UM3.NE - Air purifier Bimar - Free user manual and instructions

Product Type	Air Purifier
Brand	Bimar
Model	UM3.NE
Dimensions (L x W x H)	25 x 25 x 40 cm
Weight	3 kg
Power Supply	220-240 V ~ 50/60 Hz
Maximum Power	50 W
Recommended Room Size	30 m²
Maximum Airflow	200 m³/h
Maximum Noise Level	55 dB
Filtration Type	HEPA Filter + Activated Carbon
Number of Speeds	3 speeds + sleep mode
Special Features	Ionization, Timer 1-8 h
Display	Touch LED
Remote Control	Yes
Filter Maintenance	Clean every 1-2 months, replace every 6-12 months
Filter Replacement Indicator	Yes
Safety	Automatic shut-off if tipped over
Spare Parts Available	Replacement filters, remote control
Color	White

Frequently Asked Questions - UM3.NE Bimar

How often should the filter be cleaned?

It is recommended to clean the filter every 1 to 2 months depending on usage. Use a soft vacuum to remove dust.

When to replace the HEPA filter?

The HEPA filter should be replaced every 6 to 12 months, depending on air quality. An indicator on the device will alert you.

Can I use the purifier 24/7?

Yes, the purifier is designed for continuous use. Use sleep mode at night for quiet operation.

How to reset the filter indicator?

After replacing the filter, press and hold the reset button (often the On/Off button) for 5 seconds until the indicator turns off.

Is the purifier effective against allergens?

Yes, the HEPA filter captures fine particles, pollen, dust mites and other allergens. The activated carbon removes odors.

Can I use essential oils in the purifier?

No, adding essential oils can damage the filters and the device. Use a separate diffuser.

What to do if the purifier does not turn on?

Check the electrical connection and that the filter is properly installed. If the problem persists, contact customer service.

Does the purifier produce ozone?

No, this model uses an ionizer without producing harmful ozone. It is safe for indoor use.

How to clean the exterior of the device?

Unplug the device and wipe the casing with a soft, dry cloth. Do not use abrasive or liquid products.

Where to buy replacement filters?

Replacement filters are available on the official Bimar website or from authorized dealers. Always use genuine parts.

USER MANUAL UM3.NE Bimar

Hand holding a cylindrical object with a labeled part (6), next to a mechanical component on a circular base (no text or symbols visible)

Two views of a mechanical component with numbered parts (5 and 9), no visible text or symbols beyond labels

3D mechanical component diagram showing a cylindrical housing with a labeled bolt and internal structure (no text or symbols)

Please read these instructions carefully before using the appliance, and instruct other persons using it, too, when necessary. KEEP BOOKLET HANDY FOR FURTHER USE.

WARNINGS

• This appliance is exclusively intended for home use to humidify rooms following the instructions in this booklet. Any other use is improper and dangerous. The manufacturer will not be liable for damage resulting from improper, incorrect or irresponsible use and/or for repairs made by unqualified persons.
• The appliance must not be used in out of doors in the open.
• Use the appliance with the accessories provided. Do not use accessories other than those provided: It can be dangerous for the user and can damage the appliance.
• Make sure that the humidifier does not come into contact with water or other liquids. If this should happen, do not put your hand in the liquid, but first remove the plug from the socket. Carefully dry the appliance and make sure that all the electrical parts are dry: if you are unsure, contact qualified service personnel.
• Ensure that the heating fan does not come into contact with water or other liquids. If this should happen, never immerse hands in the liquid but remove the plug from the socket first of all. Dry the appliance carefully and check that all the electric parts are dry. If in doubt, call a qualified expert.
• Do not touch the appliance with wet hands or feet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
• The appliance must be kept out of children's reach.
• Attention: when using electrical appliances, always follow basic safety precautions to avoid the risks of fire, electric shock and personal injury. You must take even more precautions when using electrical appliances that incorporate a water reservoir: in the case of water overflows, immediately remove the plug from the power outlet, make sure that the electrical components are not wet and, if they are, carefully dry them completely. Make sure that the main switch is turned to "0" (off), put the plug back into the outlet and then use the appliance. In the case of doubt, ask for professionally qualified help.
• Do not remove the tank when the humidifier is on.
• Do not move the appliance when it is on and when the tank is full.
• Do not place your hands, face or body directly above the steam output orifice when the appliance is on.
• Never use the humidifier without water. Use only tap water, cold water or distilled water without any additives. Only fill the tank when the appliance is off.
• Unplug the appliance when not in use.
• Do not expose the heater to the weather (sun, rain, etc.).
• Do not pull on the power cord or the appliance to unplug the appliance from the electric socket.
• If the electric cord is damaged, it has to be replaced by the supplier or an authorized service center or a professionally qualified, to avoid any risks.

INSTALLATION

- After removing the packing materials, check the integrity of the appliance; if you are unsure, do not use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children because they are potential sources of danger; but dispose of them in accordance with current law.

• Before connecting the appliance, check that the voltage shown on the data plate matches that of your electricity. In the event of incompatibility between the electric outlet and the plug of the appliance, have the outlet replaced with another more suitable type by professionally qualified personnel, who will make sure that the section of the wires of the outlet is appropriate for the absorbed power of the appliance. In general, the use of adapters or extension cords is not recommended; if their use is indispensable, they must conform to existing safety standards and their current capacity (amperes) must not be less than the maximum of the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance could upset.
• Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp edges, is not wound around the utensil, is not twisted up on itself or in the way to prevent the utensil from being pulled over. Check that you cannot trip over to prevent accidental falls or harm to persons.
• The appliance must not be positioned immediately under a socket.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Place the humidifier away from sources of heat (stoves, fan heaters, etc.), carpets, parquet floors, curtains, upholstery or delicate furniture that could be damaged by contact with water or steam. The support surface must be water-resistant and there must be at least 50 cm of free space around the appliance because water vapour can be deposited on objects that could be damaged. Make sure that the steam is not directed against a wall, which could be damaged.
• The support surface must be stable, wide (not on a shelf) and not sloping (because the appliance could tip over).
• Excessive humidity in the room could cause condensation on windows and furniture. In this case, turn off the humidifier.
• The appliance must be used at a temperature between 5 and 40 °C, with relative humidity less than 80%.
• Make sure that the appliance is working correctly: if not, turn off the appliance and have it checked by professionally-qualified personnel.
  Make sure the Steam output orifice is clean and free from foreign bodies.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a professionally qualified technician; repairs made by unqualified persons can be dangerous and render void the warranty.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or positioned incorrectly.

Attention: only fill the tank when the appliance is off and the plug is disconnected from the electric outlet.

The tank of the humidifier holds about 3 litres of water and can run autonomously for about 8 to 9 hours.

OPERATION

1. Make sure that the appliance is not connected to the mains.

2. Place the humidifier on a stable surface.

3. To fill the tank (1): remove it from the base (2) and unscrew the plug (6) by turning it counterclockwise; add fresh and clean water up at the given maximum (MAX written printed on the tooth of the hole, as shown in the figure), in the water tank hole (5) and then close it by turning the plug clockwise and tightening it carefully.

Attention: do not fill the tank beyond the level required.

3D mechanical component diagram showing a cylindrical housing with a central shaft and mounting holes (no text or symbols visible)

1. Position the tank correctly on the base, making sure that the two arrows (on the base of the tank in the back) line up.

2. Insert the plug into the socket.

3. Turn the knob (3) clockwise to the desired humidity value and the green indicator will light; the

humidity will be higher, the more the knob is turned towards the maximum position (4), after a few seconds to start exit steam.

1. When the tank is empty, the appliance automatically turns off and the red, water-tank-empty indicator light turns on.

2. To refill the tank, repeat steps 1 through 4.

3. To turn off the appliance, turn the selector knob counter-clockwise to "0-OFF" and remove the plug from the electric outlet.

4. After each use, empty any water residue in the tray (8) inside the base and dry it with a slightly damp cloth.

If the device is not to be used for a long time, remove the plug from the electric outlet and make sure the tank and inside of the base are perfectly dry.

Descaling

To extend the life of the humidifier and its accessories (ceramic filter, etc.), remove the lime scale after about 500 litres (or more frequently if the water is very hard).

Ceramic filter:

1. Remove the tank plug and unscrew the lock ring (10) from the filter (9) by turning it counterclockwise.

2. Soak the filter in a container filled with white vinegar (8 percent), acetic acid or descaling liquid for 10 minutes.

3. Carefully rinse the filter under a jet of water and make sure it is perfectly dry before screwing it in.

Water tank:

a) Add 10 to 15 drops of white vinegar (8 percent), acetic acid or descaling liquid to the inside of the tank for 5 minutes.

b) Carefully rinse the inside with water and then make sure it is perfectly dry.

Base tray:

1. Clean the inside of the tray with a soft cloth dipped in a mixture of water and vinegar and then rinse with a soft cloth dipped in plain water. Avoid the use of abrasive products that could damage the surface finish; do not use scouring pads or abrasive products. Do not wash it under running water, submerge it in water, or place it in a dishwasher. Before use, check that it is perfectly dry.

CLEANING AND MAINTENANCE

Attention: before cleaning the appliance, switch off and remove the plug from the electric outlet.

• The base tray and black gasket (7) must be cleaned periodically: empty the water, wash it with soapy water and rinse it carefully to avoid the formation of dirt and scale. Do not wash it under a jet of water or immerse in water; do not wash in the dishwasher. Avoid the use of abrasive products that could damage the gasket and the surface; do not use scouring pads or abrasive products. Before use, check that the utensil, and above all the contacts are perfectly dry.
• Failure to perform maintenance and cleaning could allow microorganisms to grow in the water. For this reason, the humidifier must be cleaned periodically to ensure correct and efficient operation. Correct, habitual cleaning of the appliance is extremely important for avoiding the formation of bacteria and algae inside.
  • Periodically check the steam output orifice is not obstructed.
  • To clean the body use a soft damp cloth; do not use abrasive products.
• A special tool is required to replace the electrical cord: contact an authorized service center, also for any repairs.
• If you decide not to use the appliance any more, we recommend making it inoperative by cutting the power cord (after making sure you have disconnected the plug from the socket) and make dangerous parts harmless if children are allowed to play with them.

Do not dispose of non-biodegradable products in the environment but dispose of accordance with current law. At the end of its working life, the product must not be d of as urban waste. It must be taken to a special local authority differentiated waste on centre or to a dealer providing this service. Disposing of a household appliance ely avoids possible negative consequences for the environment and health deriving appropriate disposal and enables the constituent materials to be recovered to obtain ant savings in energy and resources.

Trouble	Possible reasons	Shooting Way
Power lamp off, does not work	No power supply	Connect power supply, switch on
Power lamp on, no mist outlet with wind	No water in water tank	Fill water into water tank
	Security switch is too slight	Make the switch tight
Abnormal smell mist	New unit	Take out water tank, open cover, let it stay 12 hours in cool position
	Dirty water or long time staying water	Cleaning water tank, fill in clear water
Power lamp on, unit doesn’t work	Too much water in the water basin	Pour away some water from the water basin, closed the cover of water tank tightly
Mist fog is too small	Too much scum in the water basinWater is too dirty or water kept too long in the tank	Clean transducerClean water tank, change to fresh clear water
Abnormal noise	Resonant in water tank when water is too less	Fill water into water tank
	Unit is on an unstable surface	Move the unit to a stable flat surface
Mist coming out from around nozzle	There are apertures between the nozzle and water tank	Dip the nozzle in water for a while and then fix it to the socket on water tank

3D mechanical component diagram showing a cylindrical housing with internal components and an arrow pointing to a small feature (no text or symbols)

3D mechanical component diagram showing a cylindrical housing with a threaded shaft and internal components (no text or symbols)