IAN 353143 - Uncategorized ZOOFARI - Free user manual and instructions

USER MANUAL IAN 353143 ZOOFARI

• Supervise your dog while playing in the paddling pool. Do not leave your dog alone with this product.

• Use the product for its intended purpose only.

• Do not overload the product.

• On very hot days, only allow your dog to enter the paddling pool once the water has been heated by the sun. Your dog may other- wise experience a cold shock on jumping into the paddling pool.

• Check with a vet prior to using this product if your dog is sick or has an open wound.

• Do not allow your dog to chew the product.

• Change the water as required for reasons of hygiene.

• Do not tip the article to empty the water. Open the drainage outlet instead. Only resid- ual water should be tipped out.

• There must be no sharp or hard objects such as dog toys in the paddling pool while it is in use.

• Do not make any modifications to the product.

• Use with clean tap water only. Impure water can endanger the health of your dog.

• Setup should always be carried out by an adult.

• Do not set up the product on concrete, asphalt or other hard surfaces.

• The product should be set up on a level area of grass, that is free from stones, sticks, bumps and dips.

• The product should be a suitable safe distance of at least 2m away from buildings, stairs, fences, walls, water, overhanging branches, washing lines, electrical wires, and other obstacles.

• Check the product for damage or wear before each use. Only use the product if it is in per- fect condition! Do not use the product if it is visibly damaged or you suspect it is damaged. Danger for children

• The product is not a toy. Keep away from young children – risk of drown- ing.

• Never leave children unattended with the pack- aging materials. There is a risk of suffocation. GB/IE6 GB/IE Setting up and filling the paddling pool Setup should always be carried out by an adult.

1. Select a suitable area that is clean and level

and has enough room to unpack and unfold the paddling pool. Spread out the product where it is to go. Make sure that it is in perfect condition.

2. Fill the product slowly and do not leave the

product unattended while filling. Emptying and folding up the product

1. Open the drainage outlet and let the water

run out. Note: Please take note of the local pro- visions for specific regulations on dis- posing of water from swimming pools.

2. Let the product dry completely before folding

it up. Repairs WARNING! You should never attempt to repair larg- er damaged areas yourself. Minor damage can be repaired using the repair kit supplied. Empty all of the water before com- mencing any repair work.

1. Clean the damaged area with an alcohol-based

solution. Roughen the area surrounding the tear or hole slightly using fine sandpaper.

2. Now cut a patch that is large enough to cover

the damaged area plus 1.25cm around it on all sides.

3. Apply the glue to the appropriate spot on the

paddling pool as well to on the patch itself. Leave the glue to dry for approx. three minutes.

4. Press the patch down with a soft object. Make

sure to work on an even surface without any creases or folds. Using a rounded object, gently remove any bubbles, moving outwards from the centre.

5. Wait for at least 12 hours after the repair