Question 1

My DE DIETRICH DPI4400B cooking hob turns on but does not heat, and displays a code 0d

Accepted Answer

The code 0d displayed on your DPI4400B is not documented in the official manual, but combined with a lack of heating, it likely indicates a failure of the detection system or the power circuit. Here is the diagnostic to follow:

Step 1: Initial checks (5 minutes)

Completely turn off the hob (off button), then disconnect it from electricity for at least 1 minute. This resets the electronic circuit that may display erroneous codes after an overload.
Reconnect and reactivate the hob. If the code 0d disappears and the hob heats normally, the problem was a transient overload.

Step 2: Check the compatibility of cookware

The DPI4400B only works with magnetic base cookware (steel, cast iron, induction stainless steel). Test with a steel or cast iron pot that you know is compatible. If it heats, your cookware is not suitable for induction.
Ensure that the base diameter of the cookware is at least 10 to 12 cm - a pot that is too small (less than 10 cm) may not be detected by the induction sensor, which blocks heating.
Make sure the bottom of the cookware is flat and rests properly on the cooking zone.

Step 3: Check ventilation and connections

Check that the ventilation grilles (at the bottom and back) are not blocked. Clean them gently with a dry cloth. Poor air circulation can cause the electronic circuit to overheat and display error codes.
If the hob is built under an oven, the hob may display the code F7 (overheating) which prevents heating. Increase the ventilation opening of your built-in furniture (minimum 8 cm x 5 cm on the side).
Check that all electrical connection cables are properly connected.

Step 4: Test another cooking zone

Try heating another zone of the DPI4400B. If this zone heats normally, the problem only concerns the defective zone - contact customer service for a circuit replacement.
If all zones display the code 0d and do not heat, it is a defect of the central power circuit or the control panel.

If the problem persists after these steps: The code 0d associated with a lack of heating very likely indicates a failure of the electronic board or the power circuit. Contact customer service at 09 69 39 34 34 (toll-free number + call charges). Have the serial number of your device ready, visible on the nameplate under the hob. Avoid continuing to use the hob while this code is displayed.

Question 2

How to disable the child lock on the DE DIETRICH DTI1053X hob?

Accepted Answer

If your DE DIETRICH DTI1053X hob displays a lock symbol and does not respond to commands, it means that the child protection is activated.

To disable the child lock:

Press and hold the K button until you hear a double beep
The lock symbol will disappear and the appliance will become operational again

To reactivate the child protection later, press and hold the K button until you hear a single beep.

Note that this model also offers a temporary lock for cleaning, accessible via the Clean Lock function, which allows for safe maintenance without fully activating the child protection.

User manual DE DIETRICH Hob : user manuals and guides in PDF

Models DE DIETRICH Hob most viewed

Other categories DE DIETRICH

Recent questions about Hob DE DIETRICH