How to configure the DIP switches of the WAECO SinePower MSI1312?

Question

Accepted Answer

The WAECO SinePower MSI1312 has eight DIP switches (S1 to S8) that allow you to customize the operation of the inverter according to your electrical installation and needs.

Configuration of the DIP switches

S1 and S2 - Mains voltage: These two switches allow you to select the appropriate input voltage for your region (200V, 220V, 230V, or 240V). Refer to the configuration table to find the correct combination.

S3 - Network frequency: OFF position for 50 Hz (standard in Europe); ON position for 60 Hz (standard in North America). Only change this setting if your network uses a different frequency.

S4, S5, S6 - Energy-saving mode: These three switches set the power threshold below which the inverter operates in energy-saving mode to reduce battery discharge. The thresholds vary according to your configuration (between 60W and 300W).

S8 - Activation of custom settings: This is the most important switch. ON position activates factory settings (DIP settings ignored); OFF position activates your custom settings (S1-S7). Your changes will only take effect if S8 is in the OFF position.

Tip: After any modification of the DIP switches, ensure that S8 is in the OFF position for your settings to be recognized by the inverter.

User manual WAECO Camping : user manuals and guides in PDF

Models WAECO Camping most viewed

Other categories WAECO

Recent questions about Camping WAECO