Question 1

How to open and access the components of the MIELE W 196 washing machine?

Accepted Answer

The MIELE W 196 has several components accessible according to your needs:

Open the loading door

Grab the handle located under the door and pull to open it. Note that the door automatically locks during the wash cycle and unlocks automatically at the end of the program or by pressing the Start/Stop button.

Access the detergent drawer

Pull the detergent drawer until you feel resistance, then press the release button while continuing to pull the drawer towards you to completely remove it from the machine. This allows you to clean or refill the detergent compartments.

Access the drain filter

Press the access panel to the drain pump located at the bottom of the machine. The panel will spring open. This access allows you to clean a clogged filter or perform an emergency drain.

Access the TwinDos panel (if equipped)

An access panel located under the detergent drawer allows you to insert or remove the automatic detergent dosing containers by pressing to open it.

Important: always ensure that the machine is completely stopped before accessing its internal components. Never insert your hands into the rotating drum.

Question 2

How to resolve a spinning issue on a MIELE W 196 washing machine?

Accepted Answer

The spinning of the MIELE W 196 washing machine can be affected by several factors. Here are the essential checks to perform, starting with the most common causes:

Check the balance of the laundry in the drum — The main reason for insufficient spinning is load imbalance. If the laundry accumulates on one side of the drum, the machine automatically reduces the spinning speed for safety reasons. For a capacity of 8 kg, mix large and small items (for example: sheets with t-shirts, towels with underwear) to promote an even distribution. Also, ensure that the laundry is not overloaded: the drum should be filled to a maximum of 80-85% to allow free movement.

Check the drainage filter and water evacuation — A clogged filter prevents water from draining properly and can block the spinning. Access the drain filter through the lower panel of the machine (access below the door), slowly drain the water, then clean the filter to remove lint, buttons, or other foreign objects. Also, check that the drain hose is neither bent nor blocked and that it does not exceed 1 meter in height (beyond that, the pressure decreases too much).

Check the leveling of the machine — If the MIELE W 196 is not perfectly level, it may vibrate and cause poor laundry distribution. Ensure that all four feet are resting properly on the floor, then adjust them if necessary to make the machine completely stable. An unstable machine also reduces spinning performance.

Check the detergent dosage — Excessive foam (due to an overflow of detergent) can prevent spinning. Make sure to follow the recommended dosage on the detergent packaging based on the load and degree of soiling. If too much foam appears, reduce the dosage by 10% for the next wash.

Select the correct program and spinning speed — Some programs include reduced spinning speeds (for example, Wool at 1200 rpm, Silk at 600 rpm). If your program shows a low spin, manually increase the speed via the Spin speed button up to a maximum of 1600 rpm for cotton, or according to the type of fabric. Don't forget to confirm with the OK button.

If after these checks the spinning still does not work properly, a more serious technical issue (faulty pump, damaged spin motor, or electronic system) may be at fault. Contact an authorized MIELE technician for an accurate diagnosis and appropriate repair.

Question 3

What should I do if my Miele W1 - WMG 120 washing machine does not start?

Accepted Answer

If your Miele W1 - WMG 120 washing machine does not start, several causes may be behind the issue. Here are the checks and actions to take to try to resolve this situation:

1. Check the power supply

Make sure the machine is properly plugged into a functioning electrical outlet.
Test the outlet with another device to confirm it is supplying power.
Check that the circuit breaker or fuse related to the outlet has not tripped.

2. Check the door

The door must be closed properly and locked for the machine to start.
Open and close the door, ensuring it clicks into place.

3. Program selection and starting

Select an appropriate washing program.
Press the start button to begin the cycle.

4. Observe the control panel

Look for any blinking lights or error messages displayed.
These indications can help identify a specific malfunction.

If after these checks your washing machine still does not start, it is possible that a technical issue requires the intervention of a professional.

User manual MIELE Washing machine : user manuals and guides in PDF

Models MIELE Washing machine most viewed

Other categories MIELE

Recent questions about Washing machine MIELE