K5625 Digital - Watch Calypso - Free user manual and instructions

USER MANUAL K5625 Digital Calypso

+1 MINUTE+1 HOUR SET HOURS

SET 12/24 FORMAT RESET SECONDS

SET SECONDS SET MINUTES

6. HOW TO USE ALARM AND CHIME DISPLAY

NORMAL TIME ALARM ALARM ON ALARM ON/CHIME ON ALARM OFF/CHIME OFF ALARM OFF/CHIME ON HOLD FOR

NORMAL TIME TIMER SET HOURS +1 HOUR SET MINUTES +1 MINUTE SET SECONDS +1 SECOND TIMERSTART By pressing C button to start and stop When timer has expired, the alarm (BI-BI-BI) lasting 10 seconds may be silenced by pressing ant button. SET TIMER Before the setting 10 seconds, there is an alarm (BI) per second. HOLD FOR 2 SECONDS9. HOW TO SET SECOND TIME ZONE EnglishFrançaisDeutschItaliano Español

1) The backlight of the watch employs an electro-luminescent (EL) light, watch tends

to lose illuminating power after very long use.

2) The illumination provided by backlight may be hard to see when viewed under

direct sunlight. SET HOURS 30 MINUTES SET MINUTES HOLD FOR

1) This watch contains precise electronic components. Never attemp to open the

case or remove the back cover.

2) Do not operate push buttons below the surface of the water when swimming or

3) Should water or condensation appear in the watch, immediately have the watch

checked. Water can corrode electronic parts inside the case.

4) Avoid severing impact: The watch is designed to with stand impact under normal

use. It is inadvisable to subject it to severe impact of rough usage or drops onto hard surfaces.

5) Avoid exposing the watch to temperature extremes.

6) Clean the watch with a soft cloth and clean water only. Avoid using chemicals,

7) Keep your watch away from the conditions of strong electric field and estatic

1) Standard display mode: Hour, minutes, seconds, month, day of week.

• Month, date AM/PM and Electro-Luminiscent light.

• Alarm function with buzzer signal output.

• Chronograph function with lap operation.

3) Accuracy at normal temperature (25ºC): 30 seconds a month.

4) Normal operating temperature range: 10ºC - 40ºCBy virtue of the regulations pursuant to the handling of waste products deriving from electronic and electrical equipment, end of lifecycle watch making products must be selectively collected for processing. You may therefore dispose of your quartz watch making products at any of our retail outlets or any other authorized collection point. The selective collection, processing, rating and recycling of these products helps contribute to safeguarding the environment and protecting our health. EnglishFrançaisDeutschItaliano Español

ADJUSTMENT, MARCHE / ARRETÊR