007-876 - Vacuum Cleaner Menuett - Free user manual and instructions

Product Type	Robotic Vacuum Cleaner
Brand	Menuett
Model	007-876
Dimensions (W x D x H)	286 x 286 x 65 mm
Weight	1750 g
Rated Voltage	230 V ~ 50 Hz
Electrical Output Data	9 VDC, 500 mA
Battery Type	7.2 V NiMH
Charging Time	180–240 min
Run Time	90 min
Dust Container Capacity	0.3 L
Cleaning Surfaces	Hard, smooth surfaces and short-pile carpets
Included Accessories	Side brush, middle brush, charger
Indoor Use Only	Yes
Safety Features	Step sensor, obstacle sensor, light sensor, fault status light
Maintenance	Empty dust container after use; clean brush wheel; wipe exterior with damp cloth
Repairability	Do not disassemble; contact authorized service center for repairs
Warranty	Not specified; contact manufacturer or retailer

Frequently Asked Questions - 007-876 Menuett

How long does the battery take to charge?

The charging time is approximately 180–240 minutes. The green status light flashes during charging and stays on when fully charged.

What is the runtime of the vacuum cleaner?

The vacuum cleaner can run for up to 90 minutes on a full charge.

What surfaces can this vacuum cleaner clean?

It is designed for hard, smooth surfaces (wood, tile) and short-pile carpets. Remove the side brush before vacuuming carpets to reduce wear.

How do I empty the dust container?

Switch off the vacuum cleaner, hold it over a waste bin, press the lock button on the dust container to open the lid, and empty the contents. Close the lid securely.

What do the status lights indicate?

Green flashing: battery charging. Green steady: fully charged. Red light: brush wheel may be blocked. Red and green lights on: press the ON/OFF button for 5 seconds to reset. If persists, contact service.

How do I replace the battery?

Open the battery cover, press the catch and pull out the old battery. Insert a new 7.2 V NiMH battery, pressing the lock tabs until it clicks. Replace the cover and tighten the screw.

Can I use this vacuum cleaner on stairs?

It has a step sensor that prevents it from falling down stairs. However, always supervise the device near stairs.

How do I clean the brush wheel?

Turn the vacuum cleaner upside down, press the middle brush holder, remove the brush wheel and roller bearing. Clean the brush wheel and bearing, then reassemble.

What should I do if the vacuum cleaner stops and the red light flashes?

Check if the brush wheel is blocked. Remove the brush wheel, clear any debris, and restart the vacuum cleaner.

Is the vacuum cleaner safe to use around pets?

Keep the device under careful supervision when used near pets. Remove any objects like wires or long hairs that could entangle the brushes. Do not let pets sit on the device.

USER MANUAL 007-876 Menuett

Black circular robotic vacuum cleaner with visible scroll and control buttons (no text or symbols)

SE ROBOTDAMMSUGARE

Operating instructions (Translation of the original instructions) Important! Read the user instructions carefully before use. Save them for future reference.

Värna om miljön!

Care for the environment!

Must not be discarded with household waste! This product contains electrical or electronic components that should be recycled. Leave the product for recycling at the designated station e.g. the local authority's recycling station.

Jula reserves the right to make changes. In the event of problems, please contact our customer service.

www.jula.com

Tillverkare/Produsent/Producenci/Manufacturer

Jula AB, Box 363, 532 24 SKARA

Distributör/Distributør/Dystrybutor/Distributor

Jula Poland Sp. z o.o., ul.

• The product can be used by children from eight years and upwards and by persons with physical, sensorial or mental disabilities, or persons who lack experience or knowledge, if they are supervised or receive instructions concerning the safe use of the pressure cooker and understand the risks involved with its use.
• Keep children under supervision to make sure they do not play with the product. Do not allow children to use, clean or maintain the product without supervision.
• This is not a toy. Keep the product under careful supervision when it is used by, or near children. Store out of the reach of children.
• Use the product only for its intended purpose.
• Do not use the product if it is damaged or not working properly, or if the power cord or plug are damaged. Discard

the product if it is damaged and replace with a new one.

• The product is only intended for indoor use. Do not use the product outdoors.
• The product is only intended for household use. The product is not intended for commercial use.
• Do not use the product in humid conditions, such as in a bathroom.
• Do not use the product near a bath, shower, sink, or other receptacle containing water.
• The product is not intended to be controlled by an external timer, a separate remote control, or other equipment that can switch on the product automatically.
• Do not cover the product.
• Place the product on a level, stable surface.
• Keep the product away from flammable objects and substances.

• Never expose the product to rain, or use it in humid conditions.

• Keep your hands and the rest of your body away from the drive wheels.

• Remove fragile objects, power cords, clothes, paper etc. and fold/hang up curtains and draperies that can get entangled with the product. If the product gets entangled this can result in material damage.
• Do not use the product to vacuum up burning or glowing objects, such as cigarettes or hot ash.
• Never vacuum up flammable or toxic substances such as petrol, toner powder, acid or asbestos dust.
• The product is only intended for indoor use.
• Do not sit or stand on the product, or put any objects on it. Keep the product under careful supervision when it is used by, or near children or pets.
• Do not put the product on a table, or chair, where it can fall down.

- Do not use the product for a long time in direct sunlight or high temperatures.

BATTERY

- The charger must only be used with the supplied battery. Do not attempt to charge the battery with any other charger than the one supplied.

- The battery must be removed before the product is handed in for recycling.

- Spent batteries must be disposed of in accordance with local regulations.

- Switch off the product and unplug the power cord before cleaning and maintenance, and before removing the battery.

- Do not allow the product to absorb liquid, and do not use it on a wet surface.

- Before using the product, check the area to be vacuumed and remove any fragile objects (glass objects, lamps etc.) and objects that can fasten in the brushes

(wires, long hairs, paper, plastic etc.).

• Empty and clean the dust container after use.
- Charge the battery every 3 months if the product is not in use.
- For best battery life, fully charge the battery when the warning for discharged battery is given.
- Recycle used batteries in accordance with local regulations.

CHARGING

Make sure to do the charging in a suitable place and to use the right charger. Never connect an unknown charger or charging cable or battery that you suspect may be damaged. Otherwise there is a risk of overheating and, at worst, a fire can break out. Do not leave the battery unattended when charging.

ELECTRICAL SAFETY

- Repairs should be carried out by qualified personnel or an authorised service centre.

• Do not use the product if the power cord or plug are damaged. A damaged power cord or plug must be replaced by an authorised service centre or other qualified personnel to ensure safe use.
• Check that the mains voltage corresponds to the rated voltage on the type plate.
• Place the power cord so that there is no risk of treading on it, or tripping over it.
• Never immerse the power cord, plug or product in water or any other liquid – risk of electric shock.
• Do not use an extension cord. Connect the charger directly to a power point.
• Do not attempt to repair or dismantle the product – risk of serious personal injury.

• Only use the supplied mains adapter and charger, otherwise there is a risk of electric shock, fire and/or material damage.

• Do not touch the power cord, plug or mains adapter with wet hands.

• Avoid pulling, twisting or kinking the power cord.
• Switch off the power switch before transporting the product, or when it will not be used for some time.
• Check before charging that the mains adapter is connected to a live power point.
• Check that the dustbin is empty before use.
• The product can knock into persons or objects. Inform persons in the vicinity when the product is in use.
• The product is intended to be used to clean hard, smooth surfaces and short-pile carpets, not for rough surfaces or carpets with thick pile.
• Remove the side brush before vacuuming carpets to avoid unnecessary wear.

IMPORTANT:

- Never open the product casing – risk of electric shock.

- Pull out the plug immediately if there is a problem.

SYMBOLS

	Read the instructions.
	Approved in accordance with the relevant directives.
	Recycle discarded product as electrical waste.

TECHNICAL DATA

Rated voltage 230 V ~ 50 Hz

Electrical output data 9 VDC, 500 mA

Battery 7.2 V NiMH

Weight 1750 g

Volume dust container 0.3 l

Charging time 180–240 min

Run time 90 min

Size 286x286x65 mm

DESCRIPTION

1. ON/OFF
2. Charger connection
3. Wheel
4. Side brush
5. Middle brush
6. Holder for middle brush
7. Battery compartment
8. Step sensor
9. Lock button for dust container

10. Operating mode

11. Status light

12. Light sensor
13. Fault status light
14. Obstacle sensor
15. Handle

FIG. 1

ASSEMBLY

SIDE BRUSH

Fit the side brush beneath the corner brush.

BATTERY COMPARTMENT

Open the battery compartment and replace the battery with a new one of the same type. Press in the lock tabs to connect the battery. Align the battery cover tabs to the square holes and tighten the screws.

BRUSH WHEEL

Turn the robotic vacuum cleaner upside down on a flat surface. Press on the middle brush holder and take out the brush wheel together with the roller bearing. Clean the brush wheel and replace the bearing and brush wheel.

USE

• The sensors on the robotic vacuum cleaner stop it from colliding with obstacles and ensure that it covers all of the floor. The step sensor prevents the robotic vacuum cleaner from falling down the stairs, and the light sensor allows it to work in the dark.
• The side brushes, in combination with the roller brush at the front, ensure effective cleaning of wooden and tiled floors and short-pile carpets.

CAPACITY

The dust container has a capacity of 0.3 litres, which means the robotic vacuum cleaner seldom needs to stop because it is full. The vacuum cleaner can work up to 90 minutes per charge.

RUN MODE

Press the button to select run mode.

HOW TO USE

1. Fit the side brushes on the robotic vacuum cleaner.
2. Place the vacuum cleaner in the middle of the area to be cleaned.
3. Press the button to start the vacuum cleaner.
4. Press the button for the required mode.
5. Press any button to stop the vacuum cleaner when it is running.

NOTE:

• If the vacuum cleaner stops and the red status light starts flashing, check whether the brush wheel is blocked. If so, take out the brush wheel and clear the blockage. Put the vacuum cleaner back on the floor and start it.
• Charge the battery if the vacuum cleaner stops and the green status light starts flashing. The green status light flashes during the charging and stops flashing when the battery is fully charged.
• If the vacuum cleaner switches off, hold it over a waste paper basket and press the release button to open the lid over the dust container to empty the dust container. Switch off the vacuum cleaner.
• If the vacuum cleaner stops and the red and green status lights start flashing at the same time, press the button on the side for five seconds to switch off and then press again to start. Contact the

retailer if the vacuum cleaner still does not work properly.

CHARGING THE BATTERY

1. Plug the charger into a power point.
2. Connect the charger cable to the vacuum cleaner.
3. An audio prompt is given and green status light starts flashing to show that the battery is charging.
4. When the battery is fully charged the green light stays on.
5. Pull out the charger cable from the vacuum cleaner and unplug the charger from the power point.

NOTE:

Charge the battery if the vacuum cleaner stops and the green status light starts flashing.

Replacing the battery

1. Open the battery cover and remove the battery.
2. Press the catch with your left hand and pull out the battery with your right.
3. Insert a new battery by pressing the lock tabs and pressing the right-hand part to the left so that the battery clicks in place.
4. Replace the battery cover. Align the battery cover tabs to the square holes. The battery cover is correctly fitted when the cover is in line with the screw hole. Tighten the screw.

MAINTENANCE

MAINTENANCE AND CLEANING

• Switch off the robotic vacuum cleaner, pull out the plug, and wait until it has cooled before cleaning.

• Do not use solvents, or strong or abrasive detergent.

• Do not attempt to clean the inside of the vacuum cleaner.

• Do not attempt to dismantle or repair the vacuum cleaner. Replace the vacuum cleaner if it is not working properly.
• Never immerse the vacuum cleaner in water or any other liquid.
• Clean the outside of the vacuum cleaner with a damp cloth. Wipe thoroughly dry.
• Clean the ventilation openings with a soft brush.
• Clean the metal parts with a dry cloth.
• Clean the plastic parts with a dry cloth. Do not use strong or corrosive detergent or oil.
• Store the vacuum cleaner in a dry and cool place.

MIDDLE BRUSH

To clean the middle brush holder, press the middle brush holder and take out the brush wheel. Take out and clean the roller bearing and fit the brush wheel.

DUST CONTAINER

Switch off the robotic vacuum cleaner before emptying the dust container. Hold the vacuum cleaner over a waste paper basket, or the equivalent. Press the lock button for the dust container to open the lid and empty the dust. Close the dust container.

TROUBLESHOOTING

STATUS LIGHTS

Three status lights show the battery charge status: 10 min, 20 min and MAX (90 min).

FAULT STATUS LIGHT

Red light on

Check whether the brush wheel is blocked, and clear if necessary.

Green light flashing

Charge the battery. The green status light flashes during the charging and stops flashing when the battery is fully charged.

Red and green lights on

Press the ON/OFF button for 5 seconds to switch off the vacuum cleaner. Press the ON/OFF button again to start the vacuum cleaner. If the vacuum cleaner does not start, take it to an authorised service centre to be checked, repaired or adjusted.