My WAECO PerfectView CAM80 camera displays nothing on my Pioneer unit, the screen remains black. What should I do?

Question

Accepted Answer

This black display issue on a Pioneer unit is generally related to a poor connection or lack of power. Here are the checks to perform:

1. Check the camera's power supply

The PerfectView CAM80 requires a power supply of 11-16V DC to operate. This voltage should typically come from the reverse light of your motorhome. Check that:

The power cable is properly connected to the reverse light (or to an active 12V source)
There is no corrosion or loose wire at the connectors
The reverse light is functioning correctly (test the reverse bulb if visible)

2. Check the video RCA cable

The camera uses a 6-pin connector with video transmission via RCA cable. Ensure that:

The yellow RCA cable (video) is connected to the correct video input of the Pioneer unit
The cable is not reversed or partially inserted
The cable is not damaged (check visually)

3. Pioneer unit settings

Even if the cable is properly connected, the Pioneer unit must be configured to display the rear camera. Refer to your Pioneer unit's manual to:

Activate the rear camera mode in the display settings
Check that the reverse signal (control wire) is connected to the unit

4. Test the camera

To verify that the camera is functioning, you can test it in isolation by powering it directly with 12V (vehicle battery) and viewing the RCA output on a small portable screen if you have one. The PerfectView CAM80 has excellent low-light sensitivity (less than 1 lux) and should display a clear image, even in dark conditions.

If after these checks the screen remains black, it is possible that the camera is defective or that the video input of the Pioneer unit is incompatible with the PAL standard used by this camera.

User manual WAECO Surveillance Camera : user manuals and guides in PDF

Models WAECO Surveillance Camera most viewed

Other categories WAECO

Recent questions about Surveillance Camera WAECO