BAB6900E Professional Hard Hat - Hair Dryers BABYLISS - Free user manual and instructions
Find the device manual for free BAB6900E Professional Hard Hat BABYLISS in PDF.
Frequently Asked Questions - BAB6900E Professional Hard Hat BABYLISS
Download the instructions for your Hair Dryers in PDF format for free! Find your manual BAB6900E Professional Hard Hat - BABYLISS and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. BAB6900E Professional Hard Hat by BABYLISS.
USER MANUAL BAB6900E Professional Hard Hat BABYLISS
BAB6900E This very compact table dryer is perfect for hairstylists who want to offer their services at home. Easy to carry and foldable, thus easy to store, the hood is very large for comfort, even with large rollers. the airflow is adjustable. as soon as the hair is styled, it only takes a few seconds to fold the dryer and store it away after it has cooled down. HIGH PERFORMANCE & IONIC TECHNOLOGY Hair is naturally positively charged; this positive charge is increased during drying and generates static electricity that causes the scales of the hair to move away from each other. The surface of your hair thus becomes rough and takes on a lifeless appearance. The negative ions generated by the hairdryer will neutralise the positive charge and in this way remove any static electricity in the hair. The hair cuti- cles thus properly closed, the hair is shiny, easy to style. It has also been proven that ionic technology acts as a catalyst for hair products.
OPENING AND ADJUSTMENT
Place the hood dryer on a table before opening it. Facing the front of the dryer, release the front hood latch (1) by bending the latch slightly toward you. Lift the hood and stem up and forward by the handle (2) until the stem is in the maximum forward position. Then tilt the hood back slightly until it snaps into place under the hood lock. Height adjustment: tilt the hood and stem right back and lift the ex- tendable neck (4) to adjust height. Once satisfied that the extend- able neck (4) is the correct height, carefully allow the hood and stem to tilt forward to maintain height adjustment. USE Prepare the hair for drying e.g. in rollers, lightly towel dried, etc. Ensure that the power switch (5) is in «off» position (0) and plug in. Switch to either I (low) or II (high). Use position II for thick or long hair or for starting the drying process, and position I for normal drying or for perfectly safe drying of dam- aged hair or synthetic hair exten- sions. As a general rule, it is recommend- ed to start in position II and end drying in position I. Adjust the vents so that there is more or less air on the top, front or back of the head, as your hairstyle requires. Rotating the handle to left or right ENGLISH7 opens or closes vents (6) that af- fect the distribution of air flow inside the hood.
Turn the switch to «o». Unplug the appliance and store the cord in its compartment in the hood dryer base (7). Being careful to support the hood, push the hood lock downwards to release the hood. Fold the hood. Ensure that it is fully closed (check that it is engaged under the rear latch and that it has fully clicked under the front latch)) before lifting it by the handle. MAINTENANCE To clean the hood dryer, use a damp cloth with mild detergent. Always ensure that the dryer is fully dry before use. IMPORTANT The hairdryer is equipped with a safety thermostat. In case of over- heating, it stops automatically. After a short time, it starts again. However, before continuing, check that the air vents (on the top of the hood and on the base) are clean and unobstructed. Clean out as necessary before continuing. SAFETY INSTRUCTIONS
- WARNING: Polyethylene bags containing this product, or it’s packaging, can be dangerous. To avoid the risk of suffocation, keep these bags out of the reach of ba- bies and children. A polyethylene bag is not a plaything.
- WARNING: do not use this unit over or near water contained in wash basins, bathtubs, showers or any other vessels.
- If the appliance is used in a bath- room, unplug it after use. Using the appliance near a source of water may be dangerous, even if the appliance is unplugged. For greater safety, we recommend using a residual current device (RCD) with a tripping current of not more than 30mA. Ask your electrician for advice.
- Do not immerse the appliance in water or any other liquid.
- Stop using the appliance imme- diately if the cord is damaged. The cord must be replaced by the manufacturer, its after sales serv- ice or a similarly qualified person to avoid risk of injury to the user.
- Do not leave the appliance unat- tended while it is plugged in or in use.
- Avoid contact with the appliance’s hot surfaces, in particular, with ears, eyes, face and neck.
- This product is not de- signed to be used by people (including children) with reduced physical, mental, or sensory capacity, nor by those with no prevoius knowledge, or experience in using it, unless un- der the supervision of somebody8 responsible for their security, or with previous instruction in it’s u s e . Adults are advised to ensure that children do not play with this prod- uct.
- Allow the appliance to cool before storing.
- After use, do not wind the cord around the appliance as this may damage it. Instead, roll the cord up loosely and let it hang by the side of the appliance.
- This appliance meets the require- ments of Directives 04/108/EEC (electromagnetic compatibility) and 06/95/EEC (safety of domestic electrical appliances), as amended by Directive 93/68/EEC (CE mark- ing).
In everyone’s interest and to active- ly participate in the collective effort to protect the environment:
- Do not discard your products with household waste.
ManualGo.com