Fusion 178167 - Helmet MANHATTAN - Free user manual and instructions

USER MANUAL Fusion 178167 MANHATTAN

A Multifunction - On/Off - Play/Pause - Answer/End Calls - Voice Dial - Redial Last Number - Begin Bluetooth Pairing B Next Track C Previous Track D Volume Up E Volume Down F LEDs (blue and red) G Micro USB port H Built-in microphone J Adjustable headband Not shown: USB type A-to-micro charging cable Range: 10 m Music: up to 10 hours Talk: up to 11 hours Standby: 250 hours

ENGLISH Initial Setup / Built-in Battery Charging Prior to initial use as a wireless headset, the built-in battery needs to be charged. A full charge can take up to 3 hours, but you can listen to music or make phone calls while charging. 1 Use the included USB-to-micro USB cable to connect the headset (G) to a powered computer or other charging device. 2 The red LED (F) lights while charging; the blue LED (F) lights when the charge is complete. Note: The red LED flashes twice to indicate low voltage. Recharge the battery as soon as you can. Bluetooth Pairing & Operation This product utilizes the latest in Bluetooth wireless technology; wireless performance may vary from device to device. If using this product with a Mac or PC, ensure that your Bluetooth driver is up to date. If it isn’t, visit your computer manufacturer’s website for details and updates. 1 Press the Multifunction button (A) for about 7 seconds, until the LEDs (F) alternately flash red and blue. Note: Pressing the Multifunction button for just 3 seconds will put the headset in Standby mode (the blue LED flashes). 2 With the headset LEDs (F) alternately flashing red and blue, activate your device’s Bluetooth function and search for Bluetooth devices. Refer as needed to the manual of your phone, tablet, computer, etc. regarding its Bluetooth operation. 3 Once the device finds “manhattanFUSION” an on-screen prompt will ask if you’re ready for pairing. Click or press OK or Confirm to continue. Note: If the device prompts you to enter a PIN, enter 0000 and click or press Yes or Confirm to continue.

• After a successful connection is made, the blue LED (F) will flash and the headset will beep. If the pairing has failed and the LEDs are still alternately flashing red and blue, the pairing procedure needs to be re-initiated on your source device.

This headset can connect with two types of devices: those using a Hands-Free or Headset Profile (HFP or HSP), such as smartphones; and those using an Advanced Audio Distribution or Audio/Video Remote Control Profile (A2DP or AVRCP), such as laptops.

FCC Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of Federal Communications Com- mission (FCC) Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: reorient or relocate the receiving antenna; increase the separation between the equipment and the receiver; connect the equipment to an outlet on a circuit different from the receiver; or consult the dealer or an experienced radio/TV technician.