Q: Does the RoadJack 8 have overload protection?

Yes, the RoadJack 8 is equipped with overload protection. According to the technical specifications in the manual, the Class D amplifier of the RoadJack 8 integrates several protection systems that work together to preserve the integrity of the device: Overload protection Short-circuit protection Limiter These three protection functions ensure that the device can operate reliably, even under demanding conditions (such as during events or on tour). The amplifier has an effective power of 25 W with a peak power of 100 W, allowing it to handle signal peaks efficiently without overload.

Q: How can I tell if the Maui 5 Go is fully charged using the charge indicator?

According to the LD Systems Maui 5 Go manual, the charge indicator (LED CHARGE) operates simply: During charging: the indicator lights up when you connect the speaker to the power supply. Full charge: the indicator automatically turns off as soon as the battery reaches its maximum charge voltage. The manual does not specify any color distinction (orange, green, etc.) for this indicator - it is simply an on/off indicator. Wait for the indicator to turn off completely to confirm that charging is complete. Allow approximately 3 hours of charging when the speaker is turned off. The system also features a battery check (BATTERY CHECK) accessible via a dedicated button, which displays the exact level via status LEDs if you want to check the precise state before the indicator turns off.

Question 1

Does the RoadJack 8 have overload protection?

Accepted Answer

Yes, the RoadJack 8 is equipped with overload protection.

According to the technical specifications in the manual, the Class D amplifier of the RoadJack 8 integrates several protection systems that work together to preserve the integrity of the device:

Overload protection
Short-circuit protection
Limiter

These three protection functions ensure that the device can operate reliably, even under demanding conditions (such as during events or on tour). The amplifier has an effective power of 25 W with a peak power of 100 W, allowing it to handle signal peaks efficiently without overload.

Question 2

How can I tell if the Maui 5 Go is fully charged using the charge indicator?

Accepted Answer

According to the LD Systems Maui 5 Go manual, the charge indicator (LED CHARGE) operates simply:

During charging: the indicator lights up when you connect the speaker to the power supply.
Full charge: the indicator automatically turns off as soon as the battery reaches its maximum charge voltage.

The manual does not specify any color distinction (orange, green, etc.) for this indicator - it is simply an on/off indicator. Wait for the indicator to turn off completely to confirm that charging is complete. Allow approximately 3 hours of charging when the speaker is turned off.

The system also features a battery check (BATTERY CHECK) accessible via a dedicated button, which displays the exact level via status LEDs if you want to check the precise state before the indicator turns off.

Question 3

Can two LD Systems CURV 500 TS subwoofers be used connected in link with an FBT speaker instead of the original satellites?

Accepted Answer

No, it is not recommended to replace the original satellites of the LD Systems CURV 500 TS with a third-party FBT speaker, and here’s why. The CURV 500 TS system is designed as an integrated set where the subwoofer contains the Class D amplifier and the DSP processor that manages signal distribution, frequency allocation, and multiband protection.

Connector and power incompatibility: The satellite outputs of the subwoofer are Speakon connectors specifically designed to power the CURV 500 satellites. A generic FBT speaker likely does not have a compatible Speakon connector, and the required impedance (16 Ohm for standard satellites, 8 Ohm for duplex) must match exactly. The subwoofer allocates 300W RMS out of the total 1,000W for the satellites, a power optimized for CURV 500 satellites only.

Loss of DSP optimization: The CURV 500 TS includes 6 DSP presets specifically calibrated for 1, 2, 3, or 4 CURV 500 satellites, with tailored equalization and level management. The DSP processor will not be able to optimize the sound with a third-party speaker, resulting in poor frequency distribution and sound imbalance.

Regarding two subwoofers in link: The CURV 500 TS is a standalone system without an option for subwoofer expansion like the ES/SE models. Only the ES (Entertainer Set) and SE (Subwoofer Expansion) variants can be linked via a dedicated 5-pin XLR cable to form a stereo system with two subwoofers.

Recommendation: To maintain the integrity of your CURV 500 TS, exclusively use the original satellites (standard or duplex) provided with the system. If you need a different setup, consult LD Systems to explore compatible options or consider another system suited to your specific needs.

Question 4

Can the LD Systems CURV 500 TS subwoofer be used with an external speaker instead of the original satellites?

Accepted Answer

Yes, it is possible to use the LD Systems CURV 500 TS subwoofer with an external speaker connected in place of the original satellites. However, it is important to consider several factors to ensure optimal and safe use:

Impedance compatibility: Make sure that the impedance of the external speaker matches the specifications of the system to avoid any risk of overload or damage.
Power handling: The external speaker must be able to handle the power delivered by the subwoofer without distortion or risk of deterioration.
Sound quality: Replacing the original satellites may affect the overall sound quality. It is advisable to test the system to ensure that the output meets your expectations.

In summary, this configuration is possible but requires careful checking of the technical specifications of the external speaker. This will ensure good performance and the durability of your audio system.

User manual LD Systems Loudspeaker : user manuals and guides in PDF

Models LD Systems Loudspeaker most viewed

Other categories LD Systems

Recent questions about Loudspeaker LD Systems