HG05720 - Garden table FLORABEST - Free user manual and instructions

USER MANUAL HG05720 FLORABEST

1 x Foot caps with height adjustment

1 x Tool bar 1 x Assembly and safety instructions Technical data Dimensions: approx. 120‒180 x 89 x 75 cm (L x W x H) Weight: approx. 26.44 kg Maximum load: 50 kg14 GB/IE Safety notices

KEEP THESE INSTRUCTIONS IN

A SAFE PLACE! WHEN PASSING

THIS PRODUCT ON TO OTHERS;

INFANTS AND CHILDREN! Never leave children unsupervised with the packaging materials. The packaging material poses a suffocation hazard. We recommend that two persons assemble the product together in order to avoid injuries or damage to people or the product. Please be careful when opening and closing the product in order to prevent injuries and pinching. Check the product for damage or wear before each use. Only use the product in good condition. Do not use the product if damage is visible or suspected. Verify the product is stable be- fore use. Before use, place the product on a level, firm surface, otherwise the product could become unstable and tip to the side and / or fall over. This can lead to injuries or damage. 50 kg Observe the maximum load capacity of 50 kg. If the weight limit is exceeded, this can lead to product damage and / or injuries. Please ensure that persons, es- pecially children, do not stand on the product or pull themselves up on it. The product could fall over. Do not sit or stand on the product. Keep your hands out of the fold- ing mechanism in order to avoid the risk of injury. Ensure that the folding function is correctly locked in place be- fore using the product. Ensure that the product has been fully opened before using it. This product is not a toy and should be used under adult su- pervision. The product is not a climbing frame or a toy! Secure the product in extreme weather, e.g. strong wind. Do not use the product close to a naked flame.15 GB/IE

PROPERTY! We are not liable for accidents that occur as a result of non-observance of the above safety notes or through incorrect handling. Assembly

on a soft, flat surface, with the underside facing upward. Note: Hard surfaces may cause scratching on the table top.

2. Twist the four rods

into the tapped holes

(Fig. B). Note: Please ensure that you screw the rods

tightly into the table top thread

. Please ensure that the end of the rod protrudes through the hole

on the end of each rod (Fig. D).

with the tool sleeve

to the base of each leg

Turn the table carefully over and set it on the legs. Note: The table must be turned over by two people.

. Please follow these steps:

on the under- side of the table top

2. Carefully slide out the lateral ta-

and unlock the plastic wing nut (Fig. H).

located underneath the table frame (Fig. I). Note: If necessary, push the two lateral table panels to the middle panel to get a level surface.

4. Press on the adjustment button

until it audibly engages (Fig. H). Slide the table panels

to- gether. To push the table top back together, follow these steps:

on the under- side of the table top

little apart and turn the central panel

around its own axis so that it slides beneath the table frame (Fig. J).

3. Make sure to lock the plastic

into the middle of the table.

5. Press on the adjustment button