8086 Duetta - Vacuum Cleaner IMETEC - Free user manual and instructions

USER MANUAL 8086 Duetta IMETEC

Operating instructions

Tel. +39.035.688.111 Fax +39.035.320.149

IMETEC

TYPE I9701

GUIDA ILLUSTRATIVA

ILLUSTRATIVE GUIDE

GUIA ILUSTRADO

ILUSTROVANY PRÚVODCE

KÉPES ÚTMUTATÓ

ILUSTROVANY SPRIEVODCA

SLIKOVNI VODNIK

Dear customer, IMETEC thanks you for having purchased this product. We are certain you will appreciate the quality and reliability of this appliance, designed and manufactured with customer satisfaction in mind. This instruction manual has been drawn up in compliance with the European Standard EN 62079.

IMPORTANT! Instructions and warnings for safe use

Before using this appliance, carefully read the instructions and in particular the safety warnings, which must be complied with. Keep this manual and illustrative guide with the appliance for future consultation. Should you pass the appliance on to another user, make sure to also include this documentation.

NOTE: should certain parts of this booklet be difficult to understand or should doubts arise, contact the company before using the product, at the address indicated on the last page.

INDEX

SAFETY WARNINGS PAGE 8

SYMBOLS PAGE 10

DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES (Fig. A) PAGE 10

ASSEMBLY PAGE 10

ACCESSORIES PAGE 11

USE PAGE 11

MAINTENANCE PAGE 12

STORING AND CARING FOR THE PRODUCT PAGE 13

TROUBLESHOOTING PAGE 13

DISPOSAL PAGE 14

ASSISTANCE AND WARRANTY PAGE 14

ILLUSTRATIVE GUIDE I-II-III

TECHNICAL DATA III

SAFETY WARNINGS

• After having removed the appliance from its packaging, verify its integrity based on the drawing and any presence of damage caused by transport. If in doubt, do not use the appliance and contact an authorised service centre.
• Do not let children play with the packaging! Keep the plastic bag out of the reach of children - risk of suffocation!
  • Before connecting the appliance, check that the technical data (8F) match

EN

the mains supply. The identification technical data (8F) are found on the appliance and on the power supply/battery charger (if present).

- This appliance must be used only for the purpose for which it was designed, namely as a vacuum cleaner for home use. Any other use is considered not compliant and therefore dangerous.

- This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the risks involved. Children must not play with the appliance. The appliance cannot be cleaned or serviced by children without adult supervision.

- Do NOT use the vacuum cleaner to vacuum:

• burning ashes, cigarette butts, etc.;
• liquids, such as carpet cleaners;
• sharp or hard objects, such as nails or large glass shards;
• fine powder, such as cement;
• toner powder (for laser printers, copy machines, etc.).

- ✉ NEVER use the vacuum cleaner without inserting the dust bag, dust container or filter.

- Do NOT use the appliance with wet hands, damp feet or barefoot.

- Do NOT pull the power cable or the appliance itself to remove the plug from the socket.

- Do NOT expose the appliance to humidity or weather conditions (rain, sun, etc.).

- Always disconnect the appliance from the mains supply before cleaning or performing maintenance and when the appliance is not in use.

- If the appliance is faulty or malfunctions, switch it off and do not tamper with it. Any repairs must only be carried out by an authorised technical service centre.

- If the power cable is damaged it must be replaced by an authorised technical service centre, so as to prevent all risks.

- ✉ NEVER pull or lift the appliance by its cable.

- NEVER submerge the appliance in water or other liquids.

- ✉ NEVER direct the flexible hose, pipe or any other accessory towards eyes or ears and do not put them in your mouth when they are connected to the vacuum cleaner.

EN

• Always use the appliance with a motor protection filter to prevent damaging the motor and the vacuum cleaner.
• The power cable must always be fully unwound to prevent hazardous overheating.

SYMBOLS

	Warning ON/OFF switch
	Prohibited Protection class II

DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (Fig. A)

Refer to Figure [A] in the illustrative guide to verify your appliance equipment. All the figures are on the cover pages of these instructions for use

1. Handle
2. Cable winding system

2A Turning upper cable hook

2B Fixed lower cable hook

1. Fastening screw
2. Power cable with plug
3. Manual mini-vacuum release buttons
4. Suction inlet
5. Multi-surface brush
6. Manual MINI-VACUUM

8A Dust compartment release key

8B Dust collection compartment

8C Protective filter mesh
8D Cyclone filter
8E Motor filter
8F Technical data

1. ON/OFF switch

2. Set of accessories

10A Accessory support
10B Dusting nozzle
10C Crevice nozzle
10D Upholstery nozzle

ASSEMBLY

• Loosen the fastening screw (3) of the handle (1) and remove it.
• Attach the handle (1) to the body of the appliance, taking care to assemble it correctly [Fig. B1].
• Insert the fastening screw (3) and tighten it clockwise [Fig. B2] using a screwdriver.
• Attach the multi-surface brush (7) to the suction connection (6) [Fig. B3].
• Put the various accessories (10B+10C+10D) on the accessory support 10A [Fig. B4].
• Secure the accessory support (10A) by pressing it gently into place on the back of the stick body [Fig. B5].

ACCESSORIES

Your appliance is equipped with the following attachments:

• Multi-surface brush (7): The multi-surface brush (7) is suitable for all surfaces: ceramic, marble, parquet and carpets.

• SET OF ACCESSORIES (10):

• Accessory Support (10A): to store the accessories and attach them to the body of the stick.

• Dusting nozzle (10B).
• Nozzle for crevices (10C): to clean corners and slots, such as radiators, skirting boards and blinds.
• Upholstery nozzle (10D): to clean sofas, armchairs, upholstered chairs and curtains.

USE

USING IT AS A STICK VACUUM CLEANER

Fully unwind the power cable (4). To do so, turn the upper cable hook (2A) downwards [FIG. C1].

Using the vacuum cleaner with the cable fully or partly wound involves an overheating hazard!

NOTE:

1. Bear in mind that a new appliance can develop odours the first few times it is used. These odours are harmless and disappear shortly afterwards. Ventilate the room.

2. Transparent parts can become opaque, due to use.

3. Insert the plug into the socket, while holding the appliance by the handle to prevent it from falling in the event that it was not stored in the OFF position.

4. Press the ON/OFF button (9) once to switch the vacuum cleaner on or off.
5. Switch the appliance off after use, by pressing the ON/OFF button (9) and disconnect the plug from the socket.
6. Wind the cable (4) round the two hooks (2A and 2B) [Fig. D1]. With the clamp on the plug, it is possible to secure it to the cable.

USING IT AS A MANUAL MINI-VACUUM

• Fully unwind the power cable (4). To do so, turn the upper cable hook (2A) downwards [Fig. C1].
• Detach the mini-vacuum (8) from the body of the stick by pressing the release buttons (5) [Fig. D1].
• Attach the suitable accessory (10) for the surface requiring cleaning and connect it to the mini-vacuum [Fig. D2].
• Press the ON/OFF switch (9) once to turn the vacuum cleaner on, and start cleaning.
• When you have finished, press the ON/OFF switch (9) to turn it off and take the plug

EN

out of the power socket.

• Put the mini-vacuum (8) back on the body of the stick vacuum and press the handle of the mini-vacuum until the click tells you that it is correctly in place [Fig. D1].
• Wind the cable (4) round the two hooks (2A and 2B) [FIG. C1]. With the clamp on the plug, it is possible to secure it to the cable.

MAINTENANCE

ATTENTION! Turn the appliance off and take the plug out of the power socket before opening the dust collection system!

Make sure all cleaned parts are completely dry before reusing the appliance.

CLEANING THE APPLIANCE

When necessary, clean the appliance with a damp cloth.

ATTENTION!

DO NOT USE SOLVENTS OR OTHER AGGRESSIVE OR ABRASIVE DETERGENTS. THIS CAN DAMAGE THE SURFACE.

CLEANING THE MULTI-SURFACE BRUSH (7)

With the motor ON, rub the lower part of the brush with your hand to remove the dust and fluff, which will be drawn.

CLEANING THE DUST COLLECTION SYSTEM (8)

ATTENTION! Empty the dust collection compartment (8B) and clean the filtering system (8C, 8D, 8E) after every use.

• Clean the dust collection system following the instructions below and paying attention to the figures in the illustrative guide.
• Detach the mini-vacuum (8) from the body of the stick by pressing the release buttons (5) [Fig. D1].
• Press the release button (8A) [Fig. E1] and take down the dust container (8B+8C+8D) [Fig. E2].
• Take out filtering system 8C and 8D [Fig. E3] and empty out the contents of the dust container (8B).
• Separate the filter protection mesh (8C) from the cyclone filter (8D), and clean them by carefully shaking and brushing away the dust. To do so, use a soft brush to prevent any damage.
  • Take out the motor filter (8E) and clean it.
• If necessary, rinse the parts of the dust collection system under running water. Before putting them back in place, make sure they are completely dry.

ATTENTION!

Let the filter dry for at least 24 hours after washing it. Do not reinstall the filter if it is damp!

If suction does not increase after cleaning the dust collection compartment (8B) and the filtering system (8C+8D+8E), replace the filter 8D with a new one.

NOTE:

• Replace the filter in the event it is damaged or impossible to clean.
• Replace the filter at least once a year.
• Failure to clean or replace the filter will make the manufacturer's warranty null and void.

Put the filtering system back inside (8C+8D) the dust compartment (8B) and attach it back on the mini-vacuum (8), being careful to hook it onto the bottom fitting and making the release button click (8A).

STORING AND CARING FOR THE PRODUCT

When the appliance is not used, unplug it from the socket and store it in a dry and dust-free place.

TROUBLESHOOTING

PROBLEM SOLUTION
The appliance does not go on.	·Ensure that the plug is connected to the socket. Make sure the ON/OFF button has been pressed (19).
The appliance switches off during use and does not switch back on again.	·The vacuum cleaner is equipped with a protective motor thermostat that shuts off the appliance in the event of overheating! (caused by obstructing objects or a clogged dust collection system). If triggered, switch the appliance off by pressing the ON/OFF switch (9) and let it cool down completely for a few hours. Remove any dust or the obstructing object before restarting the appliance.
The vacuum cleaner does not suction well.	·The dust collection system is full: empty the dust collection compartment (8B).·The filter is clogged: clean or replace the filter (8D).·The filter is not fastened correctly: make sure that the filter (8D) is fitted correctly.

DISPOSAL

The product is packaged in recyclable materials. Dispose of it in compliance with the environmental protection standards.

The appliance must be disposed of in compliance with EU standard 2002/96/EC. The recyclable materials contained in the appliance must be collected to prevent environmental pollution. For further information contact the local waste authority or the appliance retailer.

ASSISTANCE AND WARRANTY

To request repairs or purchase spare parts please contact IMETEC's authorised customer service centre on the Toll-Free Number below or via the website.

The appliance is covered by the manufacturer warranty. For details, read the attached warranty sheet.

Failure to comply with the instructions for use and maintenance provided in this manual will render the manufacturer's warranty null and void.

MANUAL DE INSTRUÇÕES PARA O USO DO ASPIRADOR DE PÓ

PROBLEMAS E SOLUÇÕES PÁG. 20

ELIMINAÇÃO

PÁG. 21

ASSISTÊNCIA E GARANTIA

PÁG. 21

GUIA ILUSTRADO

I-II-III

DADOS TÉCNICOS

III

AVISOS SOBRE A SEGURANÇA

PROBLEMAS E SOLUÇÕES

ASSISTÊNCIA E GARANTIA

POPIS PŘÍSTROJE A PŘÍSLUŠENSTVÍ (Obr. A) STR. 24

MONTÁŽ STR. 24

PŘÍSLUŠENSTVÍ STR. 25

ZPŮSOB POUŽITÍ STR. 25

ÚDRŽBA STR. 26

SKLADOVÁNÍ A PÉČE O VÝROBEK STR. 27

PROBLÉMY A ŘEŠENÍ STR. 27

LIKVIDACE STR. 28

SERVISNÍ SLUŽBA A ZÁRUKA STR. 28

ILUSTROVANÝ PRŮVODCE I-II-III

TECHNICKÉ ÚDAJE III

BEZPEČNOSTNÍ UPOZORNĚNÍ

POPIS PŘÍSTROJE A PŘÍSLUŠENSTVÍ (Obr. A)