IAN 399688 - Inflatable pool Playtive - Free user manual and instructions

USER MANUAL IAN 399688 Playtive

Instructions for use2

• Warning. Recommended for children over 1½ years of age.

• Warning. Suitable for outdoor use only.

• Warning. Only for domestic use. Danger to life!

• Children can drown in very small amounts of water. Empty the pool when not in use. Risk of injury!

• Do not allow your child to use the product un- supervised since children are unable to judge potential dangers. Use only under the direct supervision of an adult.

• Do not place hard objects with sharp edges, e.g. toys, in the pool while it is in use. Do not wear or carry jewellery, watches or keys. Take off your own shoes and your child’s and remove glasses if worn.

• To protect against damage to the product and injuries to people, the product may not be used until it is fully inflated.

• Children may not jump into the pool.

• Speak to your children about how to use the product while playing safely.

• Do not modify the product in any way.

• Use only clean tap water. Contaminated water can endanger the health of users. GB17GB

• Adult assembly required.

• Do not install the paddling pool over con- crete, asphalt or any other hard surface.

• The product should be assembled on a flat lawn without any stones, sticks, bumps or hollows. Please ensure that the product is at an appropriately safe distance of at least two metres away from buildings, steps, fences, walls, waterways, overhanging branches, washing lines, electrical cables, and any other obstacles.

• Check the product for damage or wear before each use. The product may be used only when in good working order and condition!

• Do not use the product if air is leaking. Avoiding material damage!

• All inflatables are susceptible to cold. For this reason never unfold and inflate the product at a temperature lower than 15 °C!

• Warning. Avoid using sunscreen and skin care products containing alcohol. Sunscreen and skin care products containing alcohol can cause the colour coating of this PVC inflatable product to peel. This can lead to stains on your body, your clothing and other objects that are in contact.

• In the event that the air pressure increases in the hot sun, it must be balanced accordingly by letting out air.

• Make sure that the product, especially when inflated, does not come into contact with stones, gravel, or sharp objects and does not rub or scrape against anything as this can cause damage to the plastic foil.

• Use only the correct pump adapters to insert into the safety valves. The valves might other- wise be damaged.

• Do not over-inflate because you then risk tear- ing open the welded seams. Close the valves properly after inflating.

• Avoid contact with sharp-edged, hot, pointed, or dangerous objects. Assembly An adult should always assemble the product. Please follow the individual assembly steps in the order indicated. Selecting the location Choose a suitably flat and clean surface with plenty of space to unpack and unfold the prod- uct. Spread the product out in the place where it will later be used. Check that all individual parts are present and in good order and condition. Inflation Warning!

• Always inflate the air chambers fully!

• Avoid inflating the air chambers too much because there is the risk of over-stretching the welded seams or even tearing them open.

• Use standard commercial foot pumps or double-stroke piston pumps with matching adapter attachments to inflate the product.

• Do not use a compressor or com- pressed air bottles to inflate the product. This can lead to damage to the product.

• Make sure that the chambers are filled with air uniformly.

• Inflate each air chamber until it feels firm to the touch. When you press with your thumb against the air cham- ber it should still give a little.18 GB Inflate the air chambers in the following sequence:

1. Lower air chamber

2. Middle air chamber

3. Upper air chamber

1. Open the valve seal (fig. A).

2. Inflate each air chamber until the product is

3. Close the valve seal and push in the valve by

pressing lightly. Filling the product with water Fill the product slowly and do not leave it unat- tended while filling. Note: Fill the product fully up to the printed marking shown. Disassembly

1. Empty the product.

Note: Please follow the local regulations regarding specific requirements for dis- posing of water from swimming pools.

2. Allow the product to dry completely.

3. To deflate the individual air chambers, pull out

the respective valve and squeeze the valve stem lightly so that the air can escape or insert the deflation tube into the valve to allow the air to escape rapidly. Repairs Minor leaks or holes can be repaired with the repair patch supplied. Important! Do not inflate the product for 20 minutes after repair! Do not use the patch for leaks or holes on the seam.

1. Let the air out of the product completely.

2. Clean the area around the leak thoroughly.

The area must be dry and free from grease.

3. Cut out a piece of the repair material that is

big enough for its edges to overlap the dam- aged area by about 1.3cm.

4. Peel the patch off the paper, place it on the

damaged area and press tight. Storage, cleaning Exchange the water in the product frequently, es- pecially in hot weather and if it is soiled. When not in use, always store the product clean, dry and uninflated at room temperature. The valves should always be closed during storage. Clean the product only with water or soapy water, never with abrasive detergents. When storing for the winter do not put any sharp objects on the product and do not apply talcum powder. Disposal Dispose of the article and the packaging materi- als in accordance with current local regulations. Packaging materials such as foil bags are not suitable to be given to children. Keep the pack- aging materials out of the reach of children. Dispose of the products and the packaging in an environmentally friendly manner. The recycling code is used to identify various materials for recycling. The code consists of the recycling symbol – which is meant to reflect the recycling cycle – and a number which identifies the material.19GB Notes on the guarantee and service handling The product was produced with great care and under continuous quality control. DELTA-SPORT HANDELSKONTOR GmbH gives private end customers a three-year guarantee on this product from the date of purchase (guarantee period) in accordance with the following provisions. The guarantee is only valid for material and manufacturing defects. The guarantee does not cover parts subject to normal wear and tear that are thus considered wear parts (e.g. batteries) or fragile parts such as switches, rechargeable batteries, or parts made of glass. Claims under this guarantee are excluded if the product has been used incorrectly, improperly, or contrary to the intended purpose, or if the provisions in the instructions for use were not observed, unless the end customer proves that a material or manufacturing defect exists that was not caused by one of the aforementioned circumstances. Claims under the guarantee can only be made within the guarantee period by presenting the original sales receipt. Please therefore keep the original sales receipt. The guarantee period is not extended by any repairs carried out under the guarantee, under statutory guarantees, or as a gesture of goodwill. This also applies to replaced and repaired parts. If you wish to make a claim please first contact the service hotline mentioned below or contact us by e-mail. If there is a guarantee case, then the product will be repaired or replaced free of charge to you or the purchase price will be refunded, depending on our choice. Your legal rights, in particular guarantee claims against the respective seller, are not limited by this guarantee. IAN: 399688_2107 Service Great Britain Tel.: [phone] E-Mail: [e-mail]20 IAN 399688_2107