Mars 20020262 - Heating Sonnenkönig - Free user manual and instructions

USER MANUAL Mars 20020262 Sonnenkönig

Please read before first commissioning the safety instructions carefully and observe the safety in- structions to prevent damage due to misuse, improper operation, and improper environmental condi- tions to be avoided. Keep these for later reference. Check the device after removing the packaging for damage . Do not put the unit in case of suspected corruption in operation and consult a specialist. The recyclable packaging material must not be stored or disposed accessible for young children , but must be disposed of properly. This appliance is only for the purpose for which it was explicitly developed. Any other use is regarded as improper and therefore dangerous . The supplier is not liable for damage to persons and / or prop- erty damage due to an improper or incorrect use. This appliance can be used by children aged from 8 years and above and persons with reduced physi- cal, sensory or mental capabilities or lack of experience and knowledge if they have been given su- pervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Please make sure to place the device on a suitable and waterproof surfaces, so that spilled liquids can not cause harm. Repairs to electrical appliances must only be carried out by trained personnel only . Improperly per- formed repairs and alterations to the equipment can have dangerous consequences for the user ac- cording to what the warranty will be rejected. Observing the following procedures will reduce the risk of fire, electric shock, injury to persons and keep installation time to a minimums. Save these instructions for future used.

1. Read all instruction before using this heater.

2. Remove the unit from it’s packaging and check to make sure it is in good condition before using.

3. Do not let children play with parts of package (such as plastic bags).

4. Check the household voltage to ensure it matches the heater’s rated specification.

5. Check the power cord and plug carefully before used, to make sure that they are not damaged.

6. Before unplugging the power cord, be sure to turn off the power, when energizing the unit, be sure

your hands are dry to prevent from electric shock.

7. Do not use flammable objects near or point the heater like furniture, pillows. bedding, paper,

clothes and curtains at least 3 feet (1meter) from the front of the heater and keep them always the sides and rear.

8. Do not place or install near water (bathtub, pool, etc.).

9. To protect against electric shock, do not immerse cord or plug in water or any other liquid.

10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening , as this may

cause an electric shock, fire or damage to the heater.

11. Always unplug the heater when not in use.

12. Do not allow cord to overhang the counter top where it can be easily pulled by children.

13. Do not put fingers or foreign objects into the grill while in operation.

14. Do not leave the appliance unattended when in use.

15. Do not use the radiant heater near water sources. Do not place the device near a bathtub or other

water containers. EN40

2. Content of packing

16. No liability can be accepted for any damage caused by non compliance with these instructions or

any other improper use or mishandling.

17. This appliance is not intended for use by persons (including children) with reduces physical,

sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children and vulnerable people should be supervised to ensure they do not play with the appliance.

18. If the supply cord is damaged in any way, it must be replaced by the manufacturer or its service

agent or a similarly qualifi ed person in order to avoid a hazard.

19. To prevent overheating of this appliance, keep the air inlets and outlets clean and free of any-

thing that may cause blockage. Check all inlets and outlets from time to time to ensure it is clear of any dirt or dust accumulation. DO NOT COVER.

20. Parts of the heater may exceed 200°C, contact with the heating tube, refl ector, or mental parts

near the heating tube, may cause severe BURNS . To avoid burns, do not let bare skin touch hot surface.

21. NEVER place hands under the heating elements. ALWAYS allow heating element to cool at least

10 minutes before touching the heating tube or adjacent parts.

22. This product contains recyclable materials. Do not dispose this product as unsorted municipal

waste. Please contact your local municipality for the nearest collection point.

23. The heat-related vapors generated during operation may pose a risk to animals with a particu-

larly sensitive respiratory system, such as birds. Bird owners are advised to keep the animals away from the unit. Heater Wall fi xing accessory (4X) Knurled screw (2x) Remote controlScrew (4x) EN40 41

A wall mounting bracket is provide with the heater which has been specifically designed to allow this product to be fitted to a wall or ceiling before drilling the holders for the wall/ ceiling is solid and that there are no hidden water pipes or electric wires. The heater must be installed no less than 16’’ (41 cm) from side walls and no less than 6” (16 cm) off the floor. Important: Ensure that the supply cables is well mounted and that it does not come into contact with reflector of the heater or that does not trail into heated area, the supply cable can be fixed to the metal mounting bracket behind heater with plastic zip ties.

1. This heater should be installed by a competent person, i.e. a qualified electrician.

2. Always disconnected the heater from the electricity supply and allow it to cool before instal-

3. This heater can be mounted in a horizontal or vertical manner.

4. For both wall and ceiling mounting, the lowest part of the heater must be located at or above

a minimum height of 1.8 m from ground level, so that the heater can not be touched when in operation.

5. When mounting horizontally or to a ceiling, do not position the heater at an angle more than

90° and less than 45° as shown in Fig. A and B.

6. The supply cable must be at the lower end of the heater if the heater is installed at an angle

7. Keep the supply cord away from the body of the heater which will get hot during use.

8. Do not install the heater on an inflammable surface.

9. Observe the minimum safe distance between the heater body and the inflammable surfaces

10. The heater should always have a minimum clearance of 0.5 m from a ceiling and adjacent

11. If the heater is to be used outside, a weatherproof outlet is recommended.

12. Before drilling ensure that there are no wires or water pipes in the area where the heater is

13. The heater must be installed on the mounting brackets provided.

14. Fasten the brackets securely to the mounting surface and the backside of the heater using

the nuts and screws supplied.

15. Fasten the heater securely on the brackets using the nuts and bolts supplied.

16. The brackets can be used to adjust the direction of the heater, adjust the heater angle by loos-

ening the two bolts on the wall mounting bracket, tighten the bolts again when the desired angle is reached. EN42 Wall mounted installation

Position the heater so that the cable and connector are under and behind the unit. Both vertical and horizontal installations are possible.42 43 Installation with stand (not included) EN44

During operation and 5 minutes after switching off – VERY HOT SURFACE!!! Remote Control 1 Power button: Turn the heater off . 2 Up button: Increase temperature, timer and level. 3 Down button: Decrease temperature, timer and level. 4 Timer button: To set the timer from T0-T24, which is the number of hours it will run. T0 will display and then adjust to the number of hours you would like to set, using the up and down buttons (2 and 3). 5 Level button: Use to adjust the 2P heat levels (P1-P2). Press the Level button then use the up and down buttons(buttons 2 and 3) to increase or decrease the heating level. Note: All heaters and their remote controls have the same frequency, so it is possible to control several heaters with just one remote. PUSH BUTTON: on the right end of heater, it can be manually operated without remote control. Inserting Batteries Insert 2 AAA/ Alkaline type batteries into your remote control

1. Flip the backside of your remote control and pull out battery cover.

Insert the batteries in accordance with the instructions and polarity the batteries.

2. Change the batteries in the same way depicted above.

1. Replace the old batteries with the same type batteries. Otherwise, your heater may not func-

2. Pull out the batteries in case of long terms of disuse to prevent leakage which may impair your

3. Do not allow water or liquid to get into the remote control.

Caution: When the appliance is not operated for a long period of time, cleaning or maintenance is conducted or when the location of the heater is changed, the heater should be turned to OFF and unplugged from the electrical connection. Periodic inspection and removal of dirt and contaminants will ensure that equipment can be operated safely. EN44 45

1. Check if the power cord is plugged into an electrical outlet, if not, plug in.

2. Check if electricity to the main fuse is working.

3. Check to see it the thermostat knob to the ON position.

4. Check the thermostat setting, the heater may be off because it has reached the desired tem-

6. Cleaning and maintenance

Regular and careful cleaning helps your infrared heater operate efficiently for many trouble free years. To clean your heater follow steps below:

1. Unplug the power cord for your safety before cleaning your appliance.

2. Make sure the heater is cool before continuing.

3. To keep the heater clean, the outer shell maybe cleaned with a soft, damp cloth. You may use

a mild detergent if necessary. After cleaning, dry the unit with a soft cloth (CAUTION: DO NOT let liquids enter the heater).

4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish or rough brushes to clean

the heater. This may cause damage or deterioration to the surface of the heater.

5. DO NOT immerse the heater in water.

6. Wait until the heater is completely dry before use.

Storage: Store the heater in a cool, dry location when not in use to prevent dust and dirt build up. Use packaging carton to store. ATTENTION:

7. Always disconnect the heater from the electricity supply and allow it to cool before attempt-

8. If the heater has collected dust or dirt inside the unit or around the heating element, have to

unit cleaned by a qualified service agent. Do not operate the heater in this condition.

9. The only maintenance required is cleaning of the external surfaces of the heater.

10. Do not touch the heating element with bare fingers, as residue from your hand could affect

the life of the lamp. If it is accidentally touched, remove the finger marks with a soft cloth moistened with mentholated spirit or alcohol.

11. Do not attempt to repair or adjust any electrical or mechanical functions on this heater.

12. The heater contains no user serviceable parts. Should the product suffer damage or break-

down, it must be returned to the manufacturer or its service agent.

13. Damaged supply cords to be replaced by the manufacturer, service agent or similarly quali-

fied person in order to avoid hazard.46

7. Warranty / Disposal / Technical change

Warranty The Products are controlled just before delivery. If despite a lack of your product, try trustfully your seller. Please bring your receipt, as this is to be submitted for each warranty. The guarantee period is 24 months from date of purchase. Disposal The device must be disposed of properly. The device can be distributed free of charge for disposal at each dealer. Technical changes Subject to changes in technology and design. We shall not be liable for technical or editorial changes or omissions in this document. Please save the packaging materials of the unit. CE Declaration of Conformity This device complies with the following standards

LVD EN 60335-1:2012 + AC:2014 + A11:2014 + A13:2017 + A1:2019 + A2:2019 + A14:2019 EN 60335-2-30:2009 + Cor. :2010 + A11:2012 EN 62233:2008 LVD 2014/35/EU EMC 2014/30/EU RoHS 2015/863/EU The heat-related vapors generated during operation may pose a risk to animals with a particularly sensitive respiratory system, such as birds. Bird owners are advised to keep the animals away from the unit. EN46 47

DISPOSAL INSTRUCTIONS FOR THE ELECTRICAL PART OF THE PRODUCT In accordance with Article 26 of the Decree-Law of 14 March 2014 implementing Directive 2012/19/ EC, and the Law of 31 March 2015 implementing Directive 2015/863/EU on the reduction of the use of hazardous substances in electrical and electronic equipment and on waste management. The crossed-out dustbin symbol on the machine or packaging indicates that the waste generated at the end of its useful life must be collected separately from other waste. The user must there- fore take the device to the appropriate collection points at the end of its service life. Sort elect- ronic and electrical waste or send back to the retailer when purchasing new, equivalent devices in a one-to-one process. Appropriate separate collection for subsequent commissioning of the equipment to be recycled, treatment and environmentally sound disposal helps to avoid possible adverse effects on the environment and health, and promote the reuse and/or recycling of the materials to which they belong. Misuse of this product by the user will result in the application of the administrative penalties provided for in the applicable legislation. Batteries contained in the device must be disposed of separately in the appropriate containers for the collection of used batteries.

DISPOSAL OF BATTERIES AND ACCUMULATORS

In accordance with Legislative Decree 188 of 20 November 2008 implementing Directive 2006/66/ EC on batteries, accumulators and related waste, the symbol of the crossed-out waste bin on the battery indicates that the disposal of used batteries is prohibited in household waste. Single-use and rechargeable batteries contain substances that are highly polluting for the environment. The user is obliged to dispose of used batteries at collection points in the municipality or in appropriate containers. This service is free. In this way, legal requi- rements are adhered to and the environment protected. The symbols identifying hazar- dous materials that may be present in single-use and rechargeable batteries are as follows: Hg = Mercury, Cd = Cadmium, Pb = Lead.Company Sonnenkönig of Switzerland Olensbachstrasse 9-15 CH-9631 Ulisbach Tel. Int. +41 58 611 60 00 Tel. Nat. 0848870850 www.sonnenkoenig.ch Company Sonnenkönig of Switzerland Peter-Henlein-Strasse 5 D-89331 Burgau Tel: 0180 500 64 35 info@sonnenkoenig.ch www.sonnenkoenig.ch