411-129 - Heating Anslut - Free user manual and instructions

Product Type	Oil-filled radiator
Brand	Anslut
Model	411-129
Manufacturer	Jula AB
Rated Voltage	230 V ~ 50 Hz
Maximum Power Output	2000 W
Power Mode I	1000 W
Power Mode II	1200 W
Power Mode III	2200 W (both switches on)
Temperature Control	Adjustable thermostat knob
Status Lights	Indicate active power modes
Feet Installation	Included with U-shaped screws and wing nuts
Safety Distance	At least 90 cm from flammable materials
Overheating Protection	Do not cover – risk of overheating
Intended Use	Indoor, well-insulated areas or occasional use
Environmental	Recycle at designated station; do not discard with household waste
Maintenance	Wipe with damp cloth, dry with dry cloth. Do not use wax or polish
Power Cord	Keep away from heat, sharp edges, moisture; out of reach of children
Oil Reservoir	Never open; contact dealer if leakage occurs
Model Identifier	411129

Frequently Asked Questions - 411-129 Anslut

How to install the feet on the heater?

Turn the appliance upside down, position the feet, lock them with the supplied U-shaped screws and wing nuts, then tighten the screw connections. Finally, turn the appliance upright.

How do I select the power mode?

The heater has two switches (I and II). Switch I gives 1000 W, switch II gives 1200 W. Turn both on for 2200 W (Mode III). The corresponding status light will illuminate.

How to set the temperature?

Rotate the temperature control knob clockwise for higher temperature and anticlockwise for lower temperature. The status light will turn on when the heater is operating.

How should I clean the heater?

Unplug the power cord before cleaning. Wipe the appliance with a damp cloth, then dry with a dry cloth. Do not use wax or polish as they can discolour the heater.

What safety precautions should I take?

Never cover the appliance – fire risk. Keep at least 90 cm away from furniture, curtains, and other flammable materials. Do not use outdoors or near water. Keep children supervised.

Can I use the heater in a bathroom?

No, the manual states: 'Do not use the appliance near baths, showers or swimming pools.' It is intended for indoor use only in dry areas.

What does the status light indicate?

The status light shows that the heater is receiving power and the thermostat is calling for heat. Separate lights indicate which power mode (I, II, or III) is active.

Is the heater suitable for continuous use?

The manual states this product is only intended for well-insulated areas or occasional use. For prolonged use, ensure proper ventilation and follow all safety instructions.

What should I do if there is an oil leak?

Never open the oil reservoir. Contact your dealer immediately if you notice any oil leakage. Repairs must be carried out by an authorised service centre.

How to store the heater when not in use?

Switch off the appliance, unplug the power cord, and wait until it has completely cooled before moving. Use the handle to carry it. Store in a dry place.

USER MANUAL 411-129 Anslut

Black electric heater with coiled heat pipes and control panel (no visible text or symbols)

This product is only intended for well-insulated areas, or occasional use.

Värna om miljön!

Care for the environment!

Must not be discarded with household waste! This product contains electrical or electronic components that should be recycled. Leave the product for recycling at the designated station e.g. the local authority's recycling station.

SE - Bruksanvisning i original

EN - Operating instructions (Translation of the original instructions)

Jula reserves the right to make changes. In the event of problems, please contact our service department. www.jula.com

Tillverkare/ Produsent / Produenci/ Manufacturer

Jula AB, Box 363, 532 24 SKARA

Distributör/ Distributör/ Dystrybutor/ Distributor

Jula Poland Sp. z o.o., ul. Malborska 49, 03-286 Warszawa, Polska

Date of production: 2017-11-15

© Jula AB

SÄKERHETSANVISNINGAR

Exterior view of a black flat-screen electric heater with labeled components (no text or symbols beyond labels)

Black electric heater with coiled heat sink and two labeled buttons (no text or symbols visible)

Black electric heater with coiled heat sink and control panel (no visible text or symbols)

Read the User Instructions carefully before use.

Save these instructions for future reference.

• Never cover the appliance – fire risk.
  • Do not place the appliance closer than 90 cm to furniture, curtains or other flammable materials.
• Do not dismantle the appliance, or attempt to modify or repair it.
• Keep the appliance under careful supervision when it is used by, or near children.
• Keep the power cord away from heat, sharp edges and moisture. Keep the power cord out of the reach of children.
• Do not use the appliance outdoors.
• Do not use or place the appliance on, or near hot surfaces.
• Do not use the appliance if it is damaged or not working properly, or if the power cord or plug are damaged.
• Never remove the control panel.
  • The appliance is only intended for indoor use.
• Wipe off any residual oil from the appliance.
• A damaged power cord must be replaced by an authorised service centre, or qualified person, to ensure safe use.
• Do not place the appliance directly below a power outlet.
• Do not use the appliance near baths, showers or swimming pools.
• Never open the oil reservoir. Any repairs should be carried out by an authorised service centre or qualified person. Contact your dealer immediately in the event of any oil leakage.
  • Recycle the appliance in accordance with local regulations.
• WARNING: Do not cover the appliance, this can cause it to overheat.
• The appliance is not intended to be used by persons (children or adults) with any form of functional disorders, or by persons who do not have sufficient experience or knowledge on how to use it, unless they have received instructions concerning the use of the appliance from someone who is responsible for their safety.
• Keep children under supervision to make sure they do not play with the appliance.

TECHNICAL DATA

Rated voltage	230 V ~ 50 Hz
Output	2000 W
Power consumption in mode I	1000 W
Power consumption in mode II	1200 W
Power consumption in mode III	2200 W

DESCRIPTION

Exterior view of a black flat-screen electric heater with labeled components (no text or symbols beyond labels)

1. Power switch/Output mode selector
2. Temperature selector

OPERATION

Installation

Remove all parts from the packaging.

1. Turn the appliance upside down.
2. Put the feet on the radiator.
3. Lock the feet in place with the supplied U-shaped screws and wing nuts.
4. Tighten the screw connections.
5. Turn the appliance upright and stand it on its feet.

Positioning

NOTE: Check that the mains voltage corresponds to the rated voltage on the type plate. Do not place the appliance closer than 90 cm to furniture, curtains or other flammable materials.

1. Check that the temperature control is set to 0 and the switches are switched off.
2. Plug in the power cord.
3. Set the required temperature with the temperature control. Turn the temperature control clockwise for higher temperature and anticlockwise for lower temperature. The status light goes on.

Power modes

1. When switch I is switched on the status light for mode I goes on.
2. When switch II is switched on the status light for mode II goes on.
3. When both switch I and switch II are switched on the status light for mode III goes on.
4. After use, switch all the switches off and turn the temperature control to 0 and unplug the power cord.

NOTE: Switch off the appliance, unplug the power cord and wait until the appliance has completely cooled before moving. Use the handle to move the appliance.

MAINTENANCE

• Unplug the power cord before cleaning and when the appliance is not in use.
• Wipe the appliance with a damp cloth, and then dry with a dry cloth.
• Do not use wax or polish, this can discolour the appliance.

Model identifier: 411129
Item Symbol Value Unit Item Unit
Heat output Type of heat input, for electric storage local space heaters only (select one)
Nominal heat output P	nom	0,618 kW	Manual heat	heat charge control, with integrated thermostat No
Minimum heat output (indicative)	Pmin	0	kW	Manual heat charge control with room and/or outdoor temperature feedback	No
Maximum continuous heat output	Pmax,c	0,618 kW		Electronic heat charge control with room and/or outdoor temperature feedback	No
Auxiliary electricity consumption				Fan assisted heat output No
At normal heat output elmax N/A kW Type of heat output/room temperature control (select one)
At minimum heat output elmin N/A kW				Single stage heat output and no room temperature control	No
In standby mode	eISB	N/A	kW	Two or more manual stages, no room temperature control	No
				With mechanic thermostat room temperature control	Yes
				With electronic thermostat room temperature control	No
				Electronic room temperature control plus day timer	No
				Electronic room temperature control plus week timer	No
				Other control options (multiple selections possible)
				Room temperature control, with presence detection	No
				Room temperature control, with open window detection	No
				With distance control option	No
				With adaptive start control	No
				With working time limitation	No
				With black bulb sensor	No
Contact details	www.jula.com