1945056 - Blender RUSSELL HOBBS - Free user manual and instructions

USER MANUAL 1945056 RUSSELL HOBBS

C BEHANDLING OG VEDLIKEHOLD

рецепти има на нашата уеб страница: http://www.russellhobbs.com/ifu/55093166 Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all packaging before use.

A IMPORTANT SAFEGUARDS

Follow basic safety precautions, including: 1 This appliance must only be used by or under the supervision of a responsible adult. Use and store the appliance out of reach of children. 2 Don’t put the appliance in liquid, don’t use it in a bathroom, near water, or outdoors. 3 Unplug before dismantling or cleaning. 4 Switch off (0) before fitting the jug to the motor unit. 5 Switch off (0), and wait till the blades come to a stop before removing the lid from the jug, or removing the jug from the motor unit. 6 Don’t fill with anything hotter than you can comfortably handle (i.e. liquid temperature below 40°C). 7 Don’t put your hand into the jug, even after you’ve removed it from the motor unit – the blades are sharp. 8 Don’t put any other object (spoon, spatula, etc.) into the jug while the blender is plugged in. 9 Don’t leave the appliance unattended while plugged in. 10 Don’t let the jug overflow. If liquid gets under the motor unit, it may be sucked into the motor, damaging it. 11 Don’t use accessories or attachments other than those we supply. 12 Don’t use the appliance for any purpose other than those described in these instructions. 13 Don’t operate the appliance if it’s damaged or malfunctions. 14 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or someone similarly qualified, in order to avoid hazard. household use only C PREPARATION 1 Sit the motor unit on a dry, firm, level surface, near a power socket. 2 Hold the jug above the motor unit, with the handle between the speed control and the u arrow on the motor unit. 3 Lower the jug on to the motor unit, then turn the jug to align the handle with the u arrow on the motor unit. 4 Turn the lid clockwise to unlock it (U), then lift it off the jug. 5 Put the ingredients into the jug. 6 Don’t fill past the 1500ml mark. If you do, the contents may force the lid off when you start the motor.

7 Fit the lid, with the tab in front of the handle. 8 Turn the lid anti-clockwise (L) till the latch clicks into the safety interlock. 9 Push the cap into the hole in the lid. 10 Don’t run the appliance without fitting the cap.

11 Check that the speed control is set to 0. 12 Put the plug into the power socket.

13 Turn the speed control to the speed you want (1 = low, 2 = high). 14 Turn the speed control back to 0 to turn the motor off.67 15 Generally, large quantities, thick mixes, and a high ratio of solids to liquids suggest longer timings and slower speeds. 16 Smaller quantities, thinner mixes, and more liquids than solids suggest shorter timings and higher speeds. 17 Don’t run the motor for more than 1 minute, or it may overheat. After 1 minute, switch off for at least 2 minutes, to let the motor cool. Y PULSE 18 Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In this direction, the knob is spring-loaded. When you let go, it’ll return to 0.

C ADDING INGREDIENTS

19 To add ingredients while the blender is working, remove the cap, pour the new ingredients through the hole, then replace the cap. 20 Check that the added ingredients don’t push the volume in the jug past the 1500ml mark. C FINISHED? 21 Switch off (0), and wait till the blades come to a stop before removing the lid from the jug, or removing the jug from the motor unit.

C CARE AND MAINTENANCE

22 Switch the appliance off () and unplug it. 23 Wipe the outside of the motor unit with a clean damp cloth. 24 Wash the removable parts in warm soapy water, rinse well, drain, and air dry. 25 Don’t put any part of the appliance in a dishwasher.

26 You may remove the blade unit for cleaning. 27 This is best done with the jug turned upside down. 28 Grip the jug handle with one hand. 29 Grip the bottom of the blade unit with the other hand. 30 Turn the blade unit anti-clockwise till it comes loose from the jug base. 31 Carefully, pull it up and out of the bottom of the jug. 32 Lift the seal away from the blade unit. 33 Wash the seal and blade unit in warm soapy water, rinse, and air dry. 34 Take great care with the blades – don’t handle them directly, use a nylon washing-up brush. 35 Replace the seal round the blade unit. 36 Replace the blade unit in the jug base. 37 Turn the blade unit clockwise to tighten it.

H ENVIRONMENTAL PROTECTION

To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol mustn’t be disposed of with unsorted municipal waste, but recovered, reused, or recycled. instructions diagrams 0 off 1 low 2 high 3 speed control 4 motor unit Y pulse 5 blade unit 6 seal 7 jug 8 safety interlock 9 latch 10 tab 11 lid 12 cap68 recipes h = handful c = clove(s) coriander pesto 2 h coriander leaves 2 c garlic 60 g pine nuts 125 m olive oil 60 g Parmesan, grated Process the coriander, garlic, pine nuts and half the oil till smooth. Transfer to a large bowl. Stir in the Parmesan. Add oil to adjust the consistency: For a dip: thick. For a topping: medium. For pasta sauce: thin. recipes are available on our website: http://www.russellhobbs.com/ifu/55093169 ΍ϊϓέΏέγΗϟ΍ϊϧΎϣϥϣΕ΍έϔηϟ΍ΓΩΣϭ