Luna - Bottle warmer Neno - Free user manual and instructions

USER MANUAL Luna Neno

1. Carefully read the instrucons before use.

2. To avoid ooding of the sterilizer, do not clean it under running water.

3. Keep the device away from children and babies. Unplug the sterilizer if it is

not used for a long me.

4. If the plug or cable is damaged, return it to Neno service, or contact an

authorised representave.

5. Do not pour milk or food directly into the warming vessel.

6. Make sure that the heang me is not too long so that the food does not

lose its nutrional value.

7. Before feeding your baby, check the temperature of the food on your wrist.

8. The steriliser may be used by adults and children over 8 years of age under

adult supervision. Adults with limited physical, mental and sensory abilies may use the device under the supervision of another adult.

9. Cleaning and maintenance should be carried out by adults or children over

8 years of age under adult supervision. Keep all parts of the appliance away from children under 8 years of age.

10. Tips: for improved user comfort, before rst use wipe the sterilizer with a

wet wipe. Wash the bole basket, pour dislled water into the heater and switch on the sterilizaon funcon. Aer sterilizaon pour out the water and leave the device to dry.

03. CLEANING AND MAINTENANCE

1. Unplug the unit from the outlet and allow to cool before cleaning.

2. Be careful not to damage the heang surface with sharp metal tools.

3. If scale accumulates, add citric acid or vinegar to the water and boil using

the sterilisaon funcon.

4. Cleaning: remove the top cover from the body and wipe the surface of the

device with a damp, so cloth.

5. It is recommended to clean the device every 10-15 days.

6. Aer cleaning the device, allow it to dry. Do not immerse the body in water

7. Every two months it is recommended to pour a mixture of citric acid and

vinegar or detergent over the dish and leave it for 10 minutes, then rinse it under running water.

4. Reduce me/temperature

6. Increase me/temperature

1. The device will automacally go to sleep when the plug is inserted into

2. Press the power buon to turn the device on or o. When turned on, the

funcon indicators will illuminate on the screen.

3. Press the „Mode” buon to select the quick heat, reheat/thaw, reheat food

or sterilise funcons. a. Fast heang: insert the basket into the steriliser, pour in 40 ml of dislled water and then insert the feeding bole and replace the lid. Press the „Mode” buon unl „Fast” lights up and the screen shows a temperature of 37°C. In this mode you can set a me between 1 and 8 minutes, which you can do using the corresponding buons. The word „Fast” will light up 2 mes, the appliance will make a sound and start heang. During he- ang, the screen will show the remaining heang me and the displayed temperature of 37°C is the target bole temperature. Check the chart provided with the product or SEE FIG.C to adjust the me according to the amount of food to be heated. When the rapid heang is nished, the machine will beep 5 mes and will automacally switch on the 24 hour „Milk” mode, to maintain the temperature of the heated food, add dislled water to the 160ml (MAX) line. If the appliance starts working without water it will automacally switch o and can only be used again once it has cooled down to room temperature, thus prolonging the life of the appliance. Check the temperature of the warmed food before feeding it to your baby. b. Table descripon SEE FIG. C C.1 Recommended me for rapid heang mode | C.2 Bole material | C.3 Plasc | C.4 Glass | C.5 Inial temperature | C.6 Food NOTE: Actual me may vary due to bole material, bole wall thickness, ambient temperature, inial food temperature, bole temperature, water temperature, amount of food. Before feeding, make sure the food is at safe temperature to give to your baby. If the food is not warm enough, place the bole back in the warmer for 0.5-1 minutes. c. Heang/defrosng: insert the basket into the steriliser, pour in 160ml of dislled water and then insert the feeding bole and replace the lid.10 Press the „Mode” buon unl „Milk” lights up and the screen shows the previously set temperature between 35°C and 60°C and the default me of 24 hours. In this mode you can set the temperature between 35°C and 60°C using the corresponding buons. The word „Milk” will light up 2 mes, the device will make a sound and start heang. During heang the display shows the current water temperature and the me of 24 hours will be replaced by blinking rectangular lights. The unit will beep 5 mes to indicate when the set temperature has been reached and then when it has been nished. The 24 hours are counted from the me the water is heated to the set temperature. d. Food: use this mode to heat semi-liquid foods and maintain the temperature for up to 2 hours. Insert the basket into the steriliser, pour in 160ml of dislled water and then insert the food bole and replace the lid. Press the „Mode” buon unl „Food” lights up and the screen shows the previously set temperature between 30°C and 80°C and the default me of 2 hours. The machine will beep ve mes to inform you that it is nished. e. Sterilizaon: Use this mode to sterilize boles and teats. Place the basket in the steriliser, pour in 40ml of dislled water and then insert the bole and/or teat and replace the lid. Press the „Mode” buon unl „Steam” lights up and the screen shows a temperature of 100°C. „Steam” will light up 2 mes, the device will emit a sound and will start to heat. The xed me of this funcon is 10 minutes. In this mode, the temperature and me cannot be changed. The device will beep 5 mes to inform you that it is nished. f. Restart default sengs: hold down the „Increase me/temperature” but- ton in the device’s sleep mode to restore the device to factory sengs. ATTENTION: Using water other than dislled water causes scale and sediment accumulaon and shortens the life of the device. The manufac- turer recommends the use of dislled water.

Dear Customer, thank you for purchasing our Neno Luna sterilizer and bole warmer. If you have any problems operang the unit under normal condions, please contact your authorised Neno brand service agent or distributor. Keep your warranty card in case of repair. Product comes with a 24-month warranty. Warranty condions can be found on the website: hps://neno.pl/gwarancja11 Details, contact and service address can be found at: hps://neno.pl/contact/?lang=en Specicaons and contents are subject to change without noce. We apologise for any inconvenience.

4. Reducer d/temperatur

05. WERKING VAN HET APPARAAT