Syrene SR71_SB01011 - Broom HOOVER - Free user manual and instructions

USER MANUAL Syrene SR71_SB01011 HOOVER

CMY K* Certain models only ** Certain models only, nozzles may vary according to model

• Certain models only ** Certain models only, nozzles may vary according to model

This appliance should only be used for domestic cleaning, as described in this user guide. Please ensure that this guide is fully understood before operating the appliance. Do not leave the appliance plugged in. Always switch off and remove the plug from the socket after use, or before cleaning the appliance or any maintenance task. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. If the power cord is damaged stop using the appliance immediately. To avoid a safety hazard, an authorised HOOVER service engineer must replace the power cord. Keep hands, feet, loose clothing and hair away from rotating brushes. Use only attachments, consumables or spares recommended or supplied by HOOVER. Static electricity: Some carpets can cause a small build up of static electricity. Any static discharge is not hazardous to health. Do not use your appliance out of doors or on any wet surface or for wet pick up. Do not pick up hard or sharp objects, matches, hot ashes, cigarette ends or other similar items. Do not spray with or pick up ammable liquids, cleaning uids, aerosols or their vapours. Do not run over the power cord when using your appliance or remove the plug by pulling on the power cord. Do not continue to use your appliance if it appears faulty. HOOVER service: To ensure the continued safe and efcient operation of this appliance we recommend that any servicing or repairs are only carried out by an authorised HOOVER service engineer. Do not stand on or wrap the cord around arms or legs when using your appliance. Do not use the appliance to clean animals or people. Do not position the appliance above you when cleaning the stairs. The Environment The symbol on this appliance indicates that this appliance may not be treated as household waste. Instead it must be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this appliance, please contact your local city ofce, your household and waste disposal service or the shop where you purchased the appliance. This appliance complies with the European Directives 2014/35/EU, 2014/30/ EU and 2011/65/EU. CANDY HOOVER GROUP s.r.l. Via Privata Eden Fumagalli, 20861 Brugherio (MB) Italy GB2 *Certain Models Only **Nozzle design may vary according to models

Remove all components from the packaging.

• Assemble the cleaner handle and x in position with the supplied screw. [1,2]

• Open the bin door and check if the dust bin is correctly tted.

• Ensure the pre-motor sponge lter is correctly tted. [11]

• Fit the Carpet and Floor Nozzle . [3]

1. Before use undo integrated clip, turn top hook and release power cord. [5]

2. During use as a stick cleaner clip power cord into back of main handle. [6]

After use, unclip power cord from handle and wind it around storage hooks before securing with integrated clip. CONTROLS

1. On/Off switch. Push to switch On. Push again to switch Off. [7]

CLEANER MAINTENANCE IMPORTANT: Switch cleaner Off and remove plug from electricity supply before removing the bin.

EMPTYING THE BAGLESS CASSETTE

a) Lay the cleaner on a at surface, pull back the door release button and remove the transparent door. [8.1] b) Remove the bagless cassette.[8.2] c) Remove the bin cover by rotating the container and bin cover in opposite directions. [9.1] d) Empty the debris from the container into a bin. [9.2] Check if it is necessary to clean the relative lters, as described in the “Maintaining the bagless lters” section. e) To ret the bagless cassette and the lters to the product, simply repeat all steps in reverse. [9.3] NOTE: Hoover recommends to inspect and wash if necessary, the cassette and the lters after each full container, see maintaining lters section.

MAINTAINING THE BAGLESS FILTERS

a) To access the washable HEPA lter, rotate the mesh lter in the opposite direction from the cassette upper closure and remove the mesh. [10.1] b) Gently tap lters to release excess dust. c) Wipe clean the mesh lter and wash thoroughly the HEPA lter from the inside under hand warm water until the water runs clean. [10.2] d) Remove excess water by shaking and leave to dry for 24 hours. Ret lters to the cleaner only when completely dry. [10.3] DO NOT USE HOT WATER OR DETERGENTS. IMPORTANT: Ensure the bagless lters, mesh and HEPA, are tted before use. SPECIALITIES NOZZLES

1. Carpet & Floor nozzle

Press the Floor type selector pedal on the nozzle [4] to select the ideal cleaning mode for the oor type. Hard Floor – Brushes are lowered to protect the oor. Carpet – Brushes are raised for the deepest clean.

2. Parquet nozzle* for wooden and delicate oors.

ACCESSORIES To obtain the best performance and energy efciency #1 it is recommended that the correct nozzles are used for the main cleaning operations. These nozzles are indicated in the diagrams by the letters GP, HF or CA. A nozzle type GP can be used to clean both carpet and hard oor. A nozzle type HF is suitable for use only on hard oor. A nozzle of type CA is suitable for use only on carpet. A . Handle B. Permanent Exhaust Filter C. ON/OFF Button D. Bin Door E. Bin Door Realease Button F. Carpet and Hard Floor Nozzle** (GP) G. Screw H. Carry Handle

I. Rotating Upper Cord Hook

J. Power Cord K. Lower Cord Hook L. Bin Cover M. Filter Mesh N. HEPA Filter O . Dust Bin P. Parquet Nozzle**Certain Models Only ** Certain models only, nozzles may vary according to model FRGB

• Is there a working electricity supply to the product? Check with another electrical product.

• Is the dust bin full? Inspect and empty.

• Is the product inlet blocked? Check by removing the dust bin and checking the dust bin inlet.