OHO 162 M - Basket OK - Free user manual and instructions

Technical Specifications	Model: OK OHO 162 M
Type of Hood	Wall-mounted hood
Airflow	Up to 600 m8/h
Speed Levels	3 speed levels
Lighting	Integrated LED lighting
Filter	Aluminum grease filter, washable
Dimensions	Width: 60 cm
Installation	Wall installation
Energy Consumption	Energy class: C
Usage	Designed to eliminate kitchen odors and smoke
Maintenance	Regular cleaning of the grease filter recommended
Safety	Overheat protection
General Information	Ideal for medium-sized kitchens

Frequently Asked Questions - OHO 162 M OK

How do I clean the filters of the OK OHO 162 M hood?

To clean the filters, carefully remove them from the hood and soak them in warm soapy water for about 30 minutes. Then rinse with clear water and let them dry before putting them back in place.

What is the maximum suction power of the OK OHO 162 M hood?

The maximum suction power of the OK OHO 162 M hood is 600 m8/h.

How do I install the OK OHO 162 M hood?

To install the hood, follow the instructions provided in the user manual. Make sure to mount it at least 65 cm above the stove and connect the power supply correctly.

What should I do if the hood does not turn on?

First, check that the hood is properly plugged in and that the switch is in the "on" position. If it still does not turn on, check the fuse or circuit breaker of your electrical installation.

The lights on my OK OHO 162 M hood are not working, what should I do?

If the lights are not working, check if the bulbs are burnt out. Replace them with compatible bulbs. If the problem persists, contact customer service.

What is the size of the OK OHO 162 M hood?

The OK OHO 162 M hood has a width of 60 cm.

The hood is making an unusual noise, what should I do?

If the hood is making unusual noises, check if the filters are properly in place and clean them if necessary. If the noise persists, there may be a problem with the motor or fan, and it is advisable to contact a technician.

How can I adjust the ventilation speed on the OK OHO 162 M hood?

The OK OHO 162 M hood has several speed levels. Use the control panel to select the desired speed according to your suction needs.

Where can I find spare parts for the OK OHO 162 M hood?

You can find spare parts for the OK OHO 162 M hood on the manufacturers website or from authorized dealers. Make sure to check the compatibility of the parts.

Does the hood need to be installed with an exhaust duct?

It is recommended to install the hood with an exhaust duct for optimal efficiency. However, you can also use a recirculation mode with charcoal filters if exhaust is not possible.

USER MANUAL OHO 162 M OK

Thanks for your purchase of an ok. product. Please read this manual carefully and keep it for future reference.

IMPORTANT SAFETY INSTRUCTIONS . READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.

1. This product can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved.
2. Children shall not play with the product.
3. Cleaning and user maintenance shall not be made by children unless they are supervised.
4. The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.
5. The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood shall be at least 65~cm
6. CAUTION: Accessible parts may become hot when used with cooking appliances.
7. A damaged power cord may only be replaced by the authorised service agent in order to avoid hazards.

8. Follow the instructions in the chapter Cleaning and care.

9. Read this user manual thoroughly before first use and pass it on with the product. Pay attention to the warnings on the product and in this user manual. It contains important information for your safety as well as for the use and maintenance of the equipment.

10. Use the product only for its intended purpose and with recommended accessories and components. Improper use or wrong operation may lead to hazards.
11. Take care when the cooker hood is operating simultaneously with an open fireplace or burner that depends on the environment and is supplied by other means than electrical energy, as the cooker hood removes the air from the environment which a burner or fireplace needs for combustion. The negative pressure in the environment must not exceed 4 Pa (4x10-5 bar). Provide adequate ventilation of the room when the cooker hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
12. There is a fire risk if cleaning is not carried out in accordance with the instructions.
13. Do not put any flame under the range hood.
14. CAUTION: Accessible parts may become hot when used with cooking appliances.
15. Regulations concerning the discharge of air have to be fulfilled.
16. The means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
17. Ensure the possibility of disconnecting the product from the supply after installation by having the plug accessible, unless the appliance incorporates an adequate switch complying with wiring rules.
18. This product is only intended for extracting cooking fumes. Only use according to these instructions in order to avoid hazardous situations.

19. Never leave the product unsupervised while it is switched on.

20. Never immerse electrical parts of the product in water during cleaning or operation. Never hold the product under running water.

21. Do not under any circumstances attempt (e.g. damage in power cord, product is dropped, etc.) to repair the product yourself. For servicing and repairs, please consult an authorised service agent.
22. The mains voltage must match the information on the rating label of the product.
23. Use this product in dry indoor areas only and never outdoors.
24. This product is not intended for commercial use. It is designed for household use only.

INTENDED USE

This product is only suitable for indoor use in dry areas. The extractor hood can be used both in extraction mode and convection mode. Any other use is improper and can lead to injuries and results in exclusion of liability for the manufacturer. This product is not for commercial use. It is only designed for household use.

COMPONENTS

A. Power cable with power plug
B. Vent hole, horizontal (not shown)
C. Vent hole, vertical
D. Lamp
E. Filter cover
F. Fan speed setting 0 (off)/1/2/3
G. Light on/off
H. Air outlet, convection mode
I. Outer casing

1 Position of the mounting elements (not shown)

EN

10

BEFORE FIRST TIME USE

• Remove the product and accessories carefully from the original packaging. It is recommended to keep the original packaging for storage. If you wish to dispose of the original packaging, please observe applicable legal provisions. Should you have any questions regarding proper disposal, contact your local waste management center.
• Inspect the delivery contents for completeness and damages. Should the delivery contents be incomplete or damaged, contact your sales outlet immediately.
  After unpacking, please refer to chapter Cleaning and care.

OPERATION

Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards

The extractor hood must be fitted at a minimum distance of 65~cm above the cooking surface. The extractor hood can be screwed on at the back or on the top.

Note: If the extractor hood is used in extraction mode, one of the covers for the air canals must be removed using a suitable tool (levered out). Remove the protective foil before mounting.

2a If extraction is upwards, remove the cover from the vent hole for vertical extraction. Then insert the flange provided into the opening.
2b If extraction is towards the back, remove the cover from the vent hole for horizontal extraction. Then insert the right-angled flange provided into the opening.

Mounting from the back

3 Drill holes of 0.8mm into the wall on which the extractor hood is to be mounted.

Use that expansion plugs provided.

One person should hold the extractor hood during fitting while the other person screws the extractor hood in place.

Screw the extractor hood in place using 2 of the screws provided.

Mounting from the top

4 Please observe the installation dimensions. Drill 4 holes of 06mm into the underside of the hanging unit. Attach the air vent to the extractor hood and secure this to the underside of the hanging unit with the provided screws (x4), nut (x4) and shim (x8).

Adjust steam extraction

Press the bars on both sides inwards and fold the air inlet down.
The adjustment flaps are on the left next to the light.
If the extractor hood is operated using a vent, push the flap upwards. If no vent is available, the extractor hood can be operated in convection mode. Pull the flap downwards.

OPERATION

8 Select the desired fan speed setting.

Fan switch Setting
0 Off
1 Low
2 Medium
3 High

9 You turn the light on (1) and off (0) using the light switch.

Tips for Use

It is recommended that the extractor hood be turned on before the cook process begins.
It is recommended that the extractor hood be left on for up to 15 minutes after the cook process has ended, in order to fully remove vapours and odours.
- Flawless functioning of the extractor hood is dependent on regular maintenance and care, especially the active charcoal filter.
- The fat filter catches fat particle in the air, which clog up the filter sooner or later, depending on how frequently the extractor hood is used.
- In order to minimize the danger of ignition, the filters must be cleaned at least every two months as follows.

CLEANING AND CARE

• Warning! Do not under any circumstances use solvents or abrasive cleaners, hard brushes, metallic or sharp objects for cleaning. Solvents are damaging to health and damage the plastic parts; abrasive cleaners and accessories scratch the surface.
• Do not use a steam cleaner to clean!

10 Turn off the device. Clean the outer casing with a damp cloth. Take care to ensure that no moisture gets into the device (e.g. at the air vent).

Note: In the case of heavy soiling (oil, fat), you can also use a degreasing cleaner for cleaning.

Cleaning and Changing the Filter

Take the filter out and put it into hot water (40-50 degree) for three minutes with a fat-dissolving washing-up liquid. Brush it off carefully with a soft brush. Apply as little pressure as possible, so as not to damage it. Rinse carefully with warm water and allow to dry.

Note: Do not use any abrasive cleaners, as they can damage the extractor hood.

• The aluminium filters may change colour over the course of several cleaning processes. This is not a reason for complaint. They must be changed every four months.
• The effectiveness of the active charcoal filter depends on how frequently hood is used, the type of foods prepared and how regularly the fat filter is cleaned.

CHANGING THE BULB

WARNING! Before replacing the bulb, ensure that the product is turned off, in order to avoid a possible electrical shock.

R2ess the bars on both sides inwards and fold the air inlet down. Unscrew the defective light bulb. When screwing in the bulb type E14 28 W, do not touch the glass part of the bulb with your fingers. Remove any residues from the glass with a clean, soft cloth.

ENERGY SAVING

In order to reduce total environmental impact (e.g. energy use) of the cooking process, please be sure your product is installed according to the user manual, keep the operation place ventilated.

TECHNICAL DATA

Rated voltage 220 - 240 V~	50 Hz
Rated power input 103 W
Filter type/ dimension 45 x	27.5 x 0.5 cm
Bulb E14 28 W
Protection class II

This is a Cookerhood.
The Erp test method is according to (EU) 65/2014, (EU) 66/2014
- Please refer to below website for detail technical information, or contact the manufacturer for technical document: www.ok-online.com

DISPOSAL

Do not dispose of this product as municipal waste. Return it to a designated collection point for the recycling of electrical and electronic equipment. Contact your retailer or local authorities for more information.

TOUTES NOS FÉLICITATIONS

Energy consumption per year (AEGod): 63.3 kWh/a
- Zeitveränderungsfaktor (f): 1.8
The Fluid Dynamic Efficiency (FDEoc): 5.9
The Fluid Dynamic Efficiency class: F
Energy Efficiency Index (EEod): 95.0
Energy efficiency class: D
8P:80.5m/h
RE:173Pa
Q_X:168.6m^3/h (120.8 m³/h at lowest setting, 162.4 m³/h at highest setting)
AEP:65.3W
W28W
Eddie: 85 lux
The Lighting Efficiency (LEbod): 3.0 lux/Watt
The Lighting Efficiency Class: G
The Grease Filtering Efficiency (GFEod): 78.0%
The Grease Filtering Efficiency class: C
The power consumption in off mode (P): 0 Watt
Sound power level (wA): 69 dB