24.306.2 - Blower Kärcher - Free user manual and instructions

USER MANUAL 24.306.2 Kärcher

Read the instruction manual carefully before use. It contains important safety warnings/instructions that you must obey.

Keep bystanders, especially children but also pets, at a distance and keep distance to everything and everyone.

Attention: gravel and stones etc., may splash up.

Do not use in the rain or expose to moisture.

Always wear hear and eye protection28 Thank you! Thank you very much for choosing for a EUROM product. You have made a good choice! We hope you will be satisfied about its functioning. To get maximum profit from your product, it is important to read this manual attentive and totally before use, and to understand what is written. Read especially the safety instructions: they are there to protect you and your environment. Keep the manual in a safe place for future reference. Store also the package: that is the best protection for your heater in times of no-use. And if you at any time pass the appliance on, pass on the manual and package too. We wish you many hours of problem-free user pleasure! Technical specification Type

Blowing capacity km/h I:150 II:210 Noise level

Charging time battery uur 1-4 Weight

Warnings general Read all instructions. Failure to follow these instructions may result in electric shock, fire and / or serious personal injury. Keep all safety instructions and other instructions for future use. This device may not be used by individuals who are not familiar with its operation and who have not read the instruction manual. The user is responsible for any accidents that occur with other individuals or objects! Not following the safety instructions can cause damage, fire or personal injury. They will void the warranty and the supplier, importer or manufacturer will not accept any responsibility for the consequences! Warnings working environment A messy and dark work area is an open invitation for accidents. The work area should be clean and well lit, and tidy and free of surplus objects and rubbish. Be extra careful if the ground is slippery due to dampness, grease, sand, gravel or other materials.29

Do not use the device indoors and in an area where a danger of fire or explosion exists due to the use or storage of flammable or light inflammable liquids and gases such as paint, lacquer, petrol and so forth. Neither use the device in a dusty environment. Electronic tools can cause sparks that can ignite dust and vapours. Keep children and spectators away when you use the device. Pay attention to the direction of the airflow, it may move objects that can cause personal injury and/or property damage. Check the area where the work will be carried out for wires and other refuse that may cause damage to the device or injury. If necessary, use a rake or broom first to remove undesirable objects before you begin blowing. Warnings Electricity The electrical voltage and frequency, as indicated on the battery charger, must agree with the power socket to be used. The electrical installation must be secured with an earth leakage switch (max. 30 mA). Use only a suitable socket. Do not expose the device to humidity or rain and do not use it under humid or wet circumstances. Keep the electrical cable away from heat, oil, sharp corners and moving parts. Warnings for personal safety Use your common sense and always pay close attention to what you are doing during your activities. Never use the device when you are tired, using medication that causes drowsiness or if you have used alcohol or drugs. Take regular breaks. Stand firmly in balance, do not reach too far and always wear strong closes shoes with a good tread profile, long trousers and gloves. Do not wear any loose hanging clothing of jewellery that might be vacuumed into the air inlet. Tie back long hair and keep it away from the air inlet. During use wear protective dust goggles. In order to prevent irritation from dust, it is advisable to wear a dust mask, certainly when dust can potentially be released from concrete, MDF, fibre plates and so forth! Ear protection is30 recommended for long-term use. If you are working in an area where there is a possibility of being struck by falling objects, wear a helmet. Keep your hands and the rest of your body away from the inlets and outlets of the leaf-blower. Prevent the unintentional starting of the device. Check if the device is switched off before you place the battery in the device. Always remove the plug from the socket (battery charger) and the battery from the device if you do not use it. Never put your hand or any other object into the rotating parts of the machine, which produce suction force. Warnings for use and care This device is designed solely to blow and vacuum dead leaves and intended for use by private individuals only. It should not be used for commercial purposes. Use the device for the purpose for which it is designed only and in the manner described in this instruction manual. Do not overload the device and do not use it for long consecutive periods, as this will reduce its useful life. Before using your device (including battery and battery charge), check for visible damage and / or strange noise. Never use a damaged device and return it to your supplier for replacement. Always check the device for damage or wear and tear before using. Also check whether the electrical cable and extension cord has the correct insulation, any cuts or worn areas and the condition of the connectors. Do not use the device if you notice any damage/wear and tear/deficiencies to the device, electrical cable or plug, or when it works poorly, has fallen or shows any other signs of malfunction. Return the entire device to your supplier or an approved electrician to be checked and repaired. Always ask for original parts. Never use the device when protective parts, switches or safety provisions are broken, not correctly attached or missing. Do not use the device if it is not completely assembled. Immediately switch off the device when it starts vibrating abnormally. Abnormal vibrations point to mechanical problems that may cause bodily harm and/or property damage.31 Remove the plug from the socket, remove the battery from the device before you clean the device, assemble / disassemble the blowing channel or store the device. Ensure that there is careful supervision when this device is used in the presence of children, incapable individuals or pets. Keep them away from the device! This device is not suitable for use by individuals (including children) with a physical, sensory or mental handicap, or lack of experience and knowledge, irrespective of whether there is supervision or instruction has been given regarding the use of the device by an individual who is responsible for their safety. Measures should be taken to ensure that children do not play with the device. This device may not be used by children. Store the device out of reach of children. Switch off the device and wait for all rotating parts to come to a standstill before you store the device. Do not make any changes or modifications to the device. The device, battery and battery charger (including the electrical cable and plug) may only be opened and repaired by authorized and qualified individuals. Maintain the device properly. Check regularly if the rotating parts did not get blocked and parts were not assembled incorrectly or if there are other factors that may affect the functionality. Additional warnings / instructions for battery-operated devices These instructions for use contain important safety and user information about the battery and the battery charger. Read all instructions and warnings on the battery, battery charger and in the instruction booklet accurately before you start using the battery and the battery charger. Only use the battery charger that is recommended by the manufacturer. The use of a battery charger that is meant for a different type of battery may result in a fire hazard. Only use a battery that was designed specifically for this device. The use of other battery models may result in bodily harm or fire. If the battery is not being used then keep it away from other metal materials, e.g. paperclips, coins, nails and screws that can32 short-circuit battery connections. The short-circuiting of battery connections may cause burns or fire. Incorrect use may result in liquid leaking from the battery. Avoid all contact with this liquid. In case of unintended contact with this liquid, immediately rinse the skin thoroughly with water. If this liquid gets in your eyes then rinse carefully with water and quickly seek medical assistance. Liquid from the battery may irritate the skin or cause burns. Replace the leaking battery. Never place a cracked or damaged battery in the battery charger. - hazard of electrical shock. Never expose the battery charger to water or another liquid. - hazard of electrical shock or property damage. To make sure that the battery and the battery charger cool off faster after use, they cannot be placed in a warm space or closed cabinets, etc. Do not try to charge batteries other than those that were delivered with the device. - hazard of electrical shock and/or fire. Never place objects on the battery charger and never place the battery charger on a soft or flexible underground. - hazard of overheating. Do not place the battery charger near heat sources. Only use an appropriate socket and do not use the electricity cable to lift etc. the battery charger. To place the socket of the battery charger in the socket, or to remove it, always hold the socket in your hand; never pull the electricity cable. Completely unwind the electricity cable of the battery charger before you place the plug in the socket. Do not lead the cable under the carpet, do not cover it with mats, runners and the like and keep the cable away from the walking route. Make sure that it is not walked on and that no furniture is placed on it. Do not let the cable pass sharp edges and do not wind it up too tightly after use. It is not recommended to use an extension cord because this may cause overheating and fire. If the use of an extension cord is inevitable then make sure that an undamaged, approved extension cord of sufficient power is used.33 If the battery charger or the battery was exposed to hits or bangs or was otherwise damaged then they cannot be used until they were checked and repaired by a recognised electrician. Do not dismantle the battery charger, present it to a recognised electrician or service centre if it needs to be repaired. Messing or incorrect reassembly may lead to the risk of an electrical shock and/or fire. Remove the plug from the socket before you start cleaning the battery charger – hazard of electrical shock. It is not enough to merely remove the battery from the battery charger. Never try to connect two or more battery chargers. Never store the battery charger and never use it in circumstances where the temperature may be higher than 50° C. The battery charger is meant to be fed by a domestic socket of 220-240 Volt / 50 Hz and produce an output voltage of 18 volt. Never try to use the battery charger with different voltages. The battery is not completely charged upon delivery from the factory. The best lifecycle and performances are realised if the battery is charged at an ambient temperature of 18 to 24° C. Avoid charging of the battery at temperatures lower than 10° C or higher than 50° C. This reduces the risk of inferior performances and damage to the battery. Never burn batteries. Nor when they are damaged and can no longer be charged. Batteries may explode when they are burnt. Never try to open the battery. Do not use or charge the battery when the plastic housing is damaged or cracked. Only charge the battery in a properly ventilated area. The battery charger and the battery heat up during the charging. This is absolutely normal. Charge the battery, where possible, at normal ambient temperature. Do not cover the battery charger, risk of overheating. Avoid charging of the battery in direct sunlight or near heat sources.34 Overloading security The overloading security protects the battery against excessive loading. The battery charger switches off automatically when the battery has been charged completely in order to protect the battery against overloading. Deep de-charging protection The battery is secured against too deep de-charging. This prevents the battery from de-charging further when a too low battery tension is reached. Overheating protection The battery has a built-in temperature sensor that stops the charging when the battery overheats. The temperature sensor protects the battery when the device is being used. Otherwise the battery could reach a dangerously high level in case of overloading or long-term use. In case of overheating the battery must first cool off before it can be used again. Depending on the ambient temperature and how the device is being used, it can take up to 30 minutes before the battery has cooled off sufficiently. Overvoltage security The battery is temporarily switched off to prevent damage if the maximum voltage is exceeded. The normal battery function is reset automatically some seconds after this security has been activated. Short-circuiting security The short-circuiting security switches off and immediately interrupts the circuit of the battery when the battery short-circuits. This prevents damage to the battery and/or the device. Other risks Even if the device is being used according to the instructions then it is still impossible to exclude all risk factors. The following potential risks are related to the design and the functionality of the device: - damage to the lungs if a dust mask is not being used; - hearing loss if no hearing protection is being used; - eye damage is safety goggles are not being used; - vibration damage if the device is being used too long or is not being maintained properly. Vibrations - Specified vibration values were measured according to a standard test method and can be used for comparison between devices. - The specified values can also be used for a provisional assessment of the exposure. - Vibration levels may deviate from the specified value, depending on how the device is being used. - Try to reduce the exposure to vibrations by, for instance, wearing gloves and by taking regular breaks.35 Description and assembly

1. Blow channel (2 parts)

Do not use the machine before it is completely assembled, as in the picture above! Assembly of the leaf-blower - Slide both parts of the blowing channel in each other until you hear a click. - Potentially remove the battery from the leaf-blower before you assemble or disassemble the blowing channel and set the on/off switch to off (0). - Press the blowing channel on the leaf-blower until you hear a click and the security button is fully visible in the notch. - To remove the blowing channel again solidly press the security button and simultaneously pull the blowing channel from the leaf-blower. Charging the battery The battery must be charged before the leaf-blower can be used. After you have first charged the battery, use the leaf-blower until the battery has fully been de-charged. Repeat this 4 to 5 times. - Place the battery charger on a solid underground and place the plug in a 220/240 Volt 50 Hz socket. - The red light on the battery charger now lights up. - Slide the battery delivered with the leaf-blower in the battery charger until you hear a click. (the metal plates of the battery charger in the grooves on the battery )36

- One red light on the battery starts lighting up to indicate that the battery is being charged. (potential lights other than the red light on the battery indicate the charging level). The green light also starts lighting on the battery charger to indicate that it is being charged. If no lights appear then the battery has not been placed in the battery charger correctly. - When the battery has been charged in full then the red lights disappear on the battery and the red light of the battery charger also disappears. The green light on the battery charger remains constantly on. The battery has now been charged in full. - Remove the plug of the battery charger from the socket. - Press the security button on the battery and slide the battery from the battery charger. The battery can now be placed in the leaf-blower. To check the charging level of the battery, press the button on the battery (on the short side of the battery, alongside the red lights).

Placing the battery in the leaf-blower - Check if the on/off switch is set to off (0) before you place a battery in the leaf-blower. - Slide the battery delivered with the leaf-blower in the leaf-blower until you hear a click. Do not force it to prevent damage to the battery and/or leaf-blower. Removing the battery from the leaf-blower - Press the security button on the batter and slide the battery from the battery charger.37

Use of the leaf-blower - Read and understand all the warnings before you start using the leaf-blower. - Hold the leaf-blower firmly and slide the on/off switch forward. Select the ventilator speed, mode I or II. - Direct the airflow downwards and slowly walk forwards. Move the blowing channel back and forth with the blowing opening 5-10 cm above the ground. - Switch off the leaf-blower by again turning the on/off switch to OFF (0) and wait until all rotating parts have come to a standstill before you store the device.

Cleaning, maintenance and storage - Remove the plug from the socket, remove the battery from the device before you clean the device, assemble / disassemble the blowing channel or store the device. - Check if the switch operates smoothly and is not obstructed by rubbish. - Always keep the air inlet openings of the engine case clean to avoid overheating of the engine. - Never spray or rinse your device clean with water but clean it with a moist cloth. Do not use cleaning agents on plastic parts of the leaf-blower they may damage the material! Let the engine case dry carefully. - Only store the device in a dry, frost-free space out of reach of children.38

Leaf blower Cordless Tension de raccordement