AJ3080 - Alarm clock radio PHILIPS - Free user manual and instructions
Find the device manual for free AJ3080 PHILIPS in PDF.
| Product type | Radio alarm clock |
| Brand | PHILIPS |
| Model | AJ3080 |
| Category | Radio alarm clock |
| Power supply | Mains 230 V AC, backup battery 9V (type 6F22 not included) |
| Display | LED, 24-hour format |
| Radio bands | FM, MW (or LW depending on version) |
| Alarm | By radio or buzzer |
| Sleep function | Timer up to 59 minutes (Slumber) |
| Alarm repeat | Every 9 minutes (Repeat Alarm) |
| 24-hour alarm stop | Alarm Reset (stops for 24h) |
| FM antenna | Telescopic antenna (pull-out) |
| MW/LW antenna | Built-in antenna, orient the device |
| Dimensions (approx.) | Approx. 15 x 8 x 15 cm |
| Weight (approx.) | Approx. 400 g |
| Maintenance and cleaning | Soft cloth slightly damp, no solvents or abrasives |
| Safety | Unplug during prolonged absence, remove battery to avoid leaks |
| Spare parts | 9V battery type 6F22 (not included) |
| Repairability | Do not repair yourself, contact retailer or customer service |
Frequently Asked Questions - AJ3080 PHILIPS
User questions about AJ3080 PHILIPS
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Alarm clock radio in PDF format for free! Find your manual AJ3080 - PHILIPS and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. AJ3080 by PHILIPS.
USER MANUAL AJ3080 PHILIPS
Instructions for use
Mode d'emploi
This apparatus is fitted with an approved moulded 13 Amp plug. To change a fuse in this type of plug proceed as follows:
- Remove fuse cover and fuse.
- Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type.
- Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.
Note: The severed plug must be disposed to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L).
As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows:
- Connect the blue wire to the terminal marked N or coloured black.
- Connect the brown wire to the terminal marked L or coloured red.
- Do not connect either wire to the earth terminal in the plug, marked E (or 12 ) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Copyright in the U.K.: Recording and playback of material may require consent. See Copyright Act 1956 and The Performer's Protection Acts 1958 to 1972.
Norge
① ALARM RESET - to stop the active alarm for 24 hours.
② SLUMBER - to activate slumber time.
③ CLOCK:
- RUN - To return to clock time display after setting clock/alarm time.
- ALARM - To adjust/review the alarm time.
– TIME SET - To adjust clock time. - HR - To adjust the hours for the clock and alarm time.
- MIN - To adjust the minutes for the clock and alarm time.
④ SLUMBER OFF / REPEAT ALARM
- to switch off slumber.
- to stop the active alarm for a 9 minute period.
⑤ Display - To show the hours, minutes and activated alarm
⑥ BAND - to select FM-MW(LW) wave range.
⑦ VOLUME - for adjusting the volume.
⑧ TUNING - to tune to radio stations.
⑨ RADIO - to switch radio mode ON/OFF.
⑩ ALARM:
- OFF - to switch off alarm.
- RAD (io) - to activate radio for alarm setting.
- BUZ (zer) - to activate buzzer for alarm setting.
BACK PANEL
see fig. 1
⑪ Battery door - for mains backup battery.
⑫ Mains lead - for mains supply.
⑬ Pigtail aerial - for FM reception
MAINS CONNECTION
- Check if the mains voltage as shown on the type plate on the base of the set corresponds to your local mains supply.
- Connect the mains plug into the wall socket. The mains supply is now switched on and the numbers on the display will start to flash. You will need to set the correct time.
- To disconnect the set from the mains completely, withdraw the mains plug from the wall socket.
For users in the U.K.: please follow the instructions on page 2.
FM/MW (LW) RADIO
You can use the clock radio solely as a radio.
- Set the RADIO switch to ON.
- Select your wave range using the BAND switch.
- Use TUNING to find your radio station.
- Adjust the sound with the VOLUME control.
- To turn off the radio, set the RADIO switch to OFF.
To improve radio reception
- For MW (LW), the set is provided with a built-in aerial which to function best should be placed on a non-metallic surface e.g. wood, plastic. Direct the MW (LW) aerial by adjusting the position of your clock radio.
- For FM reception extend the pigtail aerial at the back of the set completely to obtain optimum reception.
CLOCK
Clock display
The time is displayed using the 24-hour clock system.
Important!
When setting the clock alarm time, for accurate hour and minute adjustment always make sure you press the HR and MIN buttons separately and not simultaneously.
Adjusting the time
- Adjust the CLOCK control to the TIME SET position.
- Press and hold down the HR or MIN buttons to set and adjust both the hours and the minutes.
- With your finger held down on HR, the hour will increase, shown as a digit from 00 to 23.
- With your finger held down on MIN, the minutes will increase, shown as a digit from 00 to 59.
- Release the HR or MIN button when you have reached the correct setting.
- To safeguard the clock time from being accidentally adjusted, turn the CLOCK control to the RUN position.
SETTING THE ALARM
General
If you wish to use the alarm, then you should first set the alarm time. There is a choice of two modes for waking you up: by buzzer or radio.
The display also indicates whether you have switched on the alarm, shown as a dot next to ALARM in the display.
ALARM ON
- Adjust the CLOCK control to the ALARM position.
- Press and hold down the HR or MIN buttons to set and adjust both the hours and minutes.
- With your finger held down on HR, the hour will increase, shown as a digit from 00 to 23.
- With your finger held down on MIN, the minutes will increase, shown as a digit from 00 to 59.
- Release the HR or MIN buttons when you have reached the correct setting.
- Adjust the CLOCK control to the RUN position to return to clock time display.
- To review your set alarm time, adjust the CLOCK control to the ALARM position.
-
To select the alarm mode you wish to be awoken by, set the ALARM switch to RAD or BUZ.
-
If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you.
- The buzzer is set at a fixed volume and cannot be adjusted.
ALARM OFF
You can switch off the alarm in three ways. Unless you choose to cancel the alarm completely, the ALARM RESET option will be automatically selected after 1 hour and 59 minutes from the time your alarm first goes off.
ALARM RESET
If you want the alarm mode to be stopped immediately, but also wish to repeat the alarm call at the same time for the following day:
- Press ALARM RESET during the alarm call.
REPEAT ALARM
This will repeat your alarm call at 9 minutes intervals.
- Press SLUMBER OFF/REPEAT ALARM.
- Press SLUMBER OFF/REPEAT ALARM again during the next call if you wish to repeat the alarm call.
- If, however, you do not press SLUMBER OFF/REPEAT ALARM again, the alarm will sound for 1 hour and 59 minutes minutes before turning itself off. Your alarm time setting will then automatically enter the ALARM RESET mode to sound at the same time next day.
Switching off the alarm completely
- Before or during the set alarm goes off, push the ALARM switch to the OFF position.
- The alarm indicator will disappear from the display.
SLUMBERING
ADDITIONAL INFORMATION
SLUMBER
The clock radio has a built-in timer device called the SLUMBER, which enables the radio to be automatically switched off after 59 minutes. SLUMBER allows you to lie back, listen and fall asleep.
SLUMBER ON
- Check that the CLOCK control is in the RUN position.
- Set the RADIO switch to the OFF position.
- Set your slumber time by pressing the SLUMBER button once.
– The display shows the slumber period 0:59.
SLUMBER OFF
- To cancel the SLUMBER function, or to switch off before the slumber period ends, press SLUMBER OFF/REPEAT ALARM.
Notes:
- The slumber function does not affect the alarm setting.
- If during SLUMBER you have turned down the volume and you have an alarm set in radio mode, make sure you have adjusted the volume loud enough to wake you up the next day.
MAINTENANCE
- If you do not intend to use the clock radio for a long time, disconnect the set by removing the plug from the wall socket. The battery should also be removed to prevent chemical leakage which will damage your set.
- To clean your set from fingerprints, dust and dirt, use a clean and soft damp cloth or chamois leather. Do not use cleaning products which contain benzene, thinner etc. as these may harm the housing.
- When a mains failure occurs, the complete clock radio will be switched off.
- As soon as the mains supply returns, the numbers on the display will start to flash. This indicates that you must set the correct time on the clock.
-
To retain the clock time and the set alarm time in the event of a mains failure or disconnection, insert a 9 volt battery, type 6F22 (not supplied) into the battery compartment: this will act as a mains back up. However, the time will not be illuminated on the clock display. Operation of the alarm and FM/MW (LW) radio are also excluded. For clarity, the battery back up is used to retain the set clock and alarm time only. As soon as the mains supply returns, the display will indicate the correct time.
-
Connect the mains plug to the wall socket.
-
Insert a battery into the battery compartment.
- Replace the battery once a year or as often as necessary.
Batteries contain chemical substances, so they should be disposed of properly.
- If a fault occurs, first check the points listed below before taking the set for repair.
- If you are unable to remedy a problem by following the hints below, consult your dealer or service centre.
WARNING: under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
PROBLEM
- POSSIBLE CAUSE
- REMEDY
No sound
– Volume not adjusted.
- Adjust the volume.
MW (LW) broadcast cannot be received properly
- Weak radio signal.
- Rotate the set for better reception and make sure the set is placed on a non-metallic surface.
Continuous crackling and hiss noise during MW (LW) reception
- Interference from other electrical equipment e.g. TV's, computers, fluorescent lamps.
- Move the clock radio away from electrical equipment.
Intermittent crackling sound during FM reception
- Weak signal.
- Adjust the pigtail aerial.
The alarm does not function
- The alarm is not set
- Set the alarm time and the alarm switch to BUZ or RAD.
– Volume too low for radio.
- Increase the volume.
The slumber does not function
- RADIO still in ON position.
- Switch RADIO to OFF position.
- Clock control in TIME SET or ALARM position.
- Adjust clock control to RUN position.
ENVIRONMENTAL INFORMATION
All unnecessary packaging material has been omitted. We have tried to make the packaging easy to separate into three mono-materials: cardboard (box), expandable polystyrene (buffer), polyethylene (bags).
Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.
The model and production numbers are located on the bottom of the clock radio. This set complies with the radio interference requirements of the European Community.
- CAUSE POSSIBLE
- REMÈDE
Absence de son
④ SLUMBER OFF / REPEAT ALARM
- POSIBLE CAUSA
- REMEDIO
No hay sonido
④ SLUMBER OFF / REPEAT ALARM
④ SLUMBER OFF/REPEAT ALARM
INDSTILLING AF VÄKKETID
Generelt
④ SLUMBER OFF / REPEAT ALARM
TORKUNTATILA TOIMINNASSA
Meet Philips at the internet:
http://www.philips.com