).Kad se drži pritisnuta 5 sekundi aktivira se daljinski upravljač, što je prikazano na način da isti led bljesne dva puta.Držeći tipku pritisnutu 5 sekundi deaktivira se daljinski upravljač, što pokazuje bljeskaj odgovarajućeg leda samo jedan put.		Neprekidno.
S1 Upozorava na alarm zasićenosti metalnih filtara protiv masnoće i potrebu da Neprekidno.opere. Alarm se aktivira nakon 100 sati efektivnog rada nape.		Neprekidno.
		Kad je aktivirana, upozorava na alarm zasićenosti filtra protiv mirisa s ugljenom koji se mora zamijeniti; moraju se također oprati metalni filtri protiv masnoće.Alarm zasićenosti filtra protiv mirisa s aktivnim ugljenom postaje aktivan nakon 200 sati efektivnog rada nape.

WARNING: the hood starts working with the temperature sensor active. With the hood off, when the temperature detected by the sensor exceeds the set limit, the hood turns on at the second speed. When the temperature detected by the sensor drops below the threshold value, the hood turns off. If the temperature does not drop below the threshold value for about 90 minutes, the hood turns off (the sensor remains deactivated for about 15 minutes, after which it returns to the previously set operation). When manually intervening on the hood (turning on/changing speed), the sensor is deactivated and it is necessary to turn off the hood.

6. LIGHTING

• The bulbs fall into risk group 1 according to the IEC/EN62471 standard at a distance of 20 cm and into the exempt risk group according to the IEC/EN62471 standard at a distance of 30 cm.
• For replacement, contact technical support ("For purchase, contact technical support").

1. SAFETY INFORMATION

6. LIGHTING

6. LIGHTING

6. LIGHTING

6. REPLACING THE LAMP

6. LIGHTING FIXTURE

6. LIGHTING

6. LIGHTING

6. LAMP

• The lamps belong to risk group 1 according to IEC/EN62471 at a distance of 20 cm and no risk group according to IEC/EN62471 at a distance of 30 cm.
• For replacement, contact technical support ("For purchase, contact technical support").