How do I remove the bowl guard from the Luna WSM20L for cleaning?

Question

Accepted Answer

To remove the bowl guard from the Luna WSM20L, you must first turn off and unplug the mixer for safety reasons. Then, ensure that the bowl is completely lowered and that the agitator (whisk, paddle, or hook) is not on the control shaft. These two conditions are essential before proceeding to remove the bowl guard.

Next, turn the bowl guard to the left (counterclockwise) to open it. The bowl guard will then slide freely and can be completely removed from the appliance. Important: Never use excessive force to open or close the bowl guard, as this could damage the spring lock and safety micro-switch, which would void your warranty.

Once detached, the bowl guard can be cleaned in two ways: by hand using a sponge or cloth soaked in warm water and mild soap, then rinsed, dried, and sterilized; or directly in the dishwasher for convenience. The bowl guard is fully removable and designed for easy cleaning.

After cleaning, reinstall the bowl guard by positioning it correctly and turning it to the right until you hear a distinct click, indicating that it is locked in the closed position. Warning: the mixer will not operate if the bowl guard is not properly installed or if it remains open. Always check that the bowl guard is securely closed before restarting the appliance.

User manual Waring Commercial Food Processor : user manuals and guides in PDF

Models Waring Commercial Food Processor most viewed

Other categories Waring Commercial

Recent questions about Food Processor Waring Commercial