Q: How to configure a scenario on the LEGRAND 845 27 switch?

Configuring a scenario on the LEGRAND 845 27 is done through a three-step learning procedure: Configuration procedure: Initiate learning: Press the learning button on the LEGRAND 845 27 (the main switch, or "leader") Add the actors: Once in learning mode, press the learning buttons of each shutter/blind you wish to synchronize with this scenario Validate the scenario: Press the learning button on the 845 27 again to save the scenario Once configured, the three buttons on the switch (Up, Stop, Down) will control all the registered shutters in a synchronized manner. You can also modify existing scenarios, delete specific commands, or reset the device by holding the learning button down for about 5 seconds. The LEGRAND 845 27 also accepts external signals via its E1 and E2 inputs (twilight sensors, wind/sun safety controls, timers) to enhance your scenarios.

Question 1

How to configure a scenario on the LEGRAND 845 27 switch?

Accepted Answer

Configuring a scenario on the LEGRAND 845 27 is done through a three-step learning procedure:

Configuration procedure:

Initiate learning: Press the learning button on the LEGRAND 845 27 (the main switch, or "leader")
Add the actors: Once in learning mode, press the learning buttons of each shutter/blind you wish to synchronize with this scenario
Validate the scenario: Press the learning button on the 845 27 again to save the scenario

Once configured, the three buttons on the switch (Up, Stop, Down) will control all the registered shutters in a synchronized manner. You can also modify existing scenarios, delete specific commands, or reset the device by holding the learning button down for about 5 seconds.

The LEGRAND 845 27 also accepts external signals via its E1 and E2 inputs (twilight sensors, wind/sun safety controls, timers) to enhance your scenarios.

Question 2

Why does my LEGRAND 845 27 switch operate randomly and not always control the same shutters?

Accepted Answer

A LEGRAND 845 27 switch that operates randomly and does not always control the same shutters may be due to several causes. Here are the points to check and possible solutions:

1. Checking electrical connections

Ensure that all connections of the switch and the roller shutters are tight and free of corrosion. Loose or poorly connected wires can cause erratic operation.

2. Checking the shutter controls

Test each shutter individually to see if it responds correctly to the command. This helps identify if the problem comes from a specific shutter or the switch itself.

3. Electrical or electronic interference

Interference from other electronic devices or nearby electrical installations can disrupt the control signal. Try moving away or temporarily turning off other devices to see if the problem persists.

4. Capacity and load supported

Check that the total load of the controlled shutters does not exceed the maximum capacity supported by the LEGRAND 845 27 switch. An overload can lead to random operation.

5. Resetting the switch

If the switch has a reset function, perform it to return to factory settings. This can correct configuration errors or temporary bugs.

6. Wear or hardware failure

If after all these checks the problem persists, it is possible that the switch is defective or worn. In this case, replacement or technical intervention may be necessary.

By following these steps, you can diagnose and potentially resolve the random operation issue of your LEGRAND 845 27 switch.

User manual LEGRAND Electrical switch : user manuals and guides in PDF

Models LEGRAND Electrical switch most viewed

Other categories LEGRAND

Recent questions about Electrical switch LEGRAND