Multipo Plus AMC1000B - Vacuum Cleaner BESTRON - Free user manual and instructions

USER MANUAL Multipo Plus AMC1000B BESTRON

English SAFETY INSTRUCTIONS - General

• Pleasereadtheseinstructionscarefullyandretainthemforreference.

Use solely accessories recommended by the supplier. The use of other accessories may result in damage to the appliance, thereby creating hazards for the user.

• This appliance can be used by children older than 8 years and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, but only if they have been given supervision or instruction concerning use of the appliance in a safe wayandunderstandthehazardsinvolved.Childrenshallnotplaywith withtheappliance.Cleaningandusermaintenanceshallnotbemade by children without supervision.

• Keeptheapplianceandthecableoutofreachofchildrenunder8 years.

• Haveanyrepairscarriedoutsolelybyaqualifiedelectrician.Nevertry to repair the appliance yourself. SAFETY INSTRUCTIONS - Electricity and heat

• Before use please verify that the mains voltage is the same as indicated on the rating plate of the appliance.

Remove the plug from the wall socket by pulling the plug, not the power cord.

• Check the appliance’s power cord regularly to make sure it is not damaged. Do not use the appliance if the power cord is damaged. If the power cable is damaged, it must be replaced by the manufacturer, the after-sales service or a person with a similar qualification, in order to avoid any hazards.

• Whenusinganextensionleadalwaysmakesurethattheentirecable is unwound from the reel.

• Usesolelyapprovedextensionleads.

• Makesurethattheappliance,thepowercordortheplugdonotmake contact with heat sources, such as a hot hob or naked flame.

Make sure that the appliance, the power cord and plug do not make contact with water.Instruction manual

English SAFETY INSTRUCTIONS - During use

Make sure that your hands are dry before touching the appliance, power cord or plug.

• residuesofplaster,cement,stone,soot,andsimilar

• liquids,ormoistdirt. Theseobjectscouldcauseseriousdamagetotheapplianceandthe filter system, and make it unsafe to use.

• Donotusethevacuumcleaneronwetrugsandcarpets.

• Neverinsertobjectsintheair-exhaustvents.

• Make sure that the suction and exhaust openings are open, and that the filter is not blocked. Blockages will cause the appliance to overheat. Switch off the vacuum cleaner immediately! Once you have remedied the problem, wait 20 to 30 minutes to allow the vacuum cleaner to cool down completely. It will then be ready for use again.

• Switchofftheapplianceandremove theplugfromthewallsocket in the event of a malfunction during use, and before emptying the appliance, cleaning the appliance, fitting or removing an accessory, or storing the appliance after use.

• Donotpickuptheapplianceifitfallsintowater.Removetheplug from the wall socket immediately. Do not use the appliance any more.

• Neverimmersetheappliance,thepowercordorthepluginwateror other liquid. After washing the filters make sure they are thoroughly dry before returning them to the appliance.Instruction manual

English OPERATION - General The appliance is intended only for domestic use, not for professional use.

3. Vacuum-cleaner handle

4. On/off switch with

1. Push the hose into the hose connection on the

motorunit(seefigure1).Toremovethehose, push the two buttons and pull it out of the hose connection.

2. The power cord has a yellow (B) and red (A)

mark (see figure 2). Pull out the cord to the yellow mark. Never pull out the power cord beyond the red mark(A).Thiscoulddamagethepowercord.

3. Slide the hose handle into the telescopic tube

(seefigure3Aonthenextpage).

4. Press the button on the telescopic tube and

keep it pressed in; you can then extend or retract the tube to the required length (see figure3B).

5. Press the foot button on the nozzle to set the

combi nozzle for use on hard or soft surfaces, (seefigure3C).Foruseonhardsurfaces,press the foot button on the combi nozzle to extend the brushes. Lift the button for use on soft surfaces.

6. Put the plug in the wall socket, and press the

On/Off switch. To switch off the appliance, press theOn/Offswitchagain(4).

7. The appliance is now ready for use. You can

move the vacuum cleaner while you are cleaning by pulling on the hose grip. You can lift the appliance with the vacuum cleaner’s handle (3).

8. You can adjust the vacuum suction with the

vacuum suction control (see figure (5). It is

English advisable to reduce the vacuum suction when cleaning upholstered furniture and curtains. This will prevent the fabric from being sucked into the nozzle. If so required, you can also reduce the suction quickly by moving the slide on the hose grip.

OPERATION - STORAGE AFTER USE

1. Remove the plug from the wall socket.

2. Presstherewindbuttonandkeepitpressedin;

the power cord will automatically rewind onto the reel. Guide the power cord whilst it rewinds onto the reel, since otherwise the cord could become tangled or the plug could strike the back of the appliance. Take hold of the power cord near the mark, and allow it to gently slide through your fingersbackintotheappliance(seefigure5).

3. An attachment slot for the combi nozzle is fitted

to the back of the vacuum cleaner. This avoids the need to dismantle the vacuum cleanerafteruse;youcanstoretheassembled appliance and retrieve it again quickly when you need it. CLEANING AND MAINTENANCE - Cleaning the housing

1. Remove the plug from the wall socket.

2. Cleantheoutersurfaceofallpartswithadampclothandacleanersuitableforplastics.

3. Over the course of time dust and dirt can accumulate around the wheel axles, thereby preventing the

wheelsfromturningeasily.Consequentlytheyshouldbekeptclean.

1. Remove the plug from the wall socket.

pulling on the receptacle, and hold it above a waste-bin.

7. Fit the dust receptacle onto the appliance, and click it into position.

CLEANING AND MAINTENANCE - Cleaning or replacing the filter For best results clean or replace the filter after every second or third use of the vacuum cleaner, or more frequently if the filter is visibly blocked. Cleanthefilterregularlytoavoidthatthefilterbecomescloggedandtheengineoverheated.

1. Removethewastefromthedustreceptacle(see“Removingwastefromthedustreceptacle”).

2. Takethefilterfromthevacuumcleaner(seefigure6B).

3. Rinse the filter thoroughly in lukewarm water.

4. Allow the filter to dry thoroughly.

8. Rinse the filters and the dust separation system thoroughly in lukewarm water.

9. Allow the filters to dry thoroughly.

10. Mount the holders and filters in the reverse sequence.

• Donotdrythefilterwithahairdryer. CLEANING AND MAINTENANCE - Cleaning or replacing the exhaust filter Replace the exhaust filter at least twice a year, and more frequently if the filter is visibly blocked.

1. Remove the plug from the wall socket.

2. Open the cover of the exhaust filter wheel cap

by turning it to the left. Pull the exhaust filter fromthedevice(seefigure7).

3. Rinse the filter in lukewarm water. Allow it to dry

the cover, and turn right until it clicks into place.Instruction manual

• Whenthisproductreachestheendofitsusefullifedonotdisposeofitbyputtingitinadustbin; hand it in at a collection point for the reuse of electrical and electronic equipment. Please refer to the symbols on the product, the user’s instructions or the packaging.

• Thematerialscanbere-usedasindicated.Yourhelpinthere-use,recyclingorothermeans of making use of old electrical equipment will make an important contribution to the protection of the environment.

• Contactyourmunicipalityfortheaddressoftheappropriatecollectionpointinyourneighbourhood. GUARANTEE TERMS The importer guarantees the appliance against defects caused by manufacturing and/or material faults for 60monthsfromthedateofpurchase,subjecttothefollowingconditions.

1. No charges will be made for labour costs or materials during the warranty period. Any repairs carried out

during the warranty period do not extend the warranty period.

2. The importer automatically becomes the owner of any faulty parts that he replaces or a faulty appliance

(intheeventofreplacementoftheappliance).

3. All claims submitted under warranty must be accompanied by the original bill of sale.

5. The warranty is issued solely to the first purchaser and cannot be transferred.

6. The warranty does not cover damage caused by:

a. Accidents, incorrect use, wear and/or neglect. b. Faulty installation and/or use in a manner contravening the prevailing legal, technical or safety regulations. c. Connectiontoamainsvoltageotherthanthevoltagespecifiedonthetypeplate. d. Unauthorized modifications. e. Repairs carried out by third parties. f. Carelesstransport,i.e.withoutsuitablepackagingmaterialsorprotection.

7. No claims may be made under this warranty for:

a. Losses incurred during transport. b. The removal or changing of the appliance’s serial number.

8. The guarantee does not cover power cords, lamps or glass parts.

9. No claims can be submitted under this warranty for damage other than the repair or replacement of faulty

parts. The importer can never be held responsible for any consequential loss or damage or any other consequences, resulting either directly or indirectly from the appliance supplied by the importer.

10. In case of claims under guarantee you can contact your dealer where the appliance is purchased.

Bestron offers you also the possibility to send the appliance directly to our Service Department. Do not send your appliance without consulting us. The package may be refused and any any costs will be for your account. Please contact the Service Department and they will tell you how to pack and send the appliance.

11. This appliance is not suitable for professional use.

SERVICE If a fault should occur please contact the BESTRON service department: www.bestron.com/serviceInstruction manual

CE DECLARATION OF CONFORMITY

This product conforms to the essential requirements of the following EU safety directives: